2014 FORD E SERIES ignition

[x] Cancel search: ignition

Page 105 of 438

FORD E SERIES 2014 4.G Owners Manual The power point can provide power whenever the ignition is on and the
indicator light is on. The indicator light is located in the top left corner
of the power point.
When the indicator light is:
•o

Page 107 of 438

FORD E SERIES 2014 4.G Owners Manual IGNITION SWITCH
Note:Do not store the key in the ignition after the vehicle is turned off
and you have left the vehicle. This could cause a drain on the battery.
A.Accessory:Allows the electrical acce

Page 108 of 438

FORD E SERIES 2014 4.G Owners Manual Note:The engine may continue cranking for up to 15 seconds or until it
starts.
Note:If you cannot start the engine on the first try, wait for a short
period and try again.
Failure to Start
If you cann

Page 115 of 438

FORD E SERIES 2014 4.G Owners Manual RUNNING OUT OF FUEL
Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
If you have run out of fuel:
•You may need to cycle the ignition from off to

Page 117 of 438

FORD E SERIES 2014 4.G Owners Manual For consistent results when filling the fuel tank:
•Turn the ignition off before fueling; an inaccurate reading results if the
engine is left running.
•Use the same fill rate (low–medium–high)

Page 118 of 438

FORD E SERIES 2014 4.G Owners Manual EMISSION CONTROL SYSTEM
WARNING:Do not park, idle, or drive your vehicle in dry grass
or other dry ground cover. The emission system heats up the
engine compartment and exhaust system, which can start

Page 120 of 438

FORD E SERIES 2014 4.G Owners Manual Readiness for Inspection/Maintenance (I/M) Testing
Some state, provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle

Page 121 of 438

FORD E SERIES 2014 4.G Owners Manual AUTOMATIC TRANSMISSION OPERATION
Understanding the Gearshift Positions of the 4–Speed Automatic
Transmission
WARNING:Always set the parking brake fully and make sure
the gearshift is latched in P (P