6-7
What to do in an emergency
4. Connect  the  jumper  cables  in  the
exact sequence shown in the illus-
tration. First  connect  one  jumper
cable  to  the  red,  positive  (+)
jumper  terminal  of  your  vehicle
(1).
5. Connect  the  other  end  of  the
jumper  cable  to  the  red,  positive
(+)  battery/jumper  terminal  of  the
assisting vehicle (2).
6. Connect  the  second  jumper  cable
to  the  black,  negative  (-)  battery/
chassis  ground  of  the  assisting
vehicle  (3).
7. Connect the other end of the sec-
ond  jumper  cable  to  the  black,
negative  (-)  chassis  ground  of
your vehicle (4).
Do  not  allow  the  jumper  cables  to
contact  anything  except  the  cor-
rect battery or jumper terminals or
the  correct  ground. Do  not  lean
over  the  battery  when  making
connections.
8. Start  the  engine  of  the  assisting
vehicle  and  let  it  run  at  approxi-
mately  2,000  rpm  for  a  few  min-
utes. Then start your vehicle.
If  your  vehicle  will  not  start  after  a
few  attempts,  it  probably  requires
servicing. In  this  event  please  seek
qualified  assistance. If  the  cause  of
your  battery  discharging  is  not
apparent, have your vehicle checked
by an authorized HYUNDAI dealer.
Disconnect  the  jumper  cables  in  the
exact  reverse  order  you  connected
them:
1. Disconnect  the  jumper  cable  from
the  black,  negative  (-)  chassis
ground of your vehicle (4).
2. Disconnect  the  other  end  of  the
jumper  cable  from  the  black,  neg-
ative  (-)  battery/chassis  ground  of
the assisting vehicle (3).
3. Disconnect  the  second  jumper
cable  from  the  red,  positive  (+)
battery/jumper  terminal  of  the
assisting vehicle (2).
4. Disconnect  the  other  end  of  the
jumper cable from the red, positive
(+) jumper terminal of your vehicle
(1).6
1VQA4001