2014 FIAT QUBO low beam

NoteWhen one of the doors is opened, the display
is activated showing the time and mileage for a few
seconds.
CONTROL BUTTONS
To scroll through the screen and the options
upwards or to increase the value displayed.
MENU ESCPress briefly to access the menu and/or go to next
screen or confirm the chosen menu option.
Hold down to go back to the standard screen.
To scroll down through the displayed menu and
the related options or to decrease the value
displayed.NoteButtons
and
activate different
functions according to the following situations:
Adjusting headlight alignment
- with the dipped beam headlights on, press button
or
to adjust headlight alignment.
Setup menu
- in menus, to scroll up and down;
- in setting operations, to increase or decrease a
value.
fig. 12
F0T0449
15KNOW YOUR
VEHICLESAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

On the standard screen, briefly press MENU ESC to
start browsing.
Press
or
to browse within the menu.
NoteOnly the short menu may be accessed for
reasons of safety while the vehicle is moving ("Speed
Beep" setting). Stop the vehicle to access the full
menu.
Adjusting the vehicle interior lighting
This function is available with the dipped beam
headlights on to adjust brightness of the instrument
panel, buttons and radio display.
To adjust the light intensity, proceed as follows:
❒press the MENU ESC button briefly to make the
display flash the previously set level;
❒press buttonand
to set the required
brightness level;
❒press the MENU ESC button briefly to return to
the menu screen or give the button a long press
to return to the standard screen without storing.
Speed limit (Speed Beep)
This function is used to set the vehicle speed limit
(km/h or mph). When this limit is exceeded the
driver is immediately alerted (see “Warning lights
and messages” section).
To set the desired speed limit, proceed as follows:
- briefly press the MENU ESC button: the display will
show the words (Speed Beep);- press
or
to select speed limit activation
(On) or deactivation (Off );
- if the function is on, press
or
to select the
required speed limit and then press MENU ESC to
confirm;
NoteSetting is possible between 30 and 200 km/h,
or 20 and 125 mph, according to the previously
stored unit. See the "Setting the unit of
measurement" paragraph described below. The
setting will increase/decrease by five units each time
button
/
is pressed. Hold down
/
to
increase/decrease the setting rapidly. Complete
the setting by single pressing the button when you
approach the required value.
- press the MENU ESC button briefly to return to
the menu screen or give the button a long press
to return to the standard screen without storing.
To cancel the setting, proceed as follows:
- press the MENU ESC button briefly to make the
display flash (On);
- press
: (Off ) will flash on the display;
- press the MENU ESC button briefly to return to
the menu screen or give the button a long press
to return to the standard screen without storing.
Trip B activation (tripB data)
With this function is possible to turn the Trip B
display (trip meter) on and off.
For more information see "Trip computer"
paragraph.
18KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

changes. This function complies with the relevant
legislations currently in force.
FOG LIGHTS
(for versions/markets, where provided)
Press button
fig. 47 with the side/taillights on to
turn the fog lights on. Instrument panel warning light
comes on.
Press the button again to turn the lights off.
REAR FOG LIGHTS
Press button
fig. 47 with the dipped beams or
front fog lights on to turn the rear fog lights on.
Instrument panel warning light
comes on.
Press the button again to turn the lights off or turn
off the dipped beam headlights and/or the front
fog lights (for versions/markets, where provided).
INTERIOR FITTINGSDRIVER'S SEAT ARM REST
(for versions/markets, where provided)
On some versions, the driver side front seat has an
armrest.
Raise or lower the armrest as shown by the arrows
fig. 48.
fig. 47
F0T0450
fig. 48
F0T0056
48KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder, proceed as follows:
❒disengage coupling B fig. 133;
❒turn anticlockwise the cylinder to replace and raise
it;
❒fit the new cylinder and turn it clockwise;
❒connect B to the canister and fit the filler tube A
into its allocated space.
CHANGING A BULBGENERAL INSTRUCTIONS
❒Before changing a bulb check the contacts for
oxidation;
❒burnt bulbs must be replaced by others of the
same type and power;
❒always check the height of the headlight beam after
changing a bulb, for reasons of safety;
❒when a light is not working, check that the
corresponding fuse is intact before changing the
bulb. For the location of fuses, refer to the
“Changing a fuse” paragraph in this section;
WARNING
Modifications or repairs to the electrical
system that are not carried out
properly or do not take the system's technical
specifications into account can cause
malfunctions leading to the risk of fire.
WARNING
Halogen bulbs contain pressurised gas
which may cause small fragments of
glass to be projected outwards if the bulb is
broken.
fig. 133
F0T0132
142KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

CHANGING AN EXTERIOR BULBFor the type of bulb and corresponding power rating,
see the paragraph "Changing a bulb".
FRONT LIGHT CLUSTERS
The front light clusters fig. 134 contain sidelight,
dipped beam, main beam and direction indicator
bulbs.
The bulbs are arranged inside the light cluster as
follows:
❒A Side lights/tail lights and main/dipped beam
headlights;
❒B Direction indicators.SIDE LIGHTS - TAIL LIGHTS
To change the bulb, proceed as follows:
❒remove the protective lid A fig. 134;
❒turn the bulb holder A fig. 135 anticlockwise and
remove it;
❒remove the bulb B and replace it;
❒refit the new bulb, insert the bulb holder A fig. 135
again and then refit the protective lid A fig. 134
correctly.
fig. 134
F0T0093
fig. 135
F0T0094
146KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

