2014 Citroen C4 CACTUS run flat

.
.
E3_en_Chap00a_sommaire_ed01-2014
Direction indicators 129
Hazard warning lamps
1
29
H or n


13 0
Emergency or assistance call

1
30
Tyre under-inflation detection

1
31
ESC system

1
34
Seat belts
1

37
Airbags


140
Safety
Child seats 1 46
Deactivating the passenger's
front airbag

1
49
ISOFIX child seats

1
55
i-Size child seats

1
58
Child lock

1
60
Child safety
Checks
Fuel tank 161
Misfuel prevention (Diesel)
1
63
Running out of fuel (Diesel)

1
65
AdBlue
® additive and SCR system
(Blue HDi Diesel) 1 66
Temporary puncture repair kit
1

74
Changing a wheel
1

81
Snow chains

1
87
Changing a bulb
1

88
Changing a fuse
1

96
12 V battery

2
03
Energy economy mode
20

7
Changing a wiper blade
2

08
To w i n g
2

0 9
Towing a trailer

2
11
Roof bars

2
13
Very cold climate screens

2
15
AIRBUMP
® protectors 2 16
Accessories

217
Practical information Technical data
Emergency or assistance 235
Touch screen tablet
2
37
Audio and telematics
Visual search
Alphabetical index
Bonnet 220
Petrol engines
2
21
Diesel engines
2

22
Checking levels
2

23
Checks


226Petrol engines

2
28
Petrol weights
2
29
Diesel engines
2
30
Diesel weights
23
1
Dimensions

232
Identification markings
2
33
Contents

178
E3_en_Chap09_info_pratiques_ed01-2014
2. InflationF Turn the selector A to the "air" position.
F

U
ncoil the black pipe H fully.
F

C
onnect the black pipe to the
valve of the wheel. F
C onnect the compressor's electric plug to
the vehicle's 12 V socket.
F

S
tart the vehicle again and leave the
engine running.
As soon as possible, go to a CITROËN
dealer or a qualified workshop.
You must inform the technician that you
have used this kit. After inspection, the
technician will advise you on whether
the tyre can be repaired or if it must be
replaced. F
A djust the pressure using the compressor
(to inflate: switch B in position "I" ; to
deflate: switch B
in position "O" and press
button C ), in accordance with the vehicle's
tyre pressure label (located on the left
hand door aperture).
A l

oss of pressure indicates that the
puncture has not been fully plugged;
contact a CITROËN dealer or qualified
workshop for assistance.
F

R
emove and stow the kit.
F

D
rive at reduced speed (50 mph [80 km/h]
max) limiting the distance travelled to
approximately 120 miles (200 km).
Practical information

180
E3_en_Chap09_info_pratiques_ed01-2014
Checking tyre pressures /
inflating accessories
You can also use the compressor, without
injecting any product, to:
-
c
heck or adjust the pressure of your tyres,
-

i
nflate other accessories (balls, bicycle
tyres...).
F

T
urn the selector A to the "Air"
position.
F

U
ncoil the black pipe H fully. F
C onnect the compressor's electrical
connector to the vehicle's 12 V socket.
F

S
tart the vehicle and let the engine run.
F

A
djust the pressure using the compressor
(to inflate: switch B in position "I" ; to
deflate: switch B in position "O" and press
button C ), according to the vehicle's tyre
pressure label or the accessory's pressure
label.
F

R
emove the kit then stow it.Should the pressure of one or more
tyres be adjusted, it is necessary to
reinitialise the under-inflation detection
system.
Refer to the "Under-inflation detection"
section.
F

C
onnect the black pipe to the valve of the
wheel or accessory.
I

f necessary, fit one of the adaptors
supplied with the kit first.
Practical information

187
E3_en_Chap09_info_pratiques_ed01-2014
Snow chains
In wintry conditions, snow chains improve traction as well as the behaviour of the vehicle when
braking.Use only the chains designed to be fitted to the
type of wheel fitted to your vehicle:
Original tyre size Maximum

link size.
195/65 R15 9 mm
205/55 R16
205/50 R17
cannot be fitted with chains
For more information on snow chains, contact a
CITROËN dealer or a qualified workshop.
Advice on installation
F If you have to fit the chains during a journey, stop the vehicle on a flat sur face
on the side of the road.
F

A
pply the parking brake and position any
wheel chocks to prevent movement of
your vehicle.
F

F
it the chains following the instructions
provided by the manufacturer.
F

M
ove off gently and drive for a few
moments, without exceeding 30 mph
(50 km/h).
F

S
top your vehicle and check that the snow
chains are correctly tightened.
Take account of the legislation in force
in your country on the use of snow
chains and the maximum running speed
authorised.
The snow chains must be fitted only
to the front wheels. They must never
be fitted to "space-saver" type spare
wheels.
Avoid driving with snow chains on roads
that have been cleared of snow, to
avoid damaging your vehicle's tyres and
the road sur face. It is recommended
that before you leave, you practise
fitting the snow chains on a level and
dry sur face. If your vehicle is fitted with
alloy wheels, check that no part of the
chain or its fixings is in contact with the
wheel rim.
9
Practical information

