Page 64 of 494

62
Back-up key
The integral key is used to lock and unlock the vehicle when the electronic key cannot operate:
-
c
ell battery flat, vehicle battery discharged
o
r disconnected, ...
-
v
ehicle located in an area with strong
e
lectromagnetic
si
gnals.
F
M
aintain a pull on button 1 ,
to extract the
i
ntegral key 2.
Unlocking / Locking using the integral key with Keyless
Entry and Starting
If the alarm is activated, the audible s
ignal triggered on opening a door
w
ith the key (integral with the remote
c
ontrol) will stop when the ignition is
s
witched on.
Locking the driver's door
F Insert the integral key in the door lock, then t
urn it to the rear.
Unlocking the driver's door
F Insert the integral key in the door lock, then t
urn it to the front.
Locking the passenger doors
F Open the doors.
F O n the rear doors, check that the child lock
i
s not on (see the corresponding section).
F
R
emove the black cap, located on the edge
o
f the door, using the integral key.
F
I
nsert the integral key in the socket without
f
orcing it, then without turning it, move the
l
atch sideways towards the inside of the
d
o o r.
F
R
emove the integral key and refit the cap.
F
C
lose the doors and check that the vehicle
h
as locked correctly from the outside.
Unlocking the passenger
doors
F Pull the interior door opening control.
access
Page 65 of 494

63
Changing the battery
Following disconnection of the vehicle battery, replacement of the remote control battery or
i
n the event of a remote control malfunction,
y
ou can no longer unlock, lock or locate your
v
ehicle.
Remember
to refit the mat below the armrest
a
fter removing the reinitialised electronic key.
Remote control problem /
reinitialisation
F Place the back-up key (integral with the r
emote control) in the lock to unlock your
v
ehicle. F
O
pen the front armrest:
●
R
aise the mat by its tongue and
r
emove it.
●
P
lace the electronic key on the back-up
re
ader.
F S witch on the ignition by pressing the "
ST
ART/STOP"
button.
The
electronic key is fully operational again.
If
the problem persists, contact a CITROËN dealer
o
r a qualified workshop as soon as possible.
Battery
ref.:
CR2032
/
3
volts.
Battery
replacement
is
signalled
by
the
display
o
f
a
message.
F
U
nclip
the
cover
using
a
small
screwdriver
a
t
the
cutout.
F
L
ift
off
the
cover.
F
R
emove
the
flat
battery
from
its
location.
F
F
it the new battery into its location
observing
the
original
direction
of
fitment.
F
C
lip
the
cover
onto
the
casing.
3
Access
Page 69 of 494
67
* According to country of sale.
Alarm*
- exterior perimeter
The system checks for opening of the vehicle.
T he alarm is triggered if anyone tries to open a
d
oor, the boot, the bonnet...
- interior volumetric
The system checks for any variation in the volume in the passenger compartment.
The
alarm is triggered if anyone breaks a
w
indow, enters the passenger compartment or
m
oves inside the vehicle.
- tilt
The system checks for any change in the attitude of the vehicle.
The
alarm is triggered if the vehicle is lifted,
m
oved or knocked.
Self-protection function
The system checks for the putting out of service of its components.
The
alarm is triggered if the battery, the central
c
ontrol or the siren wiring are put out of service
o
r damaged. For
all work on the alarm system,
c
ontact a CITROËN dealer or a
q
ualified
w
orkshop.
System
which
protects
and
provides
a
deterrent
against theft and break-ins. It provides the
f
ollowing
types
of
monitoring:
3
Access
Page 76 of 494
74
Tailgate release
Unlocking
F Fold back the rear seats to gain access to t
he lock from inside the boot.
F
I
nsert a small screwdriver into hole A of the
lock
to unlock the tailgate.
F
M
ove the latch to the left.
Locking after closing
If the fault persists after closing again, the boot will remain locked.
System
allowing
the
mechanical
unlocking
o
f the boot in the event of a battery or central
locking
system
malfunction.
Access
Page 78 of 494

