If the level is not sufficient, namely if
there is no fluid inside the pipe, proceed
as follows:
❒to avoid any interference during the
procedure, lift the windscreen wiper
blade according to the "Windscreen
wiper" paragraph in the
"Maintenance and care" chapter;
❒ loosen the 4 self-tapping screws A
fig. 112 using the supplied
screwdriver. Remove the bonnet
grille;
❒ take the white funnel D fig. 115 for
topping up the windscreen washer
fluid/fuel and its extension pipe from
the service kit in the luggage
compartment;
❒ take out the plug B fig. 113 with the
fluid control pipe through the bonnet
opening on the grille;
❒ introduce the funnel D fig. 115 and its
extension pipe in the reservoir neck
and top up;
❒ after topping up, remove the funnel D
with the extension pipe;
❒ refit the plug B with the dipstick;
❒ reposition the bonnet grille and
tighten the 4 self-tapping screws A. BRAKE FLUID
120) 121)23) 24)
To check the brake fluid level, proceed
as follows:
❒
loosen the 2 self-tapping screws E
fig. 116 and remove the protection
panel;
❒ check that the fluid is at the max.
level.
❒ after checking, reposition the
protection panel and tighten the 2
self-tapping screws E.
If the fluid level in the reservoir is not
sufficient, proceed as follows:
❒ take the black funnel for topping up
the brake fluid and its extension
pipe from the service kit in the
luggage compartment;
113
A0L0131
114
A0L0147
115
A0L0148
142
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 142
❒loosen the reservoir plug and
introduce the funnel F fig. 117 with
the extension pipe in the reservoir
inlet;
❒ after topping up, remove the funnel F
with the extension pipe;
❒ tighten the reservoir plug;
❒ reposition the protection panel and
tighten the 2 self-tapping screws E.
WARNING Be very careful while
removing the plug from the opening to
prevent the plug from falling inside
the vehicle body.
IMPORTANT
19) Be careful not to confuse the various types of fluids while
topping up: they are not
compatible with each other!
Topping up with an unsuitable
fluid could severely damage your
vehicle.
20) The oil level should never exceed the MAX mark.
21) Do not add oil with specifications other than those of the oil already
in the engine. 22) PARAFLU
UP
anti-freeze fluid is
used in the engine cooling
system; use the same fluid type as
that already in the cooling system
when topping up. PARAFLU
UP
may not be mixed with other types
of anti-freeze fluids. If topping up
with an unsuitable product, under
no circumstances start the engine
and contact a dedicated Alfa
Romeo Dealership.
23) Avoid allowing brake fluid, which is extremely corrosive, to come
into contact with painted areas.
Should it happen, immediately
wash with water.
24) Be very careful while topping up the brake fluid, as it could drip
from the extension pipe inside the
vehicle under-bonnet and on
parts of the body and windscreen,
corroding and damaging them.
Adopt suitable protection (e.g
absorbing paper) to reduce this
risk as much as possible.
116
A0L0149
117
A0L0160
143
24-9-2013 11:50 Pagina 143
WARNING
113) The Alfa Romeo 4C is designedand produced for road use, in
compliance with the current
regulations. Vehicle use in the
track must be considered as
occasional and in any case under
the responsibility of the user.
The vehicle CANNOT be modified
or tampered with for any reason,
this would alter the Manufacturer
homologation and/or safety
requirements. Using a modified or
tampered product relieves the
Manufacturer from any
responsibility on it and may
expose people to serious risks.
114) Never smoke when performing operations in the engine
compartment. Flammable gases
and fumes may be present, with
the risk of fire.
115) Be very careful when working in the engine compartment if the
engine is hot: risk of burns. 116) If the engine oil is being topped
up, wait for the engine to cool
down before loosening the filler
plug, particularly for cars with
aluminium plug (for versions/
markets, where provided).
WARNING: risk of burns!
117) The cooling system is pressurised. If necessary, only
replace the plug with another
original one or the operation of
the system may be adversely
affected. Do not remove the
reservoir plug when the engine is
hot: risk of burns.
