Page 52 of 276

Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
50
Good practice when stopping Good practice when starting
diesel pre-heating warning
lamp
If
the temperature is high
enough,
the warning lamp
comes
on for less than
one
second, you can start
without
waiting.
In cold weather, wait for this warning
lamp
to
go off then operate the starter
(Starting position) until the engine
starts.
d
oor or bonnet open
warning lamp
If this comes on, a door or the bonnet is not closed correctly, check!
Minimise engine and gearbox wear
When switching off the ignition, let the
engine run for a few seconds to allow
the turbocharger (
d iesel engine) to
return
to idle.
d
o not press the accelerator when
switching
off the ignition.
There is no need to engage a gear
after
parking the vehicle.
StArt I n G A nd S tOPPI n G
running and accessories position.
T o unlock the steering, turn the
steering wheel gently while turning the
key
, without forcing. In this position,
certain
accessories can be used.
Starting position.
The starter is operated, the engine
turns
over, release the key.
S
t
OP
position: steering lock.
The
ignition is off.
T
urn the steering
wheel
until the steering locks. Remove
the
key.
Starting and stopping
Page 53 of 276

Berlingo_2_VP_en_Chap03_Pret-a-partir_ed02-2014
51
HILL StA rt ASSIS t
This system (also called HHC - Hill Holder
Control), linked to the dynamic
stability
control system, makes hill
starts easier and is activated in the
following
conditions:
-
the
vehicle must be stationary,
engine
running, foot on the brake,
-
the
gradient of the road must be
steeper than 5%,
-
uphill,
the gearbox must be in
neutral or in a gear other than
reverse,
-
downhill,
reverse gear must be
engaged.
The Hill Start
a
ssist function is
a
driving aid system. It is not an
automatic
vehicle parking function or
an
automatic parking brake.
Operation
With the brake pedal and clutch pedal pressed, from the time you release the
brake
pedal you have approximately
2 seconds before the vehicle starts to
roll
back and without using the parking
brake
within which to move off.
During
the moving off phase, the
function
is deactivated automatically,
gradually
releasing the braking
pressure.
During this phase, the
characteristic
noise of mechanical
release
of the brakes may be heard,
indicating
the imminent movement of
the
vehicle.
Operating fault
Hill start assist is deactivated in the
following situations:
-
when the clutch pedal is released,
-
when
the parking brake is applied,
-
when the engine is switched of
f,
-
when
the engine stalls.
If
a malfunction of the
system
occurs, this
warning
lamp comes on
accompanied
by an audible
signal
and confirmed by
a
message in the screen. Have the
system
checked by at a CITROËN
dealer
or a qualified workshop.
Starting and stopping
REadY To Go
3
Page 137 of 276
135
Berlingo_2_VP_en_Chap06_Accessoire_ed02-2014
For more information about weights and towed loads, refer to
chapter 9, "Weights" section.
tOWIn G A tr AILE r , c A r AVA n , BOAt, E tc ...
distribution of loads
d
istribute the load in the trailer so
that
the heaviest objects are as
close as possible to the axle and
the nose weight is close to the
maximum
authorised without, however,
exceeding
it.
c
ooling
Towing a trailer on a slope increases
the
coolant temperature.a s the fan is electrically controlled, its
cooling capacity is not dependent on
the
engine speed.
You should therefore use a high gear
to lower the engine speed and reduce
your
speed.
In all cases, pay attention to the
coolant
temperature.
driving advice
A towed vehicle must free wheel: gearbox
in neutral.
Towing a trailer
aCCESSoRIES
6
Page 148 of 276

Berlingo_2_VP_en_Chap07_Verification_ed02-2014
146
Bleeding water from the diesel
filter Manual gearbox
Have the level checked in accordance with the
manufacturer's servicing schedule.
Only use products recommended by CITRo Ë n or products
of
equivalent quality and
specification.
In
order to optimise the operation
of
units as important as the braking
system,
CITROËN selects and offers
specific
products.
In
order to avoid damaging the
electrical units, high pressure washing
to
clean the engine compartment is
strictly
prohibited.
After
washing the vehicle dampness,
or
in
winter, ice may form on the brake
discs
and pads: braking efficiency may
be
reduced. Make some light brake
applications to dry and de-ice the
brakes.
If
this
warning
lamp
comes
on,
bleed
the
filter.
Otherwise
bleed
regularly
each
time
the
engine
oil
is
changed.
H
d
i engines use advanced
technology.
All
work
requires
special training, which is assured
by
a
CITROËN
dealer.
Depending
on
country
of
sale.
To drain the water, unscrew the bleed
screw
located
on
the
filter.
o
perate until all of the water no longer
flows
in
the
transparent
pipe,
then
tighten
the
bleed
screw.
checks
Page 180 of 276