205
E3_en_Chap09_info_pratiques_ed01-2014
When your vehicle's battery is discharged, the
engine can be started using a slave battery
(external or on another vehicle) and jump lead
cables.
Starting using another
battery
F Operate the starter on the broken down vehicle and let the engine run.
I

f the engine does not start straight away,
switch off the ignition and wait a few
moments before trying again.
F

W
ait until the engine returns to idle then
disconnect the jump lead cables in the
reverse order.
F

R
efit the plastic cover to the (+) terminal, if
your vehicle has one.
F

R

emove the plastic cover from the (+)
terminal, if your vehicle has one.
F

C

onnect the red cable to the positive
terminal (+) of the flat battery A , then to the
positive terminal (+) of the slave battery B.
F
C
onnect one end of the green or black
cable to the negative terminal (-) of the
slave battery B (or earth point on the other
vehicle).
F

C

onnect the other end of the green or black
cable to the earth point C on the broken
down vehicle (or on the engine mounting).
F

S

tart the engine of the vehicle with the good
battery and leave it running for a few minutes. First check that the slave battery has a
nominal voltage of 12 V and a capacity
at least equal to that of the discharged
battery.
Do not try to start the engine by
connecting a battery charger.
Do not disconnect the (+) terminal when
the engine is running.
Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before
disconnecting the battery.
Following reconnection of the
battery
Following reconnection of the battery, switch on
the ignition and wait 1 minute before starting to
permit initialisation of the electronic systems.
However, if problems remain following this
operation, contact a CITROËN dealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise (depending on
version):
-

t
he remote control key,
-


...
9
Practical information

207
E3_en_Chap09_info_pratiques_ed01-2014
Load reduction mode
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air conditioning,
the heated rear screen...
The deactivated functions are reactivated
automatically as soon as conditions permit.System which manages the duration of use of
certain functions to conserve a sufficient level
of charge in the battery.
After the engine has stopped, you can still use
functions such as the audio and telematics
system,
windscreen wipers, dipped beam
headlamps,
courtesy lamps, etc. for a
maximum combined duration of about
forty minutes.
Energy economy mode
Switching to economy mode
A message then appears in the instrument
panel screen indicating that the vehicle has
switched to economy mode and the active
functions are put on standby.
If a telephone call is being made at this time,
it will be maintained for around 10 minutes
with the Bluetooth hands-free system of your
audio system.
Exiting economy mode
These functions are reactivated automatically
next time the vehicle is driven.
In order to restore the use of these functions
immediately, start the engine and let it run:
-

f
or less than ten minutes, to use the
equipment for approximately five minutes,
-

f
or more than ten minutes, to use the
equipment for up to approximately
thirty minutes.
Let the engine run for the duration specified to
ensure that the battery charge is sufficient.
Do not repeatedly and continuously restart the
engine in order to charge the battery.
A flat battery prevents the engine from starting
(refer to the "Battery" section).
9
Practical information

E3_en_Chap13_recherche_visuelle_ed01-2014
Remote control key 47-50
- l ocking / unlocking
the vehicle
-

l
ocating the vehicle
-
a

nti-theft protection
-


battery
Exterior
Door mirrors 6 2
Lighting control stalk
1
13 -119
Guide-me-home lighting
1
19
Daytime running lamps
1
18
Headlamp beam adjustment
1
20
Cornering lighting
1
21
Changing bulbs
1
88-192
-
f
ront lamps
-

foglamps
-
d
irection indicator repeaters
Doors
5
2-53
-
ope

ning / closing
-
em

ergency control
Central locking

5
1Glass panoramic sunroof
1

26
Roof bars
21
3 -214
Accessories

217-218
Wiper control stalk
1
22-125
Changing a wiper blade
1
25, 208
Boot

54
-
ope
ning / closing
-
em
ergency release
Park Assist
1
08 -112
Reversing camera
1
07
Parking sensors
1
05-106
Towbar

211-212
To w i n g

2 0 9 - 2 10
Changing bulbs
1
93-194
- r ear lamps
- 3rd brake lamp
-
n
umber plate lamps
Fuel tank, misfuel prevention (Diesel)
16

1-16 4
Running out of Diesel fuel

1
65
Electronic stability
programme


134
ESC: ABS, EBFD, ASR, DSC

1

34-136
Under-inflation detection
1

31-133
Tyre pressures
2

33
Temporary puncture repair k i t


174 -18 0
Changing a wheel
1

81-186
-

tools
-

r

emoving / refitting
Snow chains

1

87
AIRBUMP
® protectors 2
16
Visual search