2014 FORD TRANSIT CONNECT air conditioning

[x] Cancel search: air conditioning

Page 171 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual Circuits protected
Fuse Rating
Fuse
Blower motor
40A **
F10
Rear floor console auxiliary power point
20A **
F11
Cargo area auxiliary power point (van only, vehicles
with Start/Stop)
Powertrain control

Page 173 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual Circuits switched
Relay
Not used
R1
Horn
R2
Not used
R3
Not used
R4
Rear window wiper
R5
Not used
R6
Heated windshield
R7
Accessory delay
R8
Not used
R9
Starter motor
R10
Air conditioning clutch
R11
C

Page 175 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual Circuits protected
Fuse Rating
Fuse
Overhead console switch bank
Not used
-
F61
Autowipers
5A
F62
Auto-dimming interior mirror
Not used
-
F63
Not used
-
F64
Liftgate release
10A
F65
Front door double

Page 176 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual Circuits protected
Fuse Rating
Fuse
interior motion sensor
Washer pump (ground fuse)
20A
F82
Central locking (ground fuse)
20A
F83
Double locking (ground fuse)
20A
F84
Ignition switch
7.5A
F85
Airbag

Page 178 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual Circuits protected
Fuse Rating
Fuse
Not used
-
F32
Not used
-
F33
Driver heated seat
15A
F34
Passenger heated seat
15A
F35
Not used
-
F36
Power sunblind
20A
F37
Not used
-
F38
Not used
-
F39
Rear heat

Page 193 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual WARNINGS
Bulbs can become hot, let the bulb
cool down before removing it. Failure
to do so could result in personal
injury. The following instructions describe how to
remove the bulbs. Fit replacement

Page 200 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual 6. Install the air filter housing cover.
7. Install the retaining screws to secure
the air filter housing cover to the air
filter housing.
2.5L Engine 1.
Release the clamps that secure the air
filter

Page 202 of 411

FORD TRANSIT CONNECT 2014 2.G Owners Manual Specification
Name
-
Penetrating and Lock Lubricant
XL-1
If you use oil and fluids that do not meet
the defined specification and viscosity
grade, this may lead to:
• Component damage which is not
c
Page:   < prev 1-8 9-16 17-24 next >