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
178
Without lifting (4 wheels on the
road)
You should always use a towing bar.
BEInG tOWEd
Ths procedure involves the use of the
towing eye supplied with the tools for
changing
a wheel.
From the front
- Unclip the cover by pressing the
bottom part.
-
Fully
screw in the removable towing
eye.
From the rear
- Unclip the cover using a coin or the
flat part of the towing eye.
-
Fully
screw in the removable towing
eye. When towing with the engine
switched
off, there is no braking or
steering
assistance.
Lifting (only 2 wheels on the
road)
It is preferable to raise the vehicle
using
professional lifting equipment.
Vehicles fitted with a manual
gearbox (d iesel version)
In the case of vehicles fitted with a manual gearbox, the gear lever
must
be in neutral, failure to observe
this
special condition may result in
damage
to transmission and braking
components
and the absence of
braking
assistance when the engine is
started
again.
Chapter
9,
"Changing
a
wheel"
section.
Having your vehicle towed
Page 187 of 276
185
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
Petrol Engines / Weights
5-seatEngine Gearbox GearsEngine oil
capacity* (litres)
u
nbraked
trailer (kg)
r
ecommended nose
weight (kg)
1.6 90 hp Manual 53.25 735 50
1.6 110 hp Manual53.25 750 55
1.6 V
t
i 100 hp Manual 54.25 690 70
1.6 V
t
i 120 hp Manual 54.25 690 70
7-seat Engine Gearbox GearsEngine oil
capacity*
(litres)
u
nbraked
trailer (kg)
r
ecommended nose
weight (kg)
1.6 110 hp Manual53.25 750 70
1.6 V
t
i 120 hp Manual 54.25 750 70
*
Capacity with filter replacement.
TECHnICaL daTa
9
Weights
Page 188 of 276
186
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
diesel Engines / Weights
5-seatEngine Gearbox GearsEngine oil
capacity* (litres)
u
nbraked
trailer (kg)
r
ecommended nose
weight (kg)
1.6 H
d i 75 hp Manual 5-740 50
1.6 H
d i 75 hp FAP Manual 5-715 70
1.6 H
d i 90 hp Manual 53.75 740 55
1.6 H
d i 90 hp FAP Manual 53.75 750 55
1.6 H
d i 92 hp E c OManual 53.75 715 70
1.6 H
d i 92 hp FAP Manual 53.75 715 70
1.6 e-H
d I 92 hp
E
c O Manual
5
3.75 690
70
Electronic 6 75070
1.6 e-H
d i 92 hp FAP Manual
5
3.75 690
70
Electronic 6 75070
1.6 H
d i 110 hp FAP Manual 53.75 750 55
1.6 H
d i 112 hp FAP Manual 53.75 735 70
FAP:
particle filter.
e-H
d i:
model
equipped with Stop & Start.
*
Capacity with oil filter replacement.
Weights
Page 189 of 276
187
Berlingo_2_VP_en_Chap09_Caract-technique_ed02-2014
7-seatEngine Gearbox GearsEngine oil
capacity* (litres)
u
nbraked
trailer (kg)
r
ecommended nose
weight (kg)
1.6 H
d i 90 hp Manual 53.75 750 70
1.6 H
d i 90 hp FAP Manual 53.75 750 70
1.6 H
d i 92 hp FAP Manual 53.75 750 70
1.6 e-H
d I 92 hp FAP Manual 53.75 750 70
1.6 H
d i 110 hp FAP Manual 53.75 750 70
1.6 H
d i 112 hp FAP Manual 53.75 750 70
FAP:
particle filter.
e-H
d i:
model
equipped with Stop & Start.
*
Capacity with oil filter replacement..
tEcHnIcAL dAtA
9
Weights
Page:
< prev 1-8 9-16 17-24