To access ignition modes I or II without starting the engine, the brake pedal must not be depressed.
0
Vehicle unlocked.
I Remote key fully pressed into the ignition slot: press START/STOP ENGINE briefly.
II Remote key fully pressed into slot: press START/STOP ENGINE for approx. 2 seconds. Mode II should
only be used for very short periods to help avoid draining the battery.
See also the table in the section “Ignition modes” in your owner’\
s manual for information about which components/
systems can be used in the various ignition modes.
To return to mode
0 from mode II or I, press START/STOP ENGINE briefly.
KEYlESS DRIvE*
On keyless drive vehicles, it is only necessary to
have a remote key in your possession to operate the
central locking system and start the engine.
lOCKING AND ARMING THE AlARM
– Press the pressure-sensitive area on any of the out-
side door handles or the rubber-covered button to
the right of the trunk opening button. The lock indica-
tor light on the dashboard will start to flash. uNlOCKING AND DISARMING THE AlARM
– Pull a door handle to unlock and open the door or
press lightly on the larger of the two rubberized but-
tons on the trunk lid.
STARTING THE ENGINE
– With a remote key in the passenger’s compart-
ment, depress the brake pedal.
– Press and release the START/STOP ENGINE
button. The autostart function will operate the starter
motor until the engine starts.
SWITCHING OFF THE ENGINE
– Press briefly on the START/STOP ENGINE button.
1.
Park the vehicle and press
the START/STOP ENGINE
button to switch off the
engine.
2. Pull the remote key out of the ignition slot.
If the BLIS indicator lights illuminate even when there
are no vehicles in the blind area, this may be due to
light reflected from a wet road surface, the vehicle’s
own shadow against a large, light, smooth surface,
or sunlight directly in the camera when the sun is low
on the horizon.
If there is a fault with the system, Blind spot syst.
Service required will be displayed.
SWITCHING OFF THE ENGINE AND RE-
MOvING THE REMOTE KEY BlIND SPOT INFORMATION
SYSTEM (BlIS)*
IGNITION MODES
