2014 FORD MUSTANG adding oil

Adding Engine Oil
Note:Do not remove the filler cap when the engine is running.
Note:Do not add engine oil further than the MAX mark. Oil levels above
the MAX mark may cause engine damage.
Only use oils certified for gasoline engines by the
American Petroleum Institute (API). An oil with this
trademark symbol conforms to the current engine
and emission system protection standards and fuel
economy requirements of the International Lubricants
Specification Advisory Council (ILSAC), comprised of
U.S. and Japanese automobile manufacturers.
1. Remove the filler cap.
2. Add engine oil that meets Ford specifications. SeeCapacities and
Specificationsfor more information.
3. Replace the filler cap. Turn it until you feel a strong resistance.
ENGINE COOLANT CHECK
Checking the Engine Coolant
The concentration and level of engine coolant should be checked at the
intervals listed inScheduled Maintenance Information.
Note:Make sure that the level is at the FULL COLD level or within the
COLD FILL RANGE in the coolant reservoir.
Note:Coolant expands when it is hot. The level may extend beyond the
COLD FILL RANGE.
If the level is below the COLD FILL RANGE, add coolant immediately.
SeeAdding Engine Coolantin this chapter.
The coolant concentration should be maintained within 48% to 50%,
which equates to a freeze point between -30°F (-34°C) and -34°F
(-37°C).
Note:For best results, coolant concentration should be tested with a
refractometer such as Rotunda tool 300ROB75240 available from your
dealer. Ford does not recommend the use of hydrometers or coolant test
strips for measuring coolant concentrations.
Note:Automotive fluids are not interchangeable; do not use engine
coolant/antifreeze or windshield washer fluid outside of its specified
function and vehicle location.
Maintenance243
2014 05+ Mustang(197)
Owners Guide gf, 1st Printing, November 2012
USA(fus)

Item CapacityFord part name or
equivalentFord part number /
Ford Specification
2Automatic transmissions that require MERCON® LV should only use MERCON® LV fluid. See
Scheduled Maintenance Informationto determine the correct service interval. Use of any fluid
other than the recommended fluid may cause transmission damage.3Add the coolant type originally equipped in your vehicle.4Approximate dry capacity, including cooler and tubes. Fluid level should be checked by an
authorized dealer.5Service refill capacity is covered underChecking and Adding Manual Transmission Fluidin
this chapter.6Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the
requirements of Ford specification WSS-M2C945-A and display the API Certification Mark.
Your engine has been designed to be used with Ford engine oil, which gives a fuel economy
benefit while maintaining the durability of your engine.
Using oils other than the one specified can result in longer engine cranking periods, reduced
engine performance, reduced fuel economy and increased emission levels.7Your engine has been designed to be used with Ford engine oil, which gives a fuel economy
benefit while maintaining the durability of your engine.
Using oils other than the one specified can result in longer engine cranking periods, reduced
engine performance, reduced fuel economy and increased emission levels.
Capacities and Specifications309
2014 05+ Mustang(197)
Owners Guide gf, 1st Printing, November 2012
USA(fus)

D
Defrost ...............................131, 133
rear window ............................136
Dipstick
automatic transmission
fluid ..........................................248
engine oil .................................242
Driving under special
conditions ..................................172
through water .........................213
Dual automatic temperature
control (DATC) .........................133
E
Electronic message center .........99
Electronic stability control ......183
Emergencies, roadside
jump-starting ..........................218
running out of fuel .................161
Emission control system ..........166
End user license agreement ....440
Engine ........................................305
cleaning ...................................262
coolant .....................................243
fail-safe cooling .......................246
idle speed control ...................250
lubrication specifications .......306
refill capacities ........................306
service points ..................240–241
Engine block heater .................157
Engine oil
checking and adding ..............242
dipstick ....................................242
filter, specifications ................310
refill capacities ........................306
specifications ..........................306Event data recording ..................12
Exhaust fumes ..........................157
F
Fail safe cooling ........................246
Fleet MyKey programming ........58
Flexible Fuel Vehicle (FFV) ....159
Floor mats .................................214
Fluid capacities .........................306
Fuel
calculating fuel economy .......100
cap ...........................................163
capacity ...................................306
choosing the right fuel ...........160
filler funnel .............................161
filling your vehicle with fuel ..163
filter, specifications ........249, 310
fuel pump shut-off ..................218
octane rating ...................161, 305
quality ......................................160
running out of fuel .................161
safety information relating to
automotive fuels .....................159
Fuel and distance computer ....110
outside temperature
indicator ..................................110
to empty indicator ..................110
trip distance ............................110
trip/reset button .....................110
Fuel - flex fuel
vehicle (FFV) ............................159
Fuses ..................................230–231
G
Garage door opener ..................147
Gas cap (see Fuel cap) ............163
Gauges ...........................92–93, 111
Index455
2014 05+ Mustang(197)
Owners Guide gf, 1st Printing, November 2012
USA(fus)