2014 FORD FOCUS ELECTRIC ECO mode

1
2
3
4
5
6
7
8
CR
uiSE C ontRoL
To Set y our Cruise Control Speed
1.
Press and release on.
2. Accelerate to the desired speed.
3. Press and release SEt+, then take your foot off
the accelerator.
After you set your speed, you can adjust your
cruise speed by pressing and releasing SEt +/- .
To disable, press and release oFF.
LEFt VEhiCLE inF oRMAtion DiSPLA y
Provides specific information about various
systems on your vehicle including the status of your
high-voltage battery and the other unique features of
your electric vehicle.
Use the left-hand, 5-way controls located on the
steering wheel to choose and confirm settings and
messages. Refer to the Instrument Cluster chapter of
your Owner’s Manual for more information.
SERViCE VEhiCLE Soon LiGht
Illuminates when a powertrain or high-voltage
charge system fault has been detected. If the
indicator stays on or continues to come on, contact
your authorized dealer as soon as possible.
tiL t/tELESC oPE StEERinG CoL uMn
Unlock the steering wheel by pulling the lever down.
Adjust the steering wheel to the desired position.
Push the lever up to lock the steering wheel in place .
RiGht VEhiCLE inFoRMAtion DiSPLA y
Displays information about Entertainment, Phone,
Navigation* and Surplus. Use the right hand 5-way
controls located on your steering wheel to scroll
through, highlight and make minor adjustments
within a selected menu. Refer to the MyFord Touch
®
chapter in your Owner’s Manual for
more information.
MEDiA StEERinG whEEL ContR oLS
Press + to increase or – to decrease volume levels.
Pull toward you to access voice recognition.
Press to answer an incoming phone call.
Press to end a phone call and exit phone mode .
PuSh Button St ARt–READ y to DRiVE
note: Your intelligent access key must be inside the vehicle
to put the vehicle in “Ready to Drive” mode . The keyless
warning alert sounds when you open the driver’s door and
your vehicle is in RUN.
Allows you to go into “Ready to Drive” mode by
pressing the P owER StAR t/S toP button while
fully pressing down on the brake pedal. A green
“Ready to Drive” indicator light
will appear in the
instrument cluster after you start the vehicle. This
lets you know that the vehicle is turned on and ready
for driving. Press the P owER StAR t/S toP button
again to turn the vehicle off .
hAzARD ContR oL–unL oCK/LoCK
1
3
4
6
8
Instrument Panel
2
7
5
*if equipped67

*if equipped
Tips
• Make sure you accept SYNC’s request to access
your phone.
• To pair subsequent phones, please refer to Pairing
Subsequent Phones in the SYNC chapter of your
Owner’s Manual.
• If you are experiencing pairing problems, try performing
a clean pairing by deleting your services from SYNC and
deleting the SYNC connection from your phone, and then
repeat the process.
PhonE
Voice-control your phone for hands-free calling with your
phone securely put away. With SYNC, you won’t even need
to know the phone number. Just say the name of the person
you want from your contacts.
y our Phone Connects y ou with Many other Features and
S ynC Services*
• Connect to SYNC Services for traffic, directions, business
searches and information favorites.
• Connect to Operator Assist to help locate a listing
or destination.
• Call for a Vehicle Health Report.
• Connects directly to a 911 Operator in the event of an
accident (feature must be set to on prior to an incident).
• Transfer calls seamlessly from SYNC to phone as you
get in or out of your vehicle.
Refer to the MyFord Touch chapter of your Owner’s Manual
for complete details.
uSinG My PhonE with S ynC
note: Enter your phone book contacts with both first and last names
to increase SYNC’s ability to select the correct contact. Remember
to say the contact name exactly as it is listed in your phone book.
Making a Phone Call
Use SYNC to make a phone call to anyone in your phone
book by pulling the voice control
. When prompted, give a
voice command.
For example, you could say “Call Jake Smith at home”. SYNC
repeats the command back to you and dials the number.
note: You can also make phone calls by pulling the voice button
and when prompted, give the voice command “Dial” again to
initiate the call.
answering incoming Calls
Whenever you have an incoming call, you will be able to see
the name and number of the person calling in your display.
Press the phone button
to answer an incoming call. You
can hang up at any time by pressing the phone button .
do not disturb Mode
This feature blocks incoming calls and text messages, and
sends them for later. You still have access to outgoing calls
when this feature is active. Say the voice command “Do not
disturb on” to enable and “Do not disturb off” to disable.
nAViGA tion*
Get started with your navigation system by pressing the
upper-right, green corner. The available, voice-activated
navigation system includes:
• SiriusXM Traffic
• SiriusXM Travel Link
• GPS (Global Positioning System) technology
• 3-D mapping
• Turn-by-turn navigation
Some features require activation. Refer to the
MyFord Touch chapter of your Owner’s Manual for
complete details.
Tips
• Save your favorite locations by touching “Save
to Favorites.”
• Change your map views from Heading Up, North Up
or 3D.
Set a Destination
Set a destination on your touchscreen by using a street
address, a city center, a place on the map or a point of
interest (POI). The easiest way, however, is by voice.
1. Pull the voice control
. When prompted, say
“Destination street address”.
2. The system will ask you to say the full address and will
display an example on-screen.
3. You can then speak the address naturally, such as:
“One two three Main Street, Anytown”. You can also use the touchscreen to enter a destination
and narrow your choices by city or street as you type.
You can choose from up to three different types
of routes:
•
Fastest : Uses the fastest moving roads possible.
• Shortest: Uses the shortest distance possible.
• Eco (EcoRoute): Uses the most fuel-efficient route.
CLiMA tE
SYNC with MyFord Touch controls the temperature, airflow
direction, fan speed, and activates other climate features for
you and your passenger. To use voice commands to operate
the climate control, say a voice command like “Climate
temperature 72 degrees” and MyFord Touch will make
that adjustment.
Set your temperature
• Touch the lower-right, blue Climate corner on
the touchscreen.
• Set your exact, desired temperature by using the
+ or – buttons.
*if equipped1011

