2014.5 Citroen BERLINGO MULTISPACE RHD child seat

130
Berlingo_2_VP_en_Chap05_Securite_ed02-2014
"ISOFIX" MOuntInGS
Your vehicle has been approved in
accordance with the latest ISo FIX
regulation.
The
  mountings   comprise   three   rings   for  
each

  seat:
-

two front rings
A, located between
the
  vehicle   seat   backrest   and  
cushion,

  indicated   by   a   marking-
a rear ring B,   located   on   the   back  of
  the   vehicle's   seat   backrest,   for  
securing the upper strap referred to
as

  the  
T
op  
T
ether.
The Top Tether is used to secure the
upper strap of child seats that have
one.
 
This
  arrangement   limits   the  
forward tipping of the child seat in the
event

  of   a   frontal   impact.
This
  ISOFIX   mounting   system  
guarantees you fast, reliable and safe
fitting

  of   the   child   seat   in   your   vehicle.
The
  ISOFIX   child   seats   are   fitted   with  
two latches which are secured on the
two front rings

A.
Some
  also   have   an   upper   strap   which  
is attached to the rear ring

B.Follow strictly the instructions for
fitting
  child   seats   contained   in   the  
manufacturer's

  installation   guide.
To secure the child seat to the Top
Tether:
-
 
remove
  and   stow   the   head   restraint  
before installin

g the child seat in
this   seating   position   (refit   it   once  
the

  child   seat   has   been   removed),
-
pass the upper strap of the child
seat over the top of the seat
backrest,

  between   the   apertures   for  
the head restraint rods,
-
 secure   the   hook   on   the   upper   strap  to the rear ring,
-
 
tighten
  the   upper   strap.
The incorrect installation of a child
seat
  in   a   vehicle   compromises   the  
protection of the child in the event
of

  an   accident.
Refer
  to   the   table   for   information   on  
the installation of IS

o FIX child seats in
your
  vehicle.
Child safety

131
Berlingo_2_VP_en_Chap05_Securite_ed02-2014
This child seat can also be used on seats which are not fitted with ISOFIX mountings.
In  this   case,   it   must   be   attached   to   the   vehicle   seat   using   the   three   point   seat  
belt.
Follow the instructions for fitting the child seat given in the

seat
manufacturer's installation guide.
ISOFIX child seat recommended and approved for your vehicle
"ISOFIX rÖMEr duO plus"
(size category B1)
Group 1: from 9 to 18 kg
Installed
  only   in   the   "forward   facing"   position.
Secured to rings A, as well as ring B, called the Top Tether, using
  an   upper   strap.
Three
  seat   body   angles:   sitting,   reclining,   lying.
Child safety
SaFETY
5

132
Berlingo_2_VP_en_Chap05_Securite_ed02-2014
LOcAtIO n S FO r t HE I n S tALLAt IO n OF ISOFIX c HIL d SEAt S
*  In  the   7   seat   version,   all   three seats
in   row   2   must   be   present   when   child  
seats

  are   installed.
**
  
A 
child   seat   with   support   leg   must  
never be installed on an outer
passenger

  seat   in   row   2.
In accordance with European regulations, this table indicates the option\
s for the installation of IS
o FIX child seats on the
vehicle   seats   fitted   with   ISOFIX   mountings.
In   the   case   of   the   universal   and   semi-universal   ISOFIX   child   seats,   the   child   seat's   ISOFIX   size   category,   determined   by   a  
letter

  from   A to G,   is   indicated   on   the   child   seat   next   to   the   ISOFIX   logo.
Weight of the child   /   indicative   age
Less than 10 kg
(group 0)
Up   to   6   months  
approx
Less than 10 kg

(group 0)
Less than 13 kg (group 0+)
Up to 1 year approx From 9 to 18 kg
(group 1)
From   1   to   3   years   approx
type of ISOFIX child seat Infant car seat "rearward facing"
"rearward
facing" "forward facing"
ISOFIX size category F G
cdEcdA B B1
r
ow 2
(5   and   7*   seats)
o
uter
seats** IL-S u
IL-S
u
IL-S
u
I
u F, IL-S u
Centre seatn

ot ISOFIX
r

ow 3
(7   seats)
a
ll seats
n
ot ISOFIX
IL-S u : seat suitable for the installation
of a IS o FIX Semi- u niversal child seat,
either.
-
 
"rearward
  facing"   equipped   with   an  
upper strap or a support leg,
-

 
"forward
  facing"   equipped   with   a  
support leg,
-

 
a
  cot   equipped   with   an   upper   strap  
or

  a   support   leg.Remove
  and   stow   the   head  
restraint before installin

g a
child
  seat   with   a   backrest   on   a  
passenger

  seat.
Refit
  the   head   restraint   once   the   child  
seat

  has   been   removed.
I
u F: seat suitable for the installation
of an IS
o FIX u niversal child seat,
"Forward facing" and secured with an
upper
  strap. To attach the upper strap, refer to
chapter
  5,   "ISOFIX   mountings   section".
Child safety

133
Berlingo_2_VP_en_Chap05_Securite_ed02-2014
AdVIcE On cHILd SEAtS
At the rear, always leave sufficient space
  between   the   front   seat   and:
-

a "rearward facing" child seat,
-


the feet of a child seated in a
"forward

  facing"   child   seat.
For
  this,   move   the   front   seat   forward  
and, if necessary

, straighten its
backrest
  as   well.
The incorrect installation of a child seat
in
  a   vehicle   compromises   the   child's  
protection

  in   the   event   of   an   accident.
Check   that   there   is   no   seat   belt   or   seat  
belt

  buckle   under   the   child   seat,   as   this  
could

  destabilise   the   seat.
Remember   to   fasten   the   seat   belts   or  
the child seat harnesses

keeping the
slack relative to the child's body to a
minimum,   even   for   short   journeys.
For the installation of a child seat using
the seat belt, ensure that the seat belt
is well tensioned on the child seat
and that it is holding the child seat
firmly   against   the   vehicle's   seat.   If   the  
passenger

  seat   is   adjustable,   move   it  
forward

  if   necessary. For   the   optimum   installation   of   a  
"forward facing" child seat, ensure that
the

  back   of   the   child   seat   is   as   close   as  
possible

  to   the   backrest   of   the   vehicle's  
seat,

  or   in   contact   if   possible.
The   head   restraint   must   be   removed  
before installin

g a child seat with a
backrest   on   the   passenger   seat.
Ensure that the head restraint is
stowed or attached securely so that it
is not thrown around the vehicle in the
event   of   sharp   braking.
Refit   the   head   restraint   as   soon   as   the  
child

  seat   is   removed.children at the front
The legislation on carrying a child on
the
  front   passenger   seat   is   specific   to  
each

  country.   Refer   to   the   legislation   in  
force

  in   your   country.
d

eactivate the passenger's airbag
when a "rearward facing" child seat is
installed
  on   the   front   seat.
Otherwise,
  the   child   would   risk   being  
seriously

  injured   or   killed   if   the   airbag  
were

  deployed.
Installing a booster seat
The chest part of the seat belt must be positioned on the child's shoulder
without   touching   the   neck.
Ensure that the lap part of the seat belt
passes
  correctly   over   the   child's   thighs.
CITROËN
  recommends   the   use   of   a  
booster

  seat   which   has   a   back,   fitted  
with

  a   seat   belt   guide   at   shoulder   level.
As
  a   safety   precaution,   never   leave:
-
 
one
  or   more   children   alone   and  
unsupervised in a vehicle,
-

 
a
  child   or   an   animal   in   a   vehicle  
which is exposed to the sun, with
the windows closed,
-

 
the
  keys   within   reach   of   children  
inside

  the   vehicle.
To prevent accidental opening of the
doors,
  use   the   "Child   Lock".
Take
 
care
 
not
 
to
 
open
 
the
 
rear
 
windows
 
by

  more   than   one   third.
To
  protect   young   children   from   the   rays  
of

  the   sun,   fit   side   blinds   to   the   rear  
windows.
For an installation in row 3, put the
backrests

 
of
 
the
 
outer
 
and
 
centre
 seats in row 2 in the table position, or
remove
 
these
 
seats
 
in
 
row
 
2,
 
so
 
that
 
the child seat or the child's legs do not
touch

 
the
 
seats
 
in
 
row
 
2.
Child safety
SaFETY
5

Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
159
The temporary tyre repair kit consists of  a   compressor   and   a   bottle  
(containing

  a   sealant).
using the kit
1. Tick  the   deflated   wheel   on   the  speed
  limitation   sticker   then   affix  
the

  sticker   to   the   vehicle's   steering  
wheel

  to   remind   you   that   a   wheel   is  
in

  temporary   use.
2.

Clip the bottle
1 on the
compressor 2.
3.

Connect the bottle
1 to the valve of
the
  tyre   to   be   repaired.
4.
 
T
ake   care   to   unwind   the  
compressor

  pipe   before   connecting  
it

  to   the   bottle.
5.

Connect the power lead to one of
the

  vehicle's   12V   sockets.
6.
 
Switch
  on   the   compressor   by  
pressing button

A until the tyre
pressure
  reaches   2.0   bars.   If   this  
pressure cannot be reached, the
tyre

  cannot   be   repaired.
7.
 
Remove
  and   store   the   compressor.
8.
 
Drive
  immediately,   for   a   few   miles  
(kilometres),

  at   reduced   speed,  
to
  fill   the   puncture.
9.
 
Adjust
  the   pressure   using   the  
compressor

  in   accordance   with   the  
recommendation

 
for
 
the
 
vehicle
 
and
 
check

  that   the   leak   is   filled   correctly  
(no

  further   loss   of   pressure).
10.
 
Drive
  at   reduced   speed   (50 mph  
[80

  km/h]).  
The
  tyre   must   be  
examined

  and   repaired   by   a  
specialist

  as   soon   as   possible.
a
fter use, the bottle can be stored in
a   plastic   bag,   supplied   in   the   kit,   to  avoid staining your vehicle with traces
of
  fluid.
Warning:
  the   bottle   of   gel   contains  
ethylene-glycol, a product which
is

  harmful   if   swallowed   and   which  
causes

  irritation   to   the   eyes.
Keep
  it   out   of   reach   of   children.
a

fter use, do not discard the bottle into
the
  environment,   take   it   to   a   CITROËN  
dealer or to an specialised waste
disposal

  site.
Replacement
  bottles   of   sealant   are  
available

  from   CITROËN   dealers.
PuncturE rEPAIr KIt
The kit is located in one of the two storage  compartments   located   under  
the

  front   seats.
Vehicles
  supplied   with   a   temporary  
puncture

  repair   kit   do   not   have   a   spare  
wheel

  or   tooling   (jack,   wheelbrace,   ...).
Changing a wheel
QUICk HELP
8