2014 FIAT 500 ABARTH side marker

▫Appearance Care And Protection From
Corrosion...........................338
!FUSES..............................345
▫Interior Fuses........................345
▫Underhood Fuses......................348
!VEHICLE STORAGE....................351
!REPLACEMENT BULBS.................351
!BULB REPLACEMENT..................352
▫Headlamps Low Beam and High Beam......353
▫Front Turn Signal, Parking And Daytime Running
Lamps.............................353
▫Front Fog Lamps......................354
▫Front/Rear Side Marker Lamps............354
▫Rear Tail, Stop, Backup And Turn Signal
Lamps.............................354
▫Center High Mounted Stop Lamp (CHMSL) . . .355
!FLUID CAPACITIES....................356
!FLUIDS, LUBRICANTS AND GENUINE PARTS . . .356
▫Engine.............................356
▫Chassis............................357
310 MAINTAINING YOUR VEHICLE

Exterior Bulbs
Bulb Number
Front Low and High
Beam Headlamp
HIR2
Front Parking/Daytime
Running Lamps
W21/5W
Front Fog Lamps H11
Front Side Marker Lamps W3W
Front Turn Signal Lamps WY21W
Side Direction Lamps W5W
Rear Turn Signal Lamps PY21W
Rear Side Marker Lamps W3W
Rear Tail and Stop
Lamps
PY21W/5W
Rear Backup Lamps W16W
Bulb Number
Center High Mounted
Stop Lamp
W5W
License Plate Lamps LED (See Authorized
dealer)
NOTE:Numbers refer to commercial bulb types that
can be purchased from your authorized dealer.
If a bulb needs to be replaced, visit your authorized
dealer or refer to the applicable Service Manual.
BULB REPLACEMENT
NOTE:Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
352 MAINTAINING YOUR VEHICLE

6. Install the bulb into socket, and rotate bulb/socket
clockwise into lamp locking it in place.
7. Reinstall the plastic cap.
Front Fog Lamps
To replace the front fog lights, see your authorized dealer.
Front/Rear Side Marker Lamps
1. Remove portion of the wheel liner to allow hand
access to side marker lamp.
2. Rotate the bulb socket counterclockwise, and remove
the bulb and socket assembly from the housing.
3. Pull the bulb from the socket and insert the replace-
ment bulb.
4. Install the bulb and socket assembly into the housing,
and rotate the socket clockwise to lock it in place.
5. Reinstall the wheel liner.
Rear Tail, Stop, Backup And Turn Signal Lamps
1. Open the liftgate.
2. Remove the two screws and remove the tail lamp
assembly.
Tail Lamp Assembly Screws
354 MAINTAINING YOUR VEHICLE