2014 FORD MUSTANG fuel

Engine Information
Item Description
ConfigurationLongitudinally mounted, 90-degree
V8, cast aluminum cylinder block
and cylinder heads
Bore x Stroke3.681 x 4.165 inch
(93.5 x 105.8 mm)
Displacement5810 cc (355 cid)
Compression ratio9.0:1
Horsepower on 93 octane fuel662 horsepower @ 6500 rpm
Torque on 93 octane fuel631 lb-ft torque @ 4000 rpm
Redline6250 rpm continuous
7000 rpm temporary over-rev
Specific output114 hp per liter
ValvetrainDual overhead chain-driven cams,
roller finger followers with
hydraulic lash adjustment,
ovate-wire valve springs, four
valves per cylinder
IgnitionHigh energy coil on plug ignition
with Motorcraft® Iridium-Platinum
spark plugs
Fuel system55 lb/hr injectors with twin
high-flow pumps
Mass air sensor105 mm (4.13 in.) circle
Throttle bodyTwin 60 mm (2.36 in.) diameter
bore-simultaneously open
PistonsShallow-dished forged aluminum
CrankshaftForged steel balanced with
tungsten inserts
Connecting rodsForged steel I-beam
SuperchargerEaton TVS 2300
Exhaust manifoldsCast high-silicon, molybdenum iron
Exhaust systemDual stainless steel
Shelby® GT500® Unique Features
8
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

Note:During each shift, the clutch pedal must be fully pressed to the
floor and the accelerator fully released. Failure to follow this may cause
increased shift efforts, prematurely wear transmission components, or
cause gear clash or damage to the transmission. Make sure the floor mat
is properly positioned so it doesn’t interfere with the full extension of the
clutch pedal.
Note:If you attempt to shift when the drive wheels are spinning with a
loss of traction, it is possible to cause damage to the transmission. Do
not attempt to shift when the drive wheels do not have traction.
Do not drive with your foot resting on the clutch pedal or use the clutch
pedal to hold your vehicle at a standstill while waiting on a hill. These
actions will reduce the life of the clutch.
Your vehicle is equipped with a twin disc clutch. Due to the high
performance of the powertrain, a certain amount of noise from the
transmission is normal.
Clutch Protection
Your vehicle is equipped with an electronic powertrain feature to reduce
clutch damage. When excessive clutch slip is detected at a high power
level, the powertrain control module will limit torque to reduce damage
to the clutch. Full power is restored as soon as the clutch is fully
engaged. This feature is calibrated in a way that does not interfere with
normal driving and does not impede maximum acceleration capability.
Recommended Shift Speeds for Maximum Fuel Economy
Upshift according to the following chart:
Upshifts when accelerating
Shift from:
1 - 2 11 mph (18 km/h)
2 - 3 18 mph (29 km/h)
3 - 4 25 mph (40 km/h)
4 - 5 30 mph (48 km/h)
5 - 6 43 mph (69 km/h)
Driving your Shelby® GT500®
13
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

7. Add prediluted coolant to the coolant reservoir until the coolant level
is between the MIN and MAX marks on the reservoir.
8. Reinstall the pressure relief cap.
9. Check the coolant level in the reservoir before you drive your vehicle
the next few times (with the engine cool).
10. If necessary, add prediluted coolant to the coolant reservoir until the
coolant level is between the MIN and MAX marks on the reservoir.
Whenever coolant has been added, the coolant level in the coolant
reservoir should be checked the next few times you drive the vehicle. If
necessary, add prediluted coolant to bring the coolant level to the proper
level.
If you have to add more than 1.0 quart (1.0 liter) of coolant per month,
have your dealer check the cooling system. Your cooling system may
have a leak. Operating an engine with a low level of coolant can result in
engine overheating and possible engine damage.
ENGINE SPARK PLUG INTERVAL
To keep your high performance engine operating at peak performance,
the spark plug service interval is every 45000 miles (72000 kilometers).
See the Motorcraft® Part Numbers chart for the specific spark plug
application.
OCTANE RECOMMENDATIONS
Premium unleaded gasoline with an
(R+M)/2 octane rating of 91 or
higher is required. SVT recommends
using unleaded gasoline with octane
rating of 93 or higher for optimal
performance of this vehicle.
Recommended fuel is an important part of the proper maintenance and
optimal performance of this vehicle. The use of gasoline with an octane
rating lower than 91 can lead to severe mechanical damage to your
vehicle, may degrade vehicle performance, and may affect your warranty
coverage.
91(R+M)/2 METHOD
Maintenance
40
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

MOTORCRAFT PART NUMBERS
Component 5.8L Supercharged V8 engine
Air filter element FA-1896
Fuel filter FG-1083
Battery BXT-96R-590
Oil filter FL-820S
Spark plugs CGSF-12YP
0.033 - 0.037 inches
(0.85 - 0.95 mm)
Capacities and Specifications
42
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

