2014 FORD FOCUS light

insTrumenT paneL
1 Trunk*/Liftgate* Release
2 Cruise Control*
To Set Your Cruise Control Speed
1. Press the ON control and release.
2. Accelerate to the desired speed.
3. Press the SET + control and release,
then take your foot off the accelerator.
After you set your speed, you can press
SET +/ SET – to adjust your cruise speed. To
disable, tap the brake, press the clutch pedal
or pull the CAN (Cancel) control toward you.
Note: Using the clutch pedal to cancel a set
speed may cause the engine speed to
increase briefly.
3 Information Display
Provides information about various systems
on your vehicle. Use the left, 5-way controls
located on the steering wheel to choose and
confirm settings and messages. Refer to the
Information Displays chapter of your Owner’s
Manual for more information.
4 Service Engine Soon Light
Illuminates briefly when the ignition
is turned on. If it remains on or is blinking after the engine is started, the On-Board
Diagnostics (OBD-II) system has detected a
malfunction.
Drive in a moderate fashion and
contact your authorized dealer as soon
as possible.
5 Tilt/Telescope Steering Column
Unlock the steering wheel by pulling the
lever down. Adjust the wheel to the desired
position. Push the lever back up to lock the
steering wheel in place.
6 Voice Controls*
Pull toward you to access
voice recognition.
Press to answer a call.
Press to exit phone mode or end a call.
7 Push Button Start*
Allows you to start your vehicle by pressing
the ENGINE START/STOP button while
fully pressing down on the brake (automatic
transmission) or clutch and brake (manual
transmission) pedal(s). Press the button
again to turn the engine off.
Note: Your intelligent access key must be
inside the vehicle for keyless starting to work.
8 Audio Controls*
Use the right-hand, 5-way controls to
adjust your audio system:
(Volume): Press to increase (+)
or decrease (–) volume levels.
(Seek): Press the right arrow to hear the
next saved radio station, CD track or MP3 choice.
Press the left arrow to hear the previous selection.
Press M to select a different audio source.
9 Wiper Controls
Use the rotary control on the stalk to adjust the
wipe intervals. Pull the stalk toward you to spray
and wash the windshield. Press the button at the
end of the lever to turn the rear wiper* on, off or
change to intermittent wipe.
10 Hazard Control
11 Power Door Locks
Press the control to lock or unlock
the doors. When the light on the
button is on, it indicates that all
of the doors and the luggage compartment are
locked. When the light is off, it indicates that either
the luggage compartment or one or more of the
doors are unlocked.
2014 focus
4*if equipped
26
38
5
49
1011
3
7
5
1
*if equipped

funcTion
Rear View Camera*
Provides a video image
of the area behind the
vehicle in either the
rearview mirror or the
display in the center of
the instrument panel.
The image automatically
appears when the vehicle
is in R (Reverse) and
uses green, yellow and
red guides to alert you of
your proximity to objects.
Integrated Blind Spot Mirrors
Designed to assist you
by increasing the visibility
along the side of
your vehicle.
• The integrated convex
mirror is built into the
upper outboard corner
of the exterior mirrors.
• As an approaching
vehicle moves toward
you, you will see its
reflection first in the
main mirror, and then
in the blind spot mirror.
Forward and Reverse Sensing Systems*
Sounds an audible
warning tone if there is an
obstacle near the vehicle’s
front or rear bumpers.
• As the vehicle
moves closer to the
obstacle, the rate
of the warning
tone increases
in frequency.
• The front sensors automatically activate when the
vehicle is in D (Drive) and will detect objects up to
27 inches (70 centimeters) away.
• The reverse sensors are activated automatically when
the vehicle is in R (Reverse), and will detect objects up to
6 feet (2 meters) away.
•
See the Parking Aids chapter in your Owner’s Manual for
complete information on your vehicle’s sensing systems.
Note: Visibility aids do not replace the need to watch where
the vehicle is moving. Refer to your Owner’s Manual for
safety information, more details and limitations.
1213*if equipped
Active Park Assist* The active park assist
system can detect an
available parallel parking
space and automatically
steer the vehicle into that
space (hands-free). The
system instructs the driver with visual and/or audible
instructions with regard to braking, accelerating and
shifting gears in order to safely park the vehicle.
• To initiate active park assist, press the AUTO |P|
button located near the center console on the
instrument panel.
• To stop the parking procedure, grab the steering wheel
or press the control again. For complete information,
refer to the Parking Aids chapter in your Owner’s Manual.
Note: The driver is always responsible for controlling the
vehicle, supervising the system and intervening, if required.
Towing Your Focus
Towing your Focus behind an RV or any other vehicle may
be limited. Refer to Towing the Vehicle on Four Wheels in
the Towing chapter of your Owner’s Manual.
Autolamps* The headlamps will
switch on and off
automatically in
low light situations
or during inclement
weather. They will
remain on for a period
of time after you
switch the ignition
off. You can adjust
the time delay using
the information
display controls.
Headlamp Exit Delay
After you switch the ignition off, you can switch the
headlamps on by pulling the direction indicator lever
toward you. You will hear a short tone. The headlamps
will switch off automatically after three minutes with any
door open or 30 seconds after the last door has been
closed. You can cancel this feature by pulling the direction
indicator toward you again or switching the ignition on.
2014 focus
*if equipped

