2014 Alfa Romeo 4C washer fluid

GRAPHICAL INDEX
.
HEADLIGHTS
❒Bulb types ..........................................120
❒ Daytime running lights ......................... 27
❒ Side lights/dipped headlights .............. 27
❒ Main beam headlights ......................... 27
❒ Bulb replacement ................................118
WHEELS
❒Rims and tyres ....................................163
❒ Tyre pressure ......................................166
❒ Wheel repair .......................................115
DOOR MIRRORS
❒Adjustment ......................................... 18
❒ Folding ............................................... 18
DOORS
❒Central opening/closing ...................... 36
SCREEN WASHER / BRAKE FLUID
❒Checking levels ...................................139
WINDSCREEN WIPERS
❒Operation ........................................... 28
❒ Blade replacement ..............................148
TOW HOOK
❒Attachment .........................................130
1
A0L0120
5
24-9-2013 11:49 Pagina 5

Thousands of kilometres20 40 60 80 100 120
Months 12 24 36 48 60 72
Check condition and wear of rear brake pads and discs, and
operation of pad wear indicator ●●●●●●
Check and, if necessary, top-up fluid levels (engine cooling,
brakes, windscreen washer, etc.) ●●●●●●
Visually inspect condition of the accessory drive belt(s) ●
Inspect the conditions of toothed timing drive belt ●
Check handbrake lever travel and adjust, if necessary (or every 12
months) ●●●●●●
Check exhaust emissions/smokiness ●●●
Check engine control system operation (through diagnosis socket) ●●●●●●
Check and possible top up of oil level for the dual clutch
automatic transmission ●
Replace spark plugs (#) ●●
Replace accessory drive belt(s) ●
Replace toothed timing drive belt (*) ●(#) The following are essential to ensure correct operation and prevent serious damage to the engine: only use spark plugs of the same make and type which are
specially certified for such engines (see the information in the “Engine” paragraph in the “Technical specifications” section); strictly comply with the spark plug
replacement interval given in the Scheduled Servicing Plan; for spark plug replacement, it is advisable to contact the dedicated Alfa Romeo Dealership.
(*) Irrespective of the mileage, the timing drive belt must be changed every 4 years for heavy-duty use (cold climates, town use, long periods of idling) or at least every 5 years.
136
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 136

PERIODIC CHECKSEvery 1,000 km or before long
journeys, check and, if necessary, top
up the following:
❒engine coolant level;
❒ brake fluid;
❒ screen washer fluid;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlamps, direction indicators,
hazard warning lights, etc.);
❒ operation of screen washing/wiping
system and positioning/wear of
wiper blade.
Every 3,000 km, check and top up if
required: engine oil level.
HEAVY-DUTY USE OF
THE CARIf the car is used mainly under one of
the following conditions:
❒ if the car is used under demanding
conditions, e.g. on track;
❒ dusty roads;
❒ short, repeated journeys (less than
7–8 km) at sub-zero outside
temperatures;
❒ engine often idling or driving long
distances at low speeds or long
periods of inactivity;
the following checks must be carried
out more often than indicated in the
Scheduled Servicing Plan:
❒ check of front and rear disc brake
pad condition and wear;
❒ check cleanliness of tailgate locks,
cleanliness and lubrication of linkage;
❒ visually inspect conditions of: engine,
gearbox, transmission, pipes and
hoses (exhaust - fuel system -
brakes) and rubber elements (boots -
sleeves - bushes - etc.);
❒ check battery charge and battery
fluid level (electrolyte);
❒ visually inspect condition of the
accessory drive belts; ❒
check and, if necessary, change
engine oil and replace oil filter;
❒ check and, if necessary, replace air
cleaner.
Using the car on track should be
regarded as an exception. The car has
been designed and produced for road
use.
138
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 138

The plugs for topping the brake fluid and the windscreen washer fluid are located between the bonnet and the windscreen, by
respectively removing the suitable panel D and the suitable protection grid E; to top up, use the suitable kit supplied as
standard (see descriptions below).
19)111
A0L0153
140
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 140

ENGINE OIL
Check that the oil level is between the
MIN and MAX marks on the dipstick
A fig. 110.
For this check, take out the dipstick
from its seat, clean it with a lint-free
cloth, reinsert the dipstick; take it out
again and check the oil level.
116)
If the oil level is near or under the MIN
mark, add oil through the filler B fig.
110 until it reaches the MAX mark.
20)
Take out the engine oil dipstick A, clean
it with a lint-free cloth and reinsert it.
Extract the engine oil dipstick again and
check that the level is between the
MIN and MAX marks on the dipstick.
116)
The range between the MIN and MAX
levels corresponds to approximately
1 litre of oil.
Engine oil consumption
21)
3)
The maximum engine oil consumption
is usually 400 grams every 1,000 km.
When the car is new, the engine needs
to run in, therefore the engine oil
consumption can only be considered
stabilised after the first 5,000 - 6,000
km.IMPORTANT After adding or changing
the oil, let the engine run for a few
seconds and wait a few minutes after
stopping it before you check the level.
ENGINE COOLANT
22)
117)
The coolant level must be checked
when the engine is cold and must
range between the MIN and MAX
marks on the reservoir.
If the level is too low, unscrew reservoir
plug C fig. 110 and add the fluid
described in the "Fluids and lubricants"
paragraph of the "Technical
Specifications" chapter.
WINDSCREEN WASHER
FLUID
118) 119)
To check the windscreen washer fluid
level, proceed as follows:
❒
to avoid any interference during the
procedure, lift the windscreen wiper
blade according to the "Windscreen
wiper" paragraph in the
"Maintenance and care" chapter;
❒ loosen the 4 self-tapping screws A
fig. 112 using the supplied
screwdriver. Remove the bonnet
grille;
❒ release the plug from the opening; ❒
leaving the plug close to the opening,
put a finger on the central hole B fig.
113 in the plug and remove it: the
level can be seen on the control pipe
C fig. 114 due to capillarity;
❒ after the check, reinsert the plug B
with the control pipe C in the initial
position;
❒ reposition the bonnet grille and
tighten the 4 self-tapping screws A.
WARNING Re-close the plug holding it
horizontally (not directed towards the
bonnet) to prevent the opening tang
from remaining locked in a position
difficult to reach.
It is recommended to check the
windscreen washer fluid regularly, in
particular in driving conditions needing
a heavier use of the windscreen washer.
112
A0L0130
141
24-9-2013 11:50 Pagina 141

