2014 FORD EXPEDITION mirror

CONVENIENCE
mYkeY®
MyKey allows you to program certain
driving restrictions in order to promote
good driving habits. You can program
things such as speed restrictions and
limited volume levels. For complete
information, refer to the MyKey chapter
in your Owner’s Manual.
inTegraTed keYhead TranSmiTTer
Press once to lock all doors. Press
again to confirm all doors are closed.
• Press
once to unlock the driver’s
door. Press again within three
seconds to unlock all doors.
• Press
to activate the panic alarm.
Press again or turn the ignition on
to deactivate.
• Press
twice within three seconds
to unlatch the liftgate window. With a
power liftgate*, however, this button
will open or close the power liftgate
or reverse its movement instead of
the liftgate window.
• Car finder: Press
twice within three
seconds to locate your vehicle. The
horn will chirp and the turn lamps
will flash.
SecUricode™ keYLeSS
enTr Y keYP ad
Lock or unlock the doors, or release the
liftgate glass without using a key. The
keypad can be operated with the factory-
set, 5-digit entry code; this code is located
on the owner’s wallet card in the glove
box. You can also create up to five of your
own 5-digit personal entry codes.
To lock all of the doors and liftgate
Press and hold 7•8 and 9•0 at the same
time. For complete information, refer to
the SecuriCode Keyless Entry Keypad in
the Locks chapter of your Owner’s Manual.
rain-SenSing wiPerS*
If activated, your wipers will automatically
turn on when moisture is present on
the windshield. The wiper speed will
vary based on the amount of moisture
detected and the sensitivity setting. To
deactivate, turn your wiper controls off.
Note: Make sure that this feature is turned
off before entering a car wash.
memor Y feaTUre*
The memory function will save and recall
the positions of the driver seat, power
mirrors and adjustable pedals. Use the
memory controls located on the left side
of the driver’s seat
to program
and then recall memory positions.
To program
1. Switch the ignition on.
2. Move the memory features to your
desired position.
3. Press and hold the 1 button
until
you hear a tone.
Use this same procedure to set the
second position using the 2 button
.
You can now use these controls to recall
the set memory positions.
SoS PoST -craSh aLerT SYSTem™
The SOS Post-Crash Alert System
provides audible and visual alarms in
the event of a crash. The turn signals
will flash and the horn will sound. To
deactivate the system, press the hazard
flasher control, or you can press
on
your remote transmitter.
COMFORT
Sea Ting-To-cargo VerSa TiLiTY
Note: Before folding the second- or third-row
seats, make sure that the head restraints are
fully flipped down by pulling on the strap, and
that all items have been removed from the floor
and seats.
To foLd The fLa T-foLding Third-row
Sea TS To The Load fLoor
Pull up on the handle located behind the
seatback while pushing the seatback forward
and down into the seat cushion.
Note: A moderate force may be required to
move the seat forward and down.
To return the seats to an upright
seating position
Lift and pull the seat rearward until the latch
is fully engaged.
Pull Strap
handle
e-Z enTr Y inTo The
Third-row Sea TS
The E-Z entry seat allows for easier
entry and exit to and from the
third-row seat.
To enter the third-row seating area
1. Fold the head restraint forward.
2. Pull up on Lever 1.
3. Fold down the second-row seat
and release the handle.
4. Pull the handle up again until the
seat releases from the floor.
5. Push the seat upward and fold it
away from the third row.
To return the seat to an upright
seating position
1. Push the seat down and latch it
to the floor.
2. Bring the seatback to an upright
position. It should lock into position.
3. Lift up on the head restraint until it
locks into its original position.

Lever 1
Position 2
Position 3
page 11 page 10*if equipped

naViga Tion SYSTem*
Set your destination by using your
touchscreen or voice commands.
To program a destination using
the touchscreen
1. Press the DEST button and “Accept” when
the “Terms of Use” screen appears.
2. Select from the following:
a. Quick: allows you to cancel the route,
access emergency destinations (such as
police stations or hospitals), save your
favorite destinations to presets for quick
access, find the nearest point of interest
(POI), and recall a previous destination
or entry from your address book to set
as a current destination.
b. Standard: allows you to set a
destination using any of the following:
i. Address Book
ii. Previous Destination
iii. Phone Number
iv. Map
v. Street Address
vi. POI
vii. Freeway Exit/Entrance or
Intersection
c. Edit Route: allows you to make any
adjustments to the currently selected
navigation route such as:
FUNCTION
page 15 page 14
i. Cancel
ii. Detour
iii. View Route
iv. Edit Route Preferences
v. Edit Traffic Preferences
vi. Edit Destination/Way Points
vii. Edit Turn List
Note: Periodic map updates are available at an additional cost.
Call 1-800-NAVMAPS (in Mexico, call 01-800-557-5539)
or visit www.navigation.com/ford.
rear View camera*
The rear view camera system is located on the liftgate
and provides a video image of the area behind the
vehicle. The display will automatically appear on the
navigation system screen* or in the rearview mirror
whenever the vehicle is in R (Reverse) and uses colors
(green, yellow and red) to alert you of your proximity
to objects.
forward and reVerSe SenSing SYSTemS*
If your vehicle is equipped with forward and reverse sensing systems, they may warn you
if there is an object in front of or behind the vehicle. The system will sound a warning tone
that increases in frequency as the object gets closer and will sound continuously when the
object is less than 10 inches away.
Note: Visibility aids do not replace the need to watch where the vehicle is moving. Refer to
your Owner’s Manual for safety information, more details and limitations.
UniVerSaL garage door oPener*
Your driver’s side visor has a built-in wireless transmitter that replaces the common hand-
held garage door opener. This system can also be programmed to security systems, entry
gates and home or office lighting. Refer to the Universal Garage Door Opener chapter in
your Owner’s Manual for programming instructions.
*if equipped