Page 296 of 363
▫Wiper Blades ....................... .307
▫ Adding Washer Fluid ..................309
▫ Brake System ....................... .310
▫ Appearance Care And Protection From
Corrosion .......................... .312
FUSES ............................. .319
▫ Interior Fuses ....................... .319
▫ Power Distribution Center #1 .............323
▫ Power Distribution Center (PDC) #2 ........325
VEHICLE STORAGE .....................326
REPLACEMENT BULBS .................327
BULB REPLACEMENT ..................328
▫ Headlamps Low Beam and High Beam ......328
▫ Front Turn Signal, Parking And Daytime
Running Lamps ...................... .328
▫ Front Fog Lamps ..................... .329
▫ Front/Rear Side Marker Lamps ............329
▫ Rear Tail, Stop, Backup And Turn Signal
Lamps ............................ .329
▫ Center High Mounted Stop Lamp (CHMSL) . . .330
FLUID CAPACITIES .....................331
FLUIDS, LUBES, AND GENUINE PARTS ......332
294 MAINTAINING YOUR VEHICLE
Page 329 of 363
REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Overhead Lamp C5W
Courtesy Lamp W5W
Exterior Bulbs
Bulb Number
Front Low and High
Beam Headlamp HIR2
Front Parking/Daytime
Running Lamps W21/5W
Front Fog Lamps H11
Front Side Marker Lamps W3W
Front Turn Signal Lamps WY21W
Bulb Number
Side Direction Lamps W5W
Rear Turn Signal Lamps PY21W
Rear Side Marker Lamps W3W
Rear Tail and Stop
Lamps PY21W/5W
Rear Backup Lamps W16W
Center High Mounted
Stop Lamp LED (See Authorized
dealer)
License Plate Lamps LED (See Authorized dealer)
NOTE: Numbers refer to commercial bulb types that
can be purchased from your authorized dealer.
If a bulb needs to be replaced, visit your authorized
dealer or refer to the applicable Service Manual.
7
MAINTAINING YOUR VEHICLE 327
Page 330 of 363
BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Headlamps Low Beam and High Beam
1. Remove the plastic cap from the back of the headlamp housing.
2. Rotate the bulb counter-clockwise.
3. Remove the bulb and replace as needed.
4. Install the bulb and rotate clockwise to lock in place.
5. Reinstall the plastic cap.
Front Turn Signal, Parking And Daytime Running
Lamps
1. Turn the steering wheel completely to the left or right.
2. Open the wheel housing access door.
Wheel Housing Access Door
328 MAINTAINING YOUR VEHICLE