Convenience
REMotE EntRy iConS
• Press once to lock all doors. Press again within three
seconds to confirm all doors are locked.
• Press
once to unlock the driver’s door. Press again
within three seconds to unlock all doors.
• Press
to activate the panic alarm. Press again or
switch the ignition on to deactivate.
• Press
twice within three seconds to release the
liftgate latch.
• Car finder: Press
twice within three seconds to locate
your vehicle. The horn will sound and the turn signals
will flash.
intELLiGEnt A CCESS KEy
note: Your intelligent access key must be within 3 feet (1 meter)
of the vehicle for intelligent access to function properly.
To unlock the driver’s door, pull the front exterior door
handle. To lock the doors, press the sensor button on
the door handles. To unlock and open the liftgate, press
the exterior liftgate release button near the license plate.
The intelligent access
key also contains a
mechanical key blade
which can be used to
unlock the driver door,
if necessary.
REMotE StARt
Remote start allows you to start the vehicle from outside
the vehicle using your key. To start, press and then press twice within three seconds. Once inside, apply the
brake while pressing the P owER StAR t/S toP button.
Shift into D (Drive) and go. To turn the vehicle off from
outside the vehicle after using your remote start,
press
once.
note: It is also possible to turn your vehicle on and off using the
MyFord® Mobile application on your smartphone.
ChARGinG y ouR VEhiCLE
Your vehicle must be in P (Park) to charge. Press the
indentation located on the charge port door and the
door will rotate open. Plug the charging coupler into the
vehicle’s charge port receptacle and make sure that the
button “clicks” confirming that it is completely engaged.
• When the vehicle detects the connection, each quadrant
of the light ring will flash in a clockwise manner two full
times (indicating the start of a normal charge cycle).
• When you are done charging your vehicle, press the
button on the charging coupler and remove it from the
charge port receptacle.
• Close the charge port door by
pressing and holding the indentation
on the door until the door rotates
counterclockwise and closes. See
your Owner’s Manual for complete
information on charging
your vehicle.
1213
EntER tAinMEnt
No matter how you store your music, SYNC makes it yours
to enjoy when you’re behind the wheel. Press the lower-left,
red corner of the touchscreen. From here, you can easily go
between AM/FM, CD, USB and other media sources.
Set y our Radio Presets
• Touch the Entertainment corner on the touchscreen.
• Touch FM.
• Touch Direct Tune.
• Enter the desired station and touch Enter.
• Touch Presets , and then touch and hold one of the
memory preset buttons to save it. The sound will mute
briefly and return once the station is saved.
uSinG S ynC to A CCESS DiGit AL MEDiA
Plug in your USB media devices, such as phones and MP3
players, and use SYNC to play all of your favorite music. using Voice Commands to Play Music
1.
Plug your media player into your USB port.
2. Pull the voice control
. When prompted, say “USB”,
then follow-up by saying one of the voice commands.
SuRPL uS MoDE
In Surplus mode, either butterflies or a gauge represents
your surplus or status. The number of butterflies matches
the current surplus or status distance, with a maximum of
16 butterflies.
• If you entered your next charge destination in the
navigation system and you see butterflies on your screen,
then you should be able to make your destination, and you
have a Surplus.
• If you see butterflies but did not enter your next charge
destination, then you should be able to achieve the range
estimate shown at the start of your drive, and you have a
positive Status.
See the Instrument Cluster chapter in your Owner’s Manual
for more information.