If the level is not sufficient, namely if
there is no fluid inside the pipe, proceed
as follows:
❒to avoid any interference during the
procedure, lift the windscreen wiper
blade according to the "Windscreen
wiper" paragraph in the
"Maintenance and care" chapter;
❒ loosen the 4 self-tapping screws A
fig. 112 using the supplied
screwdriver. Remove the bonnet
grille;
❒ take the white funnel D fig. 115 for
topping up the windscreen washer
fluid/fuel and its extension pipe from
the service kit in the luggage
compartment;
❒ take out the plug B fig. 113 with the
fluid control pipe through the bonnet
opening on the grille;
❒ introduce the funnel D fig. 115 and its
extension pipe in the reservoir neck
and top up;
❒ after topping up, remove the funnel D
with the extension pipe;
❒ refit the plug B with the dipstick;
❒ reposition the bonnet grille and
tighten the 4 self-tapping screws A. BRAKE FLUID
120) 121)23) 24)
To check the brake fluid level, proceed
as follows:
❒
loosen the 2 self-tapping screws E
fig. 116 and remove the protection
panel;
❒ check that the fluid is at the max.
level.
❒ after checking, reposition the
protection panel and tighten the 2
self-tapping screws E.
If the fluid level in the reservoir is not
sufficient, proceed as follows:
❒ take the black funnel for topping up
the brake fluid and its extension
pipe from the service kit in the
luggage compartment;
113
A0L0131
114
A0L0147
115
A0L0148
142
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 142

WARNING
113) The Alfa Romeo 4C is designedand produced for road use, in
compliance with the current
regulations. Vehicle use in the
track must be considered as
occasional and in any case under
the responsibility of the user.
The vehicle CANNOT be modified
or tampered with for any reason,
this would alter the Manufacturer
homologation and/or safety
requirements. Using a modified or
tampered product relieves the
Manufacturer from any
responsibility on it and may
expose people to serious risks.
114) Never smoke when performing operations in the engine
compartment. Flammable gases
and fumes may be present, with
the risk of fire.
115) Be very careful when working in the engine compartment if the
engine is hot: risk of burns. 116) If the engine oil is being topped
up, wait for the engine to cool
down before loosening the filler
plug, particularly for cars with
aluminium plug (for versions/
markets, where provided).
WARNING: risk of burns!
117) The cooling system is pressurised. If necessary, only
replace the plug with another
original one or the operation of
the system may be adversely
affected. Do not remove the
reservoir plug when the engine is
hot: risk of burns.
118) Do not travel with the windscreen washer reservoir
empty: the windscreen washer is
essential for improving visibility.
Repeated operation of the system
without fluid could damage or
cause rapid deterioration of some
system components.
119) Certain commercial additives for windscreen washer fluids are
inflammable. The engine
compartment contains hot
components which may set it on
fire. 120) Brake fluid is poisonous and
highly corrosive. In the event of
accidental contact, immediately
wash the affected parts with
water and mild soap. Then rinse
thoroughly. Call a doctor
immediately if swallowed.
121) The
symbol on the container
indicates a synthetic brake fluid,
which is different from a mineral
fluid. Using a mineral fluid will
damage the special rubber seals
of the braking system beyond
repair.IMPORTANT
3) Used engine oil and oil filters contain substances which are
harmful to the environment. You
are advised to go to a dedicated
Alfa Romeo Dealership to have
the oil and filters changed.
144
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 144

NOZZLES
Screen washer
The windscreen washer nozzles are
adjustable fig. 122. They are originally
adjusted at the factory. Should it be
necessary to adjust them again,
contact a dedicated Alfa Romeo
Dealership.
If there is no jet of fluid, firstly check
that there is some fluid in the reservoir
(see paragraph "Checking fluid levels"
in this chapter).
Then check that the nozzle holes are
not clogged; use a needle to unblock
them if necessary.
WARNING
131) Driving with a worn wiper bladeis a serious hazard, because
visibility is reduced in bad
weather.
IMPORTANT
26) Do not operate the screen wiperwith the blades lifted from the
windscreen.
BODYWORKPROTECTION AGAINST
ATMOSPHERIC AGENTS
The car features advanced
technological solutions for effective
protection of the exterior bodywork and
structure.
The best products and best painting
systems lend the exterior bodywork
particularly high resistance to
atmospheric agents (solar radiation,
acid rain, etc.) and gravel, through
specific protections.
The chassis too, in light, corrosion-
resistant alloy, is treated to prevent the
formation of surface oxidation.
CAR CORROSION
WARRANTY
Your car is covered by warranty against
perforation, due to rust, of any original
element of the structure. For the
general terms of this warranty, refer to
the Warranty Booklet.
122
A0L0087
149
24-9-2013 11:50 Pagina 149