insTrumenT paneL
1 Trunk*/Liftgate* Release
2 Cruise Control*
To Set Your Cruise Control Speed
1. Press the ON control and release.
2. Accelerate to the desired speed.
3. Press the SET + control and release,
then take your foot off the accelerator.
After you set your speed, you can press
SET +/ SET – to adjust your cruise speed. To
disable, tap the brake, press the clutch pedal
or pull the CAN (Cancel) control toward you.
Note: Using the clutch pedal to cancel a set
speed may cause the engine speed to
increase briefly.
3 Information Display
Provides information about various systems
on your vehicle. Use the left, 5-way controls
located on the steering wheel to choose and
confirm settings and messages. Refer to the
Information Displays chapter of your Owner’s
Manual for more information.
4 Service Engine Soon Light
Illuminates briefly when the ignition
is turned on. If it remains on or is blinking after the engine is started, the On-Board
Diagnostics (OBD-II) system has detected a
malfunction.
Drive in a moderate fashion and
contact your authorized dealer as soon
as possible.
5 Tilt/Telescope Steering Column
Unlock the steering wheel by pulling the
lever down. Adjust the wheel to the desired
position. Push the lever back up to lock the
steering wheel in place.
6 Voice Controls*
Pull toward you to access
voice recognition.
Press to answer a call.
Press to exit phone mode or end a call.
7 Push Button Start*
Allows you to start your vehicle by pressing
the ENGINE START/STOP button while
fully pressing down on the brake (automatic
transmission) or clutch and brake (manual
transmission) pedal(s). Press the button
again to turn the engine off.
Note: Your intelligent access key must be
inside the vehicle for keyless starting to work.
8 Audio Controls*
Use the right-hand, 5-way controls to
adjust your audio system:
(Volume): Press to increase (+)
or decrease (–) volume levels.
(Seek): Press the right arrow to hear the
next saved radio station, CD track or MP3 choice.
Press the left arrow to hear the previous selection.
Press M to select a different audio source.
9 Wiper Controls
Use the rotary control on the stalk to adjust the
wipe intervals. Pull the stalk toward you to spray
and wash the windshield. Press the button at the
end of the lever to turn the rear wiper* on, off or
change to intermittent wipe.
10 Hazard Control
11 Power Door Locks
Press the control to lock or unlock
the doors. When the light on the
button is on, it indicates that all
of the doors and the luggage compartment are
locked. When the light is off, it indicates that either
the luggage compartment or one or more of the
doors are unlocked.
2014 focus
4*if equipped
26
38
5
49
1011
3
7
5
1
*if equipped
funcTion continued2014 focus
Ambient Lighting*
The ambient lighting system illuminates the interior with
a choice of several colors. The ambient lighting control
is located in the overhead console. Rotate the control
knob to switch the feature on and adjust the desired
brightness. Press the palette button to cycle through
your color choices.
Ambient lighting will switch on when the following
conditions have been met:
• You switch the ignition on, or
• You switch the headlamps on.
Traction Control
The traction control system helps avoid drive wheel
spin and loss of traction.
If your vehicle begins to slide, the system applies
the brakes to individual wheels and, when needed, reduces engine power at the same time. If the wheels
spin when accelerating on slippery or loose surfaces,
the system reduces engine power in order to
increase traction.
In certain situations (for example, stuck in snow or
mud), turning the traction control off may be beneficial
as this allows the wheels to spin with full engine power.
Turn the traction control system off through
the information display.
AdvanceTrac® Stability Control System
The system helps you keep control of your vehicle when
on a slippery surface. The electronic stability control
portion of the system helps avoid skids and lateral slides,
while the traction control system helps avoid drive wheel
spin and loss of traction.
Interior Lamps
The lamps will switch on when you open any door, press
a remote control button or press the overhead control.
Press
to switch off the
door illumination function
when you open any door.
Press
again to switch
the door illumination
function back on.
Press
to turn the
overhead lamps on and off.
comforT2014 focus
Tilting Head Restraints*
Your vehicle’s front-row head
restraints can be adjusted.
To raise: Pull up on the
head restraint.
To lower: Press the head
restraint down while pressing
and holding the guide sleeve
adjust/release button.
To tilt the head restraint: Gently pull the top of the head
restraint forward.
To return it to its upright position: Tilt it forward once
more and release.
Note: Do not attempt to force the head restraint backward
after it is tilted. Instead, continue tilting it forward until the
head restraint releases to the upright position.
Heated front Seats*
The heated front seat controls are located on the center
console near the gearshift lever.
To Use, Simply
• Adjust the dial to the desired
heat setting.
• Choose from 0–5 (off-high).
Front-Seat Adjusters
Height/Recline Adjustment
Lift the control to adjust the height
of the seat. Lift the control to adjust the angle
of the seatback.
Dual Zone Temperature Control*
You can operate the
temperature with one control,
called single zone, or two,
called dual zone where both
driver and front passenger
can select independent
temperatures using their own
rotary dials.
To operate the dual zone: Use the rotary control on the
passenger’s side. Single zone automatically shuts off.
You can now adjust the driver’s side and passenger’s side
temperatures independently.
To return back to single zone: Press and hold the AUTO
button for 2–4 seconds. The passenger’s temperature
switches to the driver’s temperature setting.
Height
Adjustment
Control
Seatback
Recline
Control
1415*if equipped *if equipped