funcTion continued2014 focus
Ambient Lighting*
The ambient lighting system illuminates the interior with
a choice of several colors. The ambient lighting control
is located in the overhead console. Rotate the control
knob to switch the feature on and adjust the desired
brightness. Press the palette button to cycle through
your color choices.
Ambient lighting will switch on when the following
conditions have been met:
• You switch the ignition on, or
• You switch the headlamps on.
Traction Control
The traction control system helps avoid drive wheel
spin and loss of traction.
If your vehicle begins to slide, the system applies
the brakes to individual wheels and, when needed, reduces engine power at the same time. If the wheels
spin when accelerating on slippery or loose surfaces,
the system reduces engine power in order to
increase traction.
In certain situations (for example, stuck in snow or
mud), turning the traction control off may be beneficial
as this allows the wheels to spin with full engine power.
Turn the traction control system off through
the information display.
AdvanceTrac® Stability Control System
The system helps you keep control of your vehicle when
on a slippery surface. The electronic stability control
portion of the system helps avoid skids and lateral slides,
while the traction control system helps avoid drive wheel
spin and loss of traction.
Interior Lamps
The lamps will switch on when you open any door, press
a remote control button or press the overhead control.
Press
to switch off the
door illumination function
when you open any door.
Press
again to switch
the door illumination
function back on.
Press
to turn the
overhead lamps on and off.
comforT2014 focus
Tilting Head Restraints*
Your vehicle’s front-row head
restraints can be adjusted.
To raise: Pull up on the
head restraint.
To lower: Press the head
restraint down while pressing
and holding the guide sleeve
adjust/release button.
To tilt the head restraint: Gently pull the top of the head
restraint forward.
To return it to its upright position: Tilt it forward once
more and release.
Note: Do not attempt to force the head restraint backward
after it is tilted. Instead, continue tilting it forward until the
head restraint releases to the upright position.
Heated front Seats*
The heated front seat controls are located on the center
console near the gearshift lever.
To Use, Simply
• Adjust the dial to the desired
heat setting.
• Choose from 0–5 (off-high).

Front-Seat Adjusters
Height/Recline Adjustment
Lift the control to adjust the height
of the seat. Lift the control to adjust the angle
of the seatback.
Dual Zone Temperature Control*
You can operate the
temperature with one control,
called single zone, or two,
called dual zone where both
driver and front passenger
can select independent
temperatures using their own
rotary dials.
To operate the dual zone: Use the rotary control on the
passenger’s side. Single zone automatically shuts off.
You can now adjust the driver’s side and passenger’s side
temperatures independently.
To return back to single zone: Press and hold the AUTO
button for 2–4 seconds. The passenger’s temperature
switches to the driver’s temperature setting.
Height
Adjustment
Control
Seatback
Recline
Control
1415*if equipped *if equipped

