2013 VOLKSWAGEN JETTA HYBRID key battery

NOTICE
The remote control vehicle keys contain electrical components. Protect them from damage, moisture and rough handling.
Do not press the buttons on the remote control vehicle key unless you actually want to use the function in question. Since terrain and conditions vary, pressing a button on the remote control vehicle key when it is not necessary may unlock the vehicle or set off the panic alarm, even if you think you are out of range.
Remote control vehicle key functions can be temporarily disrupted by interference from transmitters near the vehicle that use the same frequency range (such as radio equipment or cellular phones).
Things between the remote control vehicle key and vehicle, bad weather, as well as a weak battery can reduce the operating range.
If the remote control vehicle key buttons or the power locking buttons are pushed repeatedly in quick succession, the power locking system is switched off for a brief period to help keep it from being overloaded. The vehicle is then unlocked for about 30 seconds. Unless a door or the luggage compartment lid is opened in this span of time, the vehicle is automatically locked afterwards.
Indicator light in the remote control vehicle key

Fig. 19 Indicator light in the remote control vehicle key.

Replacing the remote control vehicle key battery

Fig. 20 Remote control vehicle key: Open battery compartment cover.

Fig. 21 Remote control vehicle key: Remove old battery.

Remove your finger from the lock sensor surface ⇒ fig. 26 (B) to stop the function. If you touch the unlock sensor surface (A) on the inside of the door handle immediately after releasing the lock sensor surface (B) (arrow), all of the windows will open (safety function).
Pinch protection is active during convenience closing of the windows and the power sunroof.
The settings in the Settings – Convenience menu determine which doors open when the door handle unlocking surface is grasped.
NOTICE
The door handle sensor surfaces can be activated by a strong stream of water or steam if a valid vehicle key is within range of the vehicle.
x All windows may open if you turn the spray of water or steam away from and then back onto the door handle sensor surface in quick succession. If at least one power window is opened and the sensor is continuously activated, convenience closing is started.
The door may not open if the outside and inside door handles are used at the same time.
If the vehicle battery or the battery in the remote control vehicle key is weak or dead, it might not be possible to unlock and lock the vehicle using Keyless Access. The vehicle can still be manually locked or unlocked with the key bit .
The driver message Key not in range appears in the instrument cluster display if there is no remote control vehicle key inside the vehicle or if the system does not recognize the remote control vehicle key. The key may not be recognized, for example, if it is covered by something that interferes with the signal (such as a briefcase), or if the remote control vehicle key battery is weak. Electronic devices such as cell phones can also interfere with the signal.
Dirt on the door handles that contains a lot of salt (especially in winter) can affect the way the door handle sensors work. Cleaning the door handles can help with this problem .
If the automatic transmission is not in Park (P) position, the electronic steering column lock will not lock and the vehicle will not lock via sensors in the front door handles or the remote control vehicle key.
Anti-theft alarm system

x Forcibly opening a door.
x Forcibly opening the engine hood.
x Forcibly opening the luggage compartment lid.
x Switching on the ignition with an invalid key.
x Disconnecting the vehicle battery.
Deactivating the alarm
Unlock the vehicle with the unlock button on the remote control vehicle key or switch on the ignition with a valid vehicle key.
For vehicles with Keyless Access, the alarm can be deactivated by grasping one of the front door handles when a valid vehicle key is in range or by holding the remote control vehicle key to the right of the steering column trim and pressing the starter button .
After the alarm has stopped and the vehicle is opened again in the same or a different area that is protected by the alarm, the alarm is triggered again. For example, the alarm will sound again if the luggage compartment lid is opened after one of the doors has been opened.
The anti-theft alarm system is not activated when the vehicle is locked with the power lock switch 0 on the inside of the driver or front passenger doors.
If the driver door is mechanically unlocked using the vehicle key bit, only the driver door is unlocked, not the entire vehicle. Switching on the ignition deactivates the anti-theft alarm system and activates the central locking button. To unlock the doors, use the central locking button or remote control vehicle key.
If the vehicle battery is dead or weak, the anti-theft alarm system will not work properly.

WARNING
Improper use of vehicle keys can result in serious personal injury.
x Always take the key with you when you leave the vehicle. The engine can be started and
vehicle systems such as the power windows can be operated, leading to serious personal
injury.
x Never leave children, disabled persons, or anyone who cannot help themselves in the
vehicle. The doors can be locked with the remote control vehicle key. This could result in
people being trapped in the vehicle in an emergency. For example, depending on the time of
year, people trapped in the vehicle can be exposed to very high or very low temperatures.
x Heat build-up in the passenger and luggage compartment of a parked vehicle can result in
temperatures in the vehicle that are much higher than the outside temperatures, particularly
in summer. Temperatures can quickly reach levels that can cause unconsciousness and
death, particularly to small children.
x Never remove the key from the ignition switch while the vehicle is moving or rolling to a
stop. The steering wheel will lock and you will not be able to steer or control the vehicle.
Leaving the key in the ignition for a long time when the engine is not running will drain the vehicle
battery.
Leaving the selector lever for a long period of time in any position other than Park (P) when the
ignition is switched off can drain the vehicle battery.
On automatic transmission vehicles, the vehicle key can be removed from the ignition switch
only when the transmission is in Park (P). You may have to press the release button on the
transmission selector lever to put the lever into Park (P).
Starter button

Fig. 101 In the center console: Starter button of the Keyless Access locking and starting system.

DANGER
The vehicle's high-voