2014 Citroen C4 RHD phone

mirror controls battery capacity fuel pump fold seats roof rack lights

Page 212 of 328

Citroen C4 RHD 2014 2.G Owners Manual 11
PRACTICAL INFORMATION
210

LOAD REDUCTION MODE

System which manages the use of cer-
tain functions according to the level of
charge remaining in the battery.

When the vehic

11
PRACTICAL INFORMATION
210

LOAD REDUCTION MODE

System which manages the use of cer-
tain functions according to the level of
charge remaining in the battery.

When the vehicle is being driven, the
load reduction function temporarily de-
activates certain functions, such as the
air conditioning, the heated rear screen...
The deactivated functions are reactivat-
ed automatically as soon as conditions
permit.

ENERGY ECONOMY MODE

System which manages the period of
use of certain functions to conserve a
sufﬁ cient level of charge in the battery.
After the engine has stopped, you can
still use functions such as the audio
equipment, windscreen wipers, dipped
beam headlamps, courtesy lamps, etc.
for a maximum combined period of thirty
minutes.

Switching to economy mode

Once this period has elapsed, a message
appears in the screen indicating that the
vehicle has switched to economy mode
and the active functions are put on standby.
If the telephone is being used at
the same time on the navigation
system, it will be interrupted after
10 minutes.
A ﬂ at battery prevents the en-
gine from starting (refer to the
corresponding paragraph).

Exiting economy mode

These functions are reactivated auto-
matically the next time the vehicle is
driven.


In order to resume the use of these
functions immediately, start the engine
and let it run for a few minutes.
The time available to you will then be
double the period for which the engine
is left running. However, this period will
always be between ﬁ ve and thirty minutes.

This period may be greatly re-
duced if the battery is not fully
charged.

CHANGING A WIPER BLADE

Before removing a front wiper
blade


Within one minute after switching
off the ignition, operate the wiper
stalk to position the wiper blades
vertically on the windscreen.

Removing


Raise the corresponding wiper arm.


Unclip the wiper blade and remove it.

Fitting


Put the corresponding new wiper
blade in place and clip it.


Fold down the wiper arm carefully.

After fitting a front wiper blade


Switch on the ignition.


Operate the wiper stalk again to
park the wiper blades.