Page 4 of 328
CONTENTS
2
Monochrome screen A 49
Monochrome screen C 51
Colour screen 55
Trip computer 57
2 - MULTIFUNCTION
SCREENS 49 60
Ventilation 61
Manual air conditioning 63
Dual-zone digital air conditioning 65
Front demist - defrost 69
Rear screen demist - defrost 69
Front seats 70
Rear seats 74
Mirrors 75
Steering wheel adjustment 77
3 - COMFORT 61 77
Remote control key 78
Alarm 85
Doors 87
Boot 88
Electric windows 89
Panoramic sunroof 91
Fuel tank 92
Misfuel prevention (Diesel) 94
4 - ACCESS 78 94
Lighting controls 95Automatic illumination of headlamps 99
Welcome lighting 100
Headlamp adjustment 101
Directional lighting 102
Wiper controls 104
Automatic rain sensitive wipers 105
Courtesy lamps 107
Interior mood lighting 108
Boot lamp 108
5 - VISIBILITY 95 108
Interior fi ttings 109
Centre consoles 112
Front armrest 113
Boot fi ttings 117
6 - FITTINGS 109 11 9
Instrument panels 28
Rev counter 31
Warning and indicator lamps 32
Indicators 43
Time and units 46
Customisation 48
FAMILIARISATION 4 25
1 - MONITORING 28 48
Child seats 120
Deactivating the passenger's front
airbag 122
ISOFIX child seats 129
Child lock 133
7 - CHILD
SAFETY 120 133 ECO-DRIVING 26 27
Page 15 of 328
13
FAMILIARISATION
Front seats
Head restraint height and angle
Lumbar
Other functions available...
Lumbar massage.
Heated seats.
Steering wheel adjustment
Front armrest
73
1.
Release the adjustment mecha-
nism.
2.
Adjust for height and reach.
3.
Lock the adjustment mechanism.
77
For your comfort, the front armrest can
be adjusted for longitudinal position
and for height, depending on version.
It also has a storage compartment.
113, 114
72
As a safety precaution, these
operations must only be carried
out when stationary.
SITTING COMFORTABLY
Page 29 of 328
27
Switch off the headlamps and front
foglamps when the level of light does
not require their use.
Avoid running the engine before moving
off, particularly in winter; your vehicle
will warm up much faster while driving.
As a passenger, if you avoid connecting
your multimedia devices (fi lm, music,
video game...), you will contribute to-
wards limiting the consumption of elec-
trical energy, and so of fuel.
Disconnect your portable devices be-
fore leaving the vehicle.
Limit the causes of excess
consumption
Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.
At the end of winter, remove snow
tyres and refi t your summer tyres.
Observe the recommendations
on maintenance
Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.
Have your vehicle serviced regularly
(engine oil, oil fi lter, air fi lter...) and ob-
serve the schedule of operations rec-
ommended by the manufacturer.
When refuelling, do not continue after
the third cut-off of the nozzle to avoid
any overfl ow.
At the wheel of your new vehicle, it is only
after the fi rst 1 800 miles (3 000 kilometres)
that you will see the fuel consumption set-
tle down to a consistent average.
Page 72 of 328
3
COMFORT
70
FRONT SEATS
Seat consisting of a seat cushion, a
seat back and a head restraint which
can all be adjusted to adapt your posi-
tion for ease of driving and comfort.
Manual adjustments
Forwards-backwards
Driver's or passenger's seat height
Seat backrest angle
Raise the control and slide the seat
forwards or backwards.
Pull the control upwards to raise
or push it downwards to lower, as
many times as necessary, to obtain
the position required.
Turn the control knob to adjust the
seat backrest angle.
As a safety measure, seat adjustments should only be done when stationary.
Page 73 of 328
3
COMFORT
71
FRONT SEATS
Seat consisting of a seat cushion, a
seat backrest and a head restraint
which can all be adjusted to adapt your
position for ease of driving and comfort.
Driver's seat electric
adjustments
The electrical functions of the driver's seat are deactivated approximately
one minute after the ignition is switched off.
To reactivate them, switch on the ignition.
Push the control forwards or rear-
wards to slide the seat.
Forwards-backwards
Tilt the rear part of the control up-
wards or downwards to obtain the
required height.
Tilt the front part of the control up-
wards or downwards to obtain the
required angle.
Cushion height and angle
Tilt the control forwards or rear-
wards to adjust the angle of the seat
backrest.
Seat backrest angle
Page 74 of 328
3
COMFORT
72
Additional adjustments
Head restraint height and angle
To raise a head restraint, pull it up-
wards.
To lower the head restraint, press
the lug A
and the head restraint at
the same time.
To adjust the angle of the head re-
straint, tilt its lower part forwards or
rearwards.
The head restraint is fi tted with
a frame with notches which pre-
vents it from lowering; this is a
safety device in case of impact.
The adjustment is correct
when the upper edge of the
head restraint is level with the
top of the head.
With the engine running, the front seats
can be heated separately.
Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:
0:
Off.
1
:
Low.
2
:
Medium.
3
:
High.
Heated seats control
Removing a head restraint
To remove the head restraint, press
the lug A
and pull the head restraint
upwards.
To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back and press
the lug A
at the same time.
Never drive with the head re-
straints removed; they must be
in place and adjusted correctly.
Page 76 of 328
3
COMFORT
74
REAR SEATS
Bench seat with fi xed one-piece cush-
ion and split backrest (left hand 2/3, right
hand 1/3) which can be folded individually
to adapt the load space in the boot.
Rear head restraints
These have one position for use (up)
and a stowed position (down).
They can also be removed.
To remove a head restraint:
release the backrest using control 1
,
tilt the backrest 2
slightly forwards,
pull the head restraint upwards to
the stop,
then, press the lug A
.
Never drive with the head re-
straints removed; they must be
in place and correctly adjusted. When repositioning the seat
backrest, take care not to trap
the seat belts.
Folding the backrest
Move the corresponding front seat
forward if necessary.
Position the seat belt between the
outer and centre head restraints to
avoid trapping the belt when reposi-
tioning the seat backrest.
Place the head restraints in the low
position.
Pull control 1
forwards to release
the seat back 2
.
Fold the seat back 2
on to the cushion.
Repositioning the seat backrest
Straighten the seat back 2
and se-
cure it.
Check that the red indicator, located
next to the control 1
, is no longer
visible.
Put the seat belt back in place on
the side of the seat backrest.
Page 90 of 328
4
ACCESS
88
BOOT
Opening
After unlocking the boot or the ve-
hicle using the remote control or the
key, press the opening control, then
raise the tailgate.
Closing
Lower the tailgate using the interior
grab handle.
If necessary, press down on the tail-
gate to fully close it.
Tailgate release
System allowing the mechanical unlock-
ing of the boot in the event of a battery or
central locking system malfunction.
Unlocking
Fold back the rear seats to gain
access to the lock from inside the
boot.
Insert a small screwdriver into hole A
of the lock to unlock the tailgate.
Move the latch to the left.
If the tailgate is not closed correctly:
- when the engine is running
,
this warning lamp comes on,
accompanied by the display
of an alert message for a few
seconds,
- when the vehicle is moving
(speed
above 6 mph (10 km/h)), this warn-
ing lamp comes on, accompanied by
an audible signal and the display of
an alert message for a few seconds.
Locking after closing
If the fault persists after closing again,
the boot will remain locked.