Item CapacityFord part name or
equivalentFord part number /
Ford specification
Fuel tank16.0 gallons
(60.5L)——
Transmission fluid
without cooler
3,4
3.6 quarts (3.4L)
Motorcraft®
MERCON® V ATFXT-5-QM /
MERCON® V
Transmission fluid with
cooler
3,4
4.1 quarts (3.9L)
Windshield washer fluid Fill as requiredMotorcraft® Premium
Windshield Washer
Concentrate (US) /
Premium Quality
Windshield Washer Fluid
(Canada)ZC-32-A (US)
CXC-37-(A, B, D, and F)
(Canada) /
WSB-M8B16–A2 / -
1Add the coolant type originally equipped in your vehicle.2Rear axle lubricants do not need to be checked or changed unless a leak is suspected, service is
required or the axle assembly has been submerged in water. The axle lubricant should be changed
any time the rear axle has been submerged in water. For vehicles with a cooler, the axle pump
must be running to perform the service refill.
Fill 1/4-9/16 inch (6-14 millimeters) below bottom of fill hole.3The TREMEC 6060 6-speed manual transmission on your Shelby GT500 uses MERCON® V
automatic transmission fluid. Make sure that the correct MERCON® V ATF automatic transmission
fluid is used as indicated on the label on your transmission.4Service refill capacity is determined by filling the transmission to the bottom of the filler hole with
the vehicle on a level surface. For vehicles with a transmission cooler, the engine must be running,
the clutch pedal must be released, and the transmission must be in neutral to perform the service
refill.
Capacities and Specifications
44
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

Additional Maintenance Items
Every 15000 miles
(24000 km)Replace cabin air filter (if equipped).
Every 30000 miles
(48000 km)Replace engine air filter.
Replace fuel filter.
Every 45000 miles
(72000 km)Replace spark plugs.
Every 105000 miles
(168000 km)Change engine coolant.
*
Inspect accessory drive belt(s).**
Every 150000 miles
(240000 km)Change manual transmission fluid.
Change rear axle fluid.
Replace accessory drive belt(s) if not replaced
within the last 100000 miles (160000 km).
*Initial replacement at six years or 105000 miles (168000 kilometers),
then every three years or 45000 miles (72000 kilometers).
**If not replaced, inspect every 15000 miles (24000 kilometers).
Scheduled Maintenance Guide
53
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

EXCEPTIONS
There are several exceptions to the Normal Schedule. They are listed
below:
Normal vehicle axle maintenance:Rear axles and power take-off
(PTO) units with synthetic fluid and light-duty trucks equipped with
Ford-design axles are lubricated for life; do not check or change fluid
unless a leak is suspected, service is required or the assembly has been
submerged in water. During long periods of trailer towing with outside
temperatures above 70°F (21°C) and at wide-open throttle for long
periods above 45 mph (72 km/h), non-synthetic rear axle fluids should
be changed every 3000 miles (4800 kilometers) or three months,
whichever comes first. This interval can be waived if the axle is filled
with 75W85 Premium Synthetic Hypoid Gear Lubricant meeting Ford
specification WSS-M2C942–A, part number XY–75W85–QL or equivalent.
Add friction modifier XL-3 (EST-M2C118-A) or equivalent for complete
refill of Traction-Lok rear axles (refer to theCapacities and
Specificationschapter for details).
Police/Taxi/Livery vehicle axle maintenance:Change rear axle fluid
every 100000 miles (160000 km). Rear axle fluid change may be waived
if the axle was filled with 75W140 synthetic gear fluid meeting Ford
specification WSL-M2C192-A, part number FITZ-19580-B or equivalent.
Add four ounces (118 mL) of additive friction modifier XL-3
(EST-M2C118-A) or equivalent for complete refill of Traction-Lok rear
axles. The axle fluid should be changed anytime the axle has been
submerged in water.
California fuel filter replacement:If the vehicle is registered in
California, the California Air Resources Board has determined that the
failure to perform this maintenance item will not nullify the emission
warranty or limit recall liability prior to the completion of the vehicle’s
useful life. Ford Motor Company, however, urges you to have all
recommended maintenance services performed at the specified intervals
and to record all vehicle service.
Hot climate oil change intervals:Vehicles operating in the Middle
East, North Africa, Sub-Saharan Africa or locations with similar climates
using an American Petroleum Institute (API) Certified for Gasoline
Engines (Certification mark) oil of SM or SN quality, the normal oil
change interval is 5000 miles (8000 kilometers).
If the available API SM or SN oils are not available, then the oil change
service interval is 3000 miles (4800 kilometers).
Engine air filter replacement:Engine air filter life is dependent on
exposure to dusty and dirty conditions. Vehicles operated in these
conditions require frequent inspection and replacement of the engine air
filter.
Scheduled Maintenance Guide
60
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)

A
AdvanceTrac ................................16
Air cleaner filter ...................41–42
Axle
refill capacities ..........................43
B
Battery
replacement, specifications .....42
Brakes
fluid, refill capacities ................43
Break-in period ...........................12
C
Capacities for refilling fluids ......43
Clutch
recommended shift speeds ......13
Coolant
refill capacities ..........................43
E
Electric power assisted
steering ........................................22
Electronically selectable
dampers .......................................22
Engine ............................................8
refill capacities ..........................43
service points ............................35
Engine oil
filter, specifications ..................42
refill capacities ..........................43
F
Fluid capacities ...........................43Fuel
capacity .....................................43
filter, specifications ..................42
octane rating .........................8, 40
H
Headlamps
bulb specifications ....................45
I
Ignition ...........................................8
Instrument panel
cluster
........................................14
L
Lamps
bulb replacement
specifications chart
..................45
Launch control
............................20
Lights, warning and indicator
....14
Lug nuts
......................................26
M
Manual transmission
fluid capacities
..........................43
Motorcraft® parts
.......................42
O
Octane rating
..............................40
P
Parts (see Motorcraft® parts)
..42
Index
62
2014 05+ Mustang(197)
Supplement, 1st Printing, December 2012
USA(fus)