76
Reinitialisation
After reconnecting the battery or a fault, you must be reinitialise the operation of the electric
w
indows. For each of the control switches on
t
he driver's side control panel:
F
p
ull the control until the window stops,
F
r
elease the control and pull it again until
t
he window closes fully,
F
c
ontinue to hold the control for
a
pproximately
o
ne
se
cond
a
fter
t
he
w
indow
h
as
c
losed,
F
p
ress the control to lower the window
a
utomatically to the low position,
F
w
hen the window has reached the low
p
osition, press the control again for
a
pproximately one second.
The safety anti-pinch function is not
operational during these operations.
Safety anti-pinch
When the window rises and meets an obstacle, i t stops and partially lowers again.
If
the window cannot be closed (for
e
xample, in the presence of ice), once
t
he window has lowered:
F
p
ress and hold the control until the
w
indow opens fully,
F
t
hen pull the control immediately
a
nd hold it until the window closes,
F
c
ontinue to hold the control for
a
pproximately one second after the
w
indow has closed.
The safety anti-pinch function is not
operational during these operations.
Access
Page 80 of 494

78
Panoramic sunroof
Electric blind
Opening
Turn the dial to the left (four possible settings).
Closing
Return the dial to the initial position.
Safety anti-pinch
If the blind encounters an obstacle during c
losing, it stops and partially opens again.
If
the blind fails to close at a second attempt,
i
t may be necessary to force the closing of the
b
lind using the reinitialisation procedure.
The
blind
is
controlled
electrically
by
a
rotary
d
ial.
Reinitialising the system
Following reconnection of the battery, or in the e
vent of a malfunction in its operation, it may
b
e necessary to reinitialise the system:
F
t
urn the dial to the fully closed position,
F
t
hen immediately press the dial, closing
s
tarts after about 10 seconds,
F
m
aintain pressure on the dial until the blind
h
as fully closed.
The anti-pinch function is inoperative
during these operations.
If
the
position
of
the
blind
does
not
agree
with
t
he
position
indicated
by
the
dial,
press
the
dial
t
o
open
the
blind
to
this
position. In
the event of contact during operation
o
f the blind, you must reverse its
m
ovement. To do this, turn the dial.
When
the driver operates the dial, they
m
ust ensure that nothing prevents the
b
lind from closing correctly.
The
driver must ensure that the
p
assengers use the blind correctly.
Be
aware of children during operation
o
f the blind.
Your
vehicle
is
fitted
with
a
tinted
glass
panoramic
sunroof
which
increases
the
light
and
visibility
in
the
p
assenger
compartment.
Its
electric
blind
helps
control
the
temperature
in
the
passenger
compartment.
Access
Page 89 of 494

87
9. "REST" function: ventilation with the engine off
Even with the engine is off, you
c an operate the ventilation for a
few
m
inutes.
8. Air intake / Air recirculation
F Press this button for recirculation of the interior air. The indicator l
amp in the button comes on.
Air
recirculation enables the passenger
c
ompartment to be isolated from exterior
o
dours
and
smoke.
F
a
s s
oon as possible, press this button
again
to permit the intake of outside air and
p
revent
the formation of condensation. The
i
ndicator lamp in the button goes off.
Avoid
prolonged operation in interior air
r
ecirculation mode (risk of misting and
d
eterioration of air quality). For
example, while you are away from the
v
ehicle, the passengers can still enjoy some air
c
irculation without having the engine running.
This
function is available after switching on the
i
gnition, as well as after stopping the engine.
The
period that the function is available
d
epends on the state of charge of the battery.
You can activate the "REST" function while the
air
conditioning control screens are on.On switching on the engine
-
T he control screens come on: the function
i
s available.
-
P
ressing the REST button activates the
ventilation
for a few minutes. Activation of
t
he function is confirmed by the display of
t
wo dashes in the control screens and four
a
ir flow level indicator lamps.
-
T
he function can be deactivated and
r
eactivated if the control screens are on.
-
T
he screens go off at the end of this
p
eriod.
4
Comfort
Page 115 of 494
113
F To connect a 12 V accessory
(max power: 120 W), remove the cap and
c
onnect an appropriate adaptor.
F
T
urn the key to the ignition on position.
12 V accessory socket
This is a removable lamp, fitted in the boot wall, which can be used to light the boot or as
a
torch.
For
the boot lamp function, refer to the
"
Visibility - Boot lamp" section.
To r c h
Operation
This torch operates with ni MH type
rechargeable b atteries.
It
has a battery life of approximately 45 minutes
a
nd charges while you are driving.
Observe
the polarities when fitting the
r
echargeable
b
atteries.
Never
r
eplace
t
he
r
echargeable
b
atteries
w
ith normal disposable batteries.
5
Fittings