118) Do not travel with the windscreen washer reservoir
empty: the windscreen washer is
essential for improving visibility.
Repeated operation of the system
without fluid could damage or
cause rapid deterioration of some
system components.
119) Certain commercial additives for windscreen washer fluids are
inflammable. The engine
compartment contains hot
components which may set it on
fire. 120) Brake fluid is poisonous and
highly corrosive. In the event of
accidental contact, immediately
wash the affected parts with
water and mild soap. Then rinse
thoroughly. Call a doctor
immediately if swallowed.
121) The
symbol on the container
indicates a synthetic brake fluid,
which is different from a mineral
fluid. Using a mineral fluid will
damage the special rubber seals
of the braking system beyond
repair.IMPORTANT
3) Used engine oil and oil filters contain substances which are
harmful to the environment. You
are advised to go to a dedicated
Alfa Romeo Dealership to have
the oil and filters changed.
144
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 144
TECHNICAL SPECIFICATIONS
Everything you may find useful for
understanding how your car is made
and works is contained in this chapter
and illustrated with data, tables and
graphics. For the enthusiasts and the
technician, but also just for those who
want to know every detail of their
car.IDENTIFICATION DATA....................154
ENGINE CODES - BODY
VERSIONS ......................................156
ENGINE ..........................................157
FUEL SUPPLY .................................158
TRANSMISSION .............................159
BRAKES .........................................160
SUSPENSION .................................161
STEERING ......................................162
WHEELS .........................................163
DIMENSIONS ..................................167
PERFORMANCE .............................168
WEIGHTS .......................................169
REFUELLING ..................................170
FLUIDS AND LUBRICANTS ............171
FUEL CONSUMPTION ....................174
CO2 EMISSIONS ............................175
PRESCRIPTIONS FOR HANDLING
THE VEHICLE AT THE END OF ITS
LIFE ................................................176
153
24-9-2013 11:50 Pagina 153
WEIGHTSVersions1750 Turbo Petrol
Unladen weight (with all fluids, fuel tank
90% full and without optional equipment): 920
Payload including the driver: (*) 255
Maximum permitted loads (**)
– front axle: 490
– rear axle: 755
– total: 1175
Towable loads (kg)
- braked trailer: 0
- non-braked trailer: 0
Maximum load on roof: 0
Maximum load on ball joint (braked trailer): 0(*) If special equipment is fitted, the unladen vehicle weight increases, thus reducing the specified payload.
(**) Loads not to be exceeded. The user is responsible for arranging goods in the luggage compartment within the maximum permitted loads.
169
24-9-2013 11:50 Pagina 169
REFUELLING
1750 Turbo PetrolPrescribed fuels / Original fluids
and lubricants
litres kg
Fuel tank 40-
Unleaded petrol not less than 95
RON (EN 228 specification)
including a reserve of 4 - 5-
Engine cooling system 10.69.4Mixture of 50% demineralised water
and 50% PARAFLU
UP
(*)
Engine sump 5.44.6
SELENIA SPORT POWER
Engine sump and filter 5.85.0
Transmission/differential casing: 1.881.6TUTELA TRANSMISSION
GEARTECH
Transmission hydraulic activation system 1.45 1.2 TUTELA CS SPEED
Hydraulic brake circuit with ABS 0.520.56 TUTELA TOP 4
Windscreen washer fluid reservoir 1.91.7Mixture of water and TUTELA
PROFESSIONAL SC 35
(*) When the vehicle is used in particularly harsh weather conditions, we recommend using a 60-40 mixture of PARAFLU
UPand demineralised water.
170
TECHNICAL SPECIFICATIONS
24-9-2013 11:50 Pagina 170
UseFluid and lubricant specifications for a correct
use of the car Genuine fluids and
lubricants Applications
Lubricants and
greases for drive
transmission SAE 75W 85 grade synthetic lubricant
FIAT 9.55550-MZ3 classification.