comforT continued
Auxiliary Power Points
The power points may
be found on the center
console or on the rear
of the center console,
depending on your
vehicle style. A power
point can be used to
power your smaller
electrical devices that require up to 180 watts. Run the
vehicle for full capacity use of the power point.
To prevent the battery from being discharged:
• Do not use the power point longer than necessary
when the vehicle is not running.
• Do not leave devices plugged in overnight or when
the vehicle is parked for extended periods.
Rear Window Buffeting
You may hear a pulsing noise when one or both of the
rear windows are open. Lower a front window slightly to
reduce this noise.
• Press the switch to open the window.
• Lift the switch to close the window.
Folding the Rear Seats
Your rear seatback can fold down for more versatile
cargo storage and transport. Your vehicle may have split
seatbacks* that must be folded individually.
To lower the seatback(s), do the following:
• Remove the outboard head restraint(s).
• Press the unlock buttons located on the top outboard
sides of each seatback.
• Push the seatback forward.
Note: Make sure you
stow the safety belt
in the belt stowage
clip to prevent it from
getting caught in the
seat latch.
• In vehicles with split-folding seatbacks, you can flip
the seat cushions forward before folding the seatback
for additional cargo space.
• When raising the seatback(s), make sure you hear the
seat latch into place and that no red portion is visible
on the release button on both sides.
*if equipped1617
Moonroof*
The moonroof control is located on the overhead console
and is equipped with a one-touch open and close feature.
To stop motion during one-touch operation, press the
control a second time.
• Press and release the rear of the control to open the
moonroof. The moonroof will stop short of the fully
opened position. This position helps to reduce
wind noise.
• Press and release the control again to fully open
the moonroof.
• Press and release the front of the control to close
the moonroof. Trunk*/Liftgate* Release
To open the trunk/
liftgate from the inside
of your vehicle, press the
button located on the
instrument panel, near
the headlamp switch.
If your car is unlocked, you
can open it from the outside
by pressing the release
button located under the
handle and above the
license plate.
If your vehicle is locked
and the intelligent access
transmitter* is within
3 feet (1 meter) of the
trunk/liftgate, you can open it from the outside by
pressing the release button located above the
license plate.
You can also use the keyless remote.
2014 focus
*if equipped

2014 focusessenTiaL informa Tion
18
Fuel Tank Capacity/Fuel Info
Your vehicle has a 12.4 gallon (46.9L) fuel tank capacity.
Your vehicle may be flex-fuel capable. If so, it will have
a yellow ring around the fuel inlet. Flex fuel vehicles
are designed to use ETHANOL (E85) fuel blends and
UNLEADED FUEL. Please see your Owner’s Manual for
specific refueling instructions when using E85.
Non-flex fuel vehicles use only UNLEADED fuel with an
octane rating of 87. Do not use fuel
E20 - E85 ethanol (E85),
diesel fuel, fuel-methanol, leaded fuel or any other
fuel because it could damage or impair the emission
control system.
Easy Fuel® Sy s t e m
To Use
• Put your vehicle into P (Park) and turn the ignition off.
• Open the fuel-filler door.
• Insert the nozzle.
• Begin fueling.
• Wait 10 seconds between
the time the refueling nozzle
is shut off until you remove
the nozzle from the vehicle
to allow residual fuel in the
nozzle to drain into
the tank.
• When using a portable fuel container, slowly insert the
fuel funnel (located in the spare tire compartment)
and pour the fuel into the funnel.
Note: Do not use aftermarket funnels as they will not work
with the Easy Fuel system and may cause damage. Properly
clean the funnel after each use.
Tire Pressure Monitoring System
Your vehicle illuminates a low tire pressure warning light in your instrument cluster when one or more of your
tires is significantly underinflated. If this happens, stop
and check your tires as soon as possible, then inflate them
to the proper pressure. Refer to the Inflating Your Tires
section in the Wheels and Tires chapter of your Owner’s
Manual for more information.
Location of Spare Tire and Tools
Your spare tire and tools are located beneath the carpeted
floor panel in the rear of your vehicle.
• The spare tire is designed for emergency use
only and should be replaced as soon as possible.
• For complete details on changing your tire, refer
to the Changing a Road Wheel section in the
Wheels and Tires chapter of your Owner’s Manual.
Powershift Six-speed Automatic Transmission*

This transmission is designed for
fun-to-drive performance and
exceptional fuel efficiency, by using the
advantages of a manual transmission
with the convenience of an automatic
transmission. You may notice the
following characteristics of
this technology:
• Mechanical noises after the engine is turned off, after
the driver door is opened and during some transmission
shifting events. These are normal and do not
cause damage.
• Firm gearshifts when moving the accelerator pedal
back and forth quickly.
Your transmission continuously makes electronic
adjustments to optimize shift quality and acceleration
performance. Most adjustments will be made during the
first 1,000 miles (1610 kilometers) of operation. During
this break-in period, slight vibrations may be felt when
accelerating the vehicle from low speeds.
Roadside Assistance
Your new Ford vehicle comes with the assurance and
support of 24-hour emergency roadside assistance.
To receive roadside assistance in the United States,
call 1-800-241-3673. In Canada, call 1-800-665-2006.
SelectShift Automatic® Transmission*
Gives you the ability to manually
change gears if you’d like. To use,
move the gearshift lever from D (Drive)
to S (Sport). Activate SelectShift by
using the + / – thumb toggle located
on the side of your gearshift lever to
manually make shifts. Press the (+)
button to upshift. Press the (–)
button to downshift.
*if equipped19