8-15
85. Pour the recommended type of oil in the trans-
mission oil filler hole until it flows out of the
check screw hole.
6. Tighten the oil check screw to the specified torque.
7. Check the oil filler bolt gasket for damage, and replace it if necessary. 8. Install the transmission oil filler bolt and its
gasket, and then tighten the bolt to the speci-
fied torque.
To change the transmission oil 1. Place the ATV on a level surface.
2. Start the engine, warm it up for several min- utes, and then turn it off.
3. Place an oil pan under the transmission to col- lect the used oil.
4. Remove the transmission oil filler bolt, the transmission oil drain bolt and their gasket to
drain the oil from the transmission case.
1. Transmission oil filler bolt
2. GasketTightening torque:Transmission oil check screw:16 Nm (1.6 m·kgf, 12 ft·lbf)
1
2
Tightening torque: Transmission oil filler bolt:23 Nm (2.3 m·kgf, 17 ft·lbf)
U1PY61E0.book Page 15 Wednesday, March 14, 2012 5:22 PM
10-2
10
Type:SAE 5W-30, 10W-30, 10W-40, 15W-40, 20W-40 or 20W-
50
Recommended engine oil grade: API service SG type or higher, JASO standard MA
Engine oil quantity: Periodic oil change:
1.25 L (1.32 US qt, 1.10 Imp.qt)Transmission oil:Quantity:0.6 L (0.63 US qt, 0.53 Imp.qt)Air filter:Air filter element:Wet element
Fuel:Recommended fuel:Regular unleaded gasoline only
Fuel tank capacity:
7.0 L (1.85 US gal, 1.54 Imp.gal)
Fuel reserve amount: 1.3 L (0.34 US gal, 0.29 Imp.gal)Carburetor:Type × quantity:
VM18SH x 1Spark plug (s):Manufacturer/model: NGK/CR7HSA
Spark plug gap:
0.6–0.7 mm (0.024–0.028 in)Clutch:Clutch type:Dry, centrifugal automaticTransmission:Primary reduction system:Helical gear/spur gear
Primary reduction ratio: 43/14 × 40/17 (7.226)
Secondary reduction system:
Chain drive
Secondary reduction ratio: 32/12 (2.666)
Transmission type: V-belt automatic
Operation:
Centrifugal automatic type
-20 -10 0 1020 30
4050 C
SAE 15W-40
SAE 20W-40SAE 20W-50
SAE 10W-40
SAE 5W-30
SAE 10W-30
U1PY61E0.book Page 2 Wednesday, March 14, 2012 5:22 PM
