▫Wiper Blades ....................... .307
▫ Adding Washer Fluid ..................309
▫ Brake System ....................... .310
▫ Appearance Care And Protection From
Corrosion .......................... .312
FUSES ............................. .319
▫ Interior Fuses ....................... .319
▫ Power Distribution Center #1 .............323
▫ Power Distribution Center (PDC) #2 ........325
VEHICLE STORAGE .....................326
REPLACEMENT BULBS .................327
BULB REPLACEMENT ..................328
▫ Headlamps Low Beam and High Beam ......328
▫ Front Turn Signal, Parking And Daytime
Running Lamps ...................... .328
▫ Front Fog Lamps ..................... .329
▫ Front/Rear Side Marker Lamps ............329
▫ Rear Tail, Stop, Backup And Turn Signal
Lamps ............................ .329
▫ Center High Mounted Stop Lamp (CHMSL) . . .330
FLUID CAPACITIES .....................331
FLUIDS, LUBES, AND GENUINE PARTS ......332
294 MAINTAINING YOUR VEHICLE
WARNING!(Continued)
•The air conditioning system contains refrigerant
under high pressure. To avoid risk of personal
injury or damage to the system, adding refrigerant
or any repair requiring lines to be disconnected
should be done by an experienced technician.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, decklid, sliding doors and hood hinges, should
be lubricated periodically with a lithium based grease,
such as MOPAR® Spray White Lube to assure quiet, easy
operation and to protect against rust and wear. Prior to
the application of any lubricant, the parts concerned
should be wiped clean to remove dust and grit; after
lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching components to ensure proper function. When performing
other underhood services, the hood latch, release mecha-
nism and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR®
Lock Cylinder Lubricant directly into the lock cylinder.
Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield and rear window periodically with a sponge
or soft cloth and a mild nonabrasive cleaner. This will
remove accumulations of salt, waxes, or road film, and
help reduce streaking and smearing.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield or rear window.
7
MAINTAINING YOUR VEHICLE 307
3. Grab the bottom of the wiper blade and rotate itforward to unsnap the blade pivot pin from the wiper
blade holder. 4. Install the wiper blade pivot pin into the wiper blade
holder at the end of the wiper arm, and firmly press
the wiper blade until it snaps into place.
5. Lower the wiper blade and snap the pivot cap into place.
Adding Washer Fluid
The windshield washer fluid reservoir is located in the
underhood compartment, and the fluid level should be
checked at regular intervals. Fill the reservoir with wind-
shield washer solvent (not coolant/ antifreeze). Refer to
“Underhood Compartment” in “Maintaining Your Ve-
hicle” for further information.
1—WiperBlade
2 — Blade Pivot Pin
3—WiperArm
4 — Wiper Blade Holder
7
MAINTAINING YOUR VEHICLE 309