DIPPED/MAIN BEAM HEADLIGHTS
To change the bulb (double filament), proceed as
follows:
❒remove the protective lid A fig. 134;
❒release the bulb holder clip;
❒remove the bulb A fig. 136 from connector B and
replace it;
❒refit the new bulb by inserting it on connector B
and then make the contour of the metallic part
mate with the grooves obtained on the headlight
parabola;
❒refit the bulb holder clip and refit the protective lid
A fig. 134 correctly.DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒turn the protective lid B fig. 134 anticlockwise;
❒remove the bulb A fig. 137 and replace it;
❒refit the protective lid B correctly.
fig. 136
F0T0095
fig. 137
F0T0096
147KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGESIN AN
EMERGENCYSERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Clutch ........................................... 195
CO2 emissions ........................... 211
Conditions of use ...................... 115
Controls........................................ 47
Coupling the tow ring............... 165
Cylinder replacement ............... 142D
ashboard ................................... 3
Dead lock ..................................... 8
Dead Lock .................................... 8
Dimensions ................................. 202
Dipped beam headlights ............ 41
Dipped/main beam
headlights (changing a bulb)... 147
Dipped/main beam
headlights ................................... 147
Direction indicators
(changing a bulb) .............. 147-149
Direction indicators ............ 42-147
– Left direction indicator
warning light .......................... 128
– Right-hand indicator
warning light .......................... 128
Door open .................................. 122
Doors (unlocking/locking) ........ 52
Double rear swing doors .......... 58
DPF (particulate filter) .............. 84DPF (particulate trap)
cleaning underway warning
light ............................................. 123
DPF (particulate trap)
(cleaning underway
warning light) ............................ 123
Driver's seat arm rest ................ 48
Driving style ................................ 114
EBD fault warning light............ 121
EBD (fault warning light) .......... 121
EBD system .................................. 70
Emergency starting.................... 109
Engine bay fuse box ................... 157
Engine codes ............................... 193
Engine compartment fuse
box table .................................... 160
Engine coolant fluid ................... 176
Engine coolant fluid
(warning light)........................... 120
Engine coolant fluid warning
light ............................................. 120
Engine coolant temperature
gauge............................................ 14
Engine ........................................... 194
Engine marking ........................... 192
Engine oil ..................................... 174
Engine oil (low pressure
warning light) ............................ 122EOBD system .............................. 76
ESP (system) ................................ 71
ESP/Traction Plus fault
warning light.............................. 121
ESP/Traction Plus (fault
warning light) ............................ 121
Extending the boot .................... 6
Exterior light fault warning
light ............................................. 126
Exterior lights .............................. 41
Exterior lights (warning
light) ............................................ 126
Fiat CODE system .................... 5
Fiat CODE vehicle
protection system fault
warning light.............................. 125
Fiat CODE (vehicle
protection system fault
warning light) ............................ 125
Fix&Go automatic quick
tyre repair kit... 137-139-141-142
Flashing the headlights ............... 41
Fluids and lubricants.................. 207
Fog lights (changing a bulb)...... 148
Fog lights ................................ 48-148
– Warning light ......................... 128
Fog lights warning light ............. 128
Follow Me Home ........................ 42
221KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONSINDEX
1

Front airbags ............................... 100
– Front airbag driver's side .... 102
– Front airbag passenger's
side .......................................... 102
– Manual deactivation of
passenger front airbag
and side bag ........................... 103
Front ceiling light ....................... 152
Front ceiling light with map
reading lights (changing a
bulb) ............................................ 153
Front light clusters
(changing a bulb) ...................... 146
Front light clusters .................... 146
Front power socket ................... 49
Fuel consumption ...................... 210
Fuel cut-off system ..................... 83
Fuel filter (water in fuel
warning light) ............................ 124
Fuel level gauge ........................... 13
Fuel reserve warning light........ 124
Fuel (reserve warning light) ..... 124
Fuel system.................................. 195
Fuses (replacement) .. 155-157-161G
ear lever................................... 112
Generic failure indication
warning light.............................. 127Generic failure indication
(warning light)........................... 127
Glove compartment................... 49
Glow plug preheating fault
warning light.............................. 124
Glow plugs (preheating/fault
warning light) ............................ 124
Glow plugs preheating
warning light.............................. 124
Handbrake ................................... 110
Handbrake lever ......................... 110
Handbrake (warning light) ....... 118
Hazard lights ................................ 47
Headlight alignment
corrector .................................... 68
Headlights
– Headlight alignment
corrector................................. 68
– Light beam direction ............ 68
Headrest
– Front ........................................ 29
– Rear .......................................... 30
Heating and ventilation ............. 35
Heating and ventilation
system; ........................................ 34
Heavy use of the vehicle .......... 171
Hill Holder (system) .................. 72How to warm up the engine
after it has just started ........... 108
Identification data ..................... 191
Ignition switch
– Ignition ..................................... 11
– Steering lock........................... 12
In an emergency ......................... 129
Inflation pressure ....................... 201
Inflation procedure .................... 139
Injection system/EOBD
engine control system fault
warning light.............................. 123
Injection system (warning
light) ............................................ 123
Installing
electrical/electronic devices ... 80
Instrument panel ......................... 4
Instruments .................................. 12
Interior fittings ............................ 48
Interiors ....................................... 189
Isofix child seat assembly
setup ............................................ 97
Isofix child seats (fitting
arrangement) ............................. 97
– Seat compliance with
child seat use.......................... 99Jack ............................................... 131
222KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX