2014.5 Citroen BERLINGO MULTISPACE RHD stop start

157
Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
BAttE rY
Before disconnecting the battery, you
must
  wait   for   2   minutes   after   switching  
of

f   the   ignition.
Never
  disconnect   a   terminal   when   the  
engine

  is   running.
Never
  charge   a   battery   without   first  
disconnecting

  the   terminals.
a

fter every reconnection of the battery,
switch
  on   the   ignition   and   wait   1   minute  
before starting to allow the electronic
systems

  to   be   initialised.   If   problems  
remain

  after   doing   this,   please   contact  
a

  CITROËN   dealer   or   a   qualified  
workshop.
a

fter changing bulbs, wait
approximately
  3   minutes   before  
reconnecting

  the   battery.
It is advisable to disconnect the
battery if the vehicle is not to be
used

 
for
 
a
 
period
 
of
 
more
 
than
 
one month.
to charge the battery using a
battery charger
- disconnect the battery,
-
Follow the instructions for use
given by the battery charger
manufacturer

,
-

Reconnect starting with the
negative

  (-)   terminal,
-
 
Check
  that   the   terminals   and  
connectors

  are   clean.   If   they   are  
covered with sulphate (white or
greenish

  deposit),   disconnect   them  
and

  clean   them.
to start the vehicle from
another battery
- Connect the red cable to the
positive   (+)   terminals   of   the  
two

batteries,
-

Connect one end of the green
or

  black   cable   to   the   negative   (-)  
terminal

  of   the   slave   battery,
-

Connect the other end of the green
or

  black   cable   to   an   earth   point   on  
the

  broken   down   vehicle   as   far   as  
possible

  from   the   battery,
-


o perate the starter, let the engine run,
-

W
ait for the engine to return to idle,
then
  disconnect   the   cables.
The presence of this label
indicates the use of a 12 V
lead-acid battery with special
technology
 
and
 
specification,
 
for
 
which
 
the

 
involvement
 
of
 
a
 
CITROËN
 
dealer
 
or

 
qualified
 
workshop
 
is
 
required
 
when
 
replacing

 
or
 
disconnecting
 
the
 
battery.
Failure to observe this
recommendation
 
may
 
cause
 
premature
 wear
 
of
 
the
 
battery.
After
 
refitting
 
the
 
battery,
 
the
 
Stop &
 
Start

 
system
 
will
 
only
 
be
 
active
 
after
 
several hours depending on the
climatic

 
conditions
 
and
 
the
 
state
 
of
 
charge of the battery (up to about
8 hours).
The Stop & Start battery does not have
to

 
be
 
disconnected
 
for
 
charging.
Battery
QUICk HELP
8

158
Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
EcOnOMY MOdE
after the engine has stopped, with
the   key   in   the   ignition   position,   certain  
functions (windscreen wiper

, electric
windows,
  courtesy   lamps,   audio  
equipment,

  etc.)   can   only   be   used   for   a  
cumulative

  duration   of   thirty   minutes,  
to
  prevent   discharging   of   the   battery.
Once
  the   thirty   minutes   are   over,   the  
active functions are put on standby
and

  the   battery   warning   lamp   flashes  
accompanied

  by   a   message   in   the  
screen.
T

o   resume   the   use   of   these   functions  
immediately

,   start   the   engine   and   let   it  
run

  for   a   few   minutes.
The
  time   available   will   then   be   double  
the

  time   for   which   the   engine   was   left  
running.

  However,   this   time   will   always  
be

  between   five   and   thirty   minutes.
A
 

flat   battery   will   prevent   the  
engine

  from   starting.
Battery

186
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
diesel Engines / Weights
5-seatEngine Gearbox GearsEngine oil
capacity* (litres)
u

nbraked
trailer (kg)
r

ecommended nose
weight (kg)
1.6 H
d i 75 hp Manual 5-740 50
1.6 H
d i 75 hp FAP Manual 5-715 70
1.6 H
d i 90 hp Manual 53.75 740 55
1.6 H
d i 90 hp FAP Manual 53.75 750 55
1.6 H
d i 92 hp E c OManual 53.75 715 70
1.6 H
d i 92 hp FAP Manual 53.75 715 70
1.6 e-H
d I 92 hp
E
c O Manual
5
3.75 690
70
Electronic 6 75070
1.6 e-H
d i 92 hp FAP Manual
5
3.75 690
70
Electronic 6 75070
1.6 H
d i 110 hp FAP Manual 53.75 750 55
1.6 H
d i 112 hp FAP Manual 53.75 735 70
FAP:
  particle   filter.
e-H
d i:  
model
  equipped   with   Stop   &   Start.
*
  Capacity   with   oil   filter   replacement.
Weights

 187
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
7-seatEngine Gearbox GearsEngine oil
capacity* (litres)
u

nbraked
trailer (kg)
r

ecommended nose
weight (kg)
1.6 H
d i 90 hp Manual 53.75 750 70
1.6 H
d i 90 hp FAP Manual 53.75 750 70
1.6 H
d i 92 hp FAP Manual 53.75 750 70
1.6 e-H
d I 92 hp FAP Manual 53.75 750 70
1.6 H
d i 110 hp FAP Manual 53.75 750 70
1.6 H
d i 112 hp FAP Manual 53.75 750 70
FAP:
  particle   filter.
e-H
d i:  
model
  equipped   with   Stop   &   Start.
*
  Capacity   with   oil   filter   replacement..
tEcHnIcAL dAtA
9
Weights

10.81
Berlingo_2_VP_en_Chap10c_Rd45_ed02_2014
FrEQuEntLY ASKE d Q u ES t IO n S
QuEStIOnA n SWE rSOL ut IO n
Sound cut-outs of 1 to
2 seconds

  in   radio   mode.During
  this   brief   sound   cut-out,   the   RDS   searches   for   any   frequency  
permitting

  better   reception   of   the   station.Deactivate
  the   RDS   function   if   the   phenomenon   is  
too

  frequent   and   always   on   the   same   route.
With the engine off,
the
 
audio   equipment  
switches of

f after a few
minutes
  of   use. When
  the   engine   is   switched   off,   the   audio   equipment   operating   time  
depends

  on   the   battery   charge.
The
  switch-off   is   normal:   the   audio   equipment   switches   to   economy   mode  
and

  switches   off   to   prevent   discharging   of   the   vehicle's   battery.Start the vehicle's engine to increase the battery
charge.
The
 
message   "the   audio  
system

  is   overheated"  
appears

  on   the   display. In
  order   to   protect   the   installation   if   the   surrounding   temperature   is   too  
high,

  the   audio   equipment   switches   to   an   automatic   thermal   protection  
mode

  leading   to   a   reduction   of   the   volume   or   stopping   of   the   playing   of  
the

  CD. Switch
  the   audio   system   off   for   a   few   minutes   to  
allow

  the   system   to   cool.