12
first drive features
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has
reached 25 mph(40 km/h).
The system will automatically maintain the set speed
until you tap the brake pedal, accelerate, cancel or
turn the system off.
To activate the cruise control, push the ON/OFF
switch
01 . The C r UISE
indicator light in the
instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the desired speed, push the COAS t /
SE
t switch
02 and release. The C r UISE SE t indicator light
in the instrument panel will
illuminate. Take your foot off the accelerator pedal. y our vehicle will maintain the set speed.
To reset at a faster cruising speed, push and hold the ACCEL/ r ES switch
03 . When the
vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAS t /SE t switch
02 . Release the
switch when the vehicle slows to the desired speed.
To cancel the preset speed, tap the brake pedal or push the CANCEL switch
04 .
To turn off cruise control, push the
ON/OFF switch
01 . The C r UISE
indicator light
in the
instrument panel will turn off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
02
0304
USB/iPod® Interface
The USB jack 01 is located in the center console under
the arm rest.
When a compatible USB memory device or iPod®
is plugged into the USB jack, compatible
audio and video files stored on the device
can be played through the vehicle’s audio
system and front display.
For more information, refer to the “Monitor, climate, audio, phone
and voice recognition systems (section 4)” of your Owner’s Manual.
01
1276473_14a_Q60_Convertible_QRG_062113.indd 126/21/13 3:31 PM
14
first drive features
Opening/Closing the Hard Top (Convertible models)
Before opening or closing the retractable hard top, refer to
your Owner’s Manual for detailed warnings and cautions
regarding hard top operation.
t
he trunk area must be absolutely empty or it may result
in damage to the hard top.
Preparing to Lower the
h ard t op
1.
The vehicle must be on a level surface when operating
the hard top.
2.
Make sure that the trunk area is absolutely empty.
3.
Pull up on the strap to open the trunk room partition.
4
.
Secure the partition hooks into holders until they latch.
If the trunk room partition hooks are not latched in the
holders, the hard top cannot be operated and
the C
h EC k SEPA r A t O r indicator will illuminate
on the vehicle information display located
between the tachometer and speedometer.
5.
Securely close the trunk before operating the hard top.
h
ard t op Operation
1.
Move the shift lever to the
P (P A rk) position
(automatic transmission) or move the shift lever to
the N (N
EU tr AL ) position (manual transmission) and
apply the parking brake.
2.
Start the engine.
3.
Press the hard top operating switch, located on the
center console, to OPEN or CLOSE and hold until the
top is fully positioned.
4.
The
r
OOF OPEN or r OOF CLOSED indicator will display when the hard top is fully positioned.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
1276473_14a_Q60_Convertible_QRG_062113.indd 146/21/13 3:31 PM