TUTELA
TRANSMISSION
GEARTECH
Contractual Technical
Reference No. F704.C08TCT automatic
transmission
Specific fluid for electro-hydraulic ratio selector
actuators
FIAT 9.55550-SA1 classification TUTELA CS SPEED
Contractual Technical
Reference No. F005.F98
Lubricant for electro-
hydraulic actuator
Molybdenum disulphide grease, for use at high
temperatures. NL.G.I. 1-2 consistency
FIAT 9.55580 classification TUTELA ALL STAR
Contractual Technical
Reference No. F702.G07
Wheel side constant
velocity joints
Grease for constant velocity joints with low friction
coefficient. NL.G.I. 0-1 consistency
FIAT 9.55580 classification TUTELA STAR 700
Contractual Technical
Reference No. F701.C07
Differential side
constant velocity joints
Brake fluid Synthetic fluid for brake and clutch systems.
Exceeds specifications: FMVSS no. 116 DOT 4,
ISO 4925, SAE J1704.
FIAT 9.55597 classification TUTELA TOP 4
Contractual Technical
Reference No. F001.A93
Hydraulic brakes and
hydraulic clutch
controls
172
TECHNICAL SPECIFICATIONS
24-9-2013 11:50 Pagina 172
INDEX
ABS .............................................. 42
– System intervention ................... 42
Air cleaner ...................................... 145
Alarm ............................................. 13"Alfa DNA" system ........................ 45
– "All Weather" mode ................... 47
– Driving modes ........................... 46
– “Dynamic” mode ....................... 46
– "Natural" mode.......................... 46
– “Race” mode............................. 46Alfa Romeo Code system ............. 10
Ashtray .......................................... 35
ASR system (AntiSlip Regulation) ... 42Backrest pocket ........................... 35
Battery ........................................... 145 – advice for extending lifetime ...... 145
– replacement .............................. 145
Battery (recharging) ........................ 129
Body versions ................................ 156
Bodywork – body codes ............................... 156
– maintenance ............................. 150
– protection against atmospheric agents................... 149
– warranty .................................... 149
Bonnet – Closing ...................................... 39 – Opening .................................... 38
Brakes ........................................... 160 – brake fluid level.......................... 142
bulb replacement.................... 123-124
Bulb replacement – exterior lights ............................. 122
– interior lights .............................. 125
Bulbs
– types of bulbs ........................... 120
Car inactivity ................................. 111
Carrying children safely .................. 93
CBC (Cornering Brake Control) system ......................................... 42
Central locking ............................... 32
Changing a bulb............................. 118 – General instructions................... 118
Cigar lighter.................................... 34
Cleaning and maintenance – bodywork .................................. 149
– car interior ................................. 151
– engine compartment ................. 150
– front headlights ......................... 150
– leather parts .............................. 152
– leather seats.............................. 151
– plastic and coated parts ............ 152
– seats and fabric parts ................ 151
– windows.................................... 150
Climate control ............................... 19 – Passenger compartment air diffusers .................................... 20 Climatic comfort ............................. 20
Clutch ............................................ 159
CO2 emissions............................... 175
Conditions of use ........................... 110
Control buttons .............................. 62
Control panel and instruments ....... 60
Controls ......................................... 32
Cruise Control ................................ 29
Cup holder ..................................... 35
Daytime running lights (DRL) ......... 27
Dimensions .................................... 167
Dipped beam headlights – bulb replacement ...................... 122
Direction indicators ........................ 27 – bulb replacement ...................... 122
– “Lane change” function ............. 27
Door mirrors – Door mirrors .............................. 18
Doors ............................................. 36 – Central door locking/unlocking ...................... 36
Driver's side front airbag ................ 97
Driving style.................................... 110
DTC (Drag Torque Control) system ......................................... 42EBD system .................................. 42
Electric windows ............................ 37 – Controls .................................... 37"Electronic Q2" system ("E-Q2") .... 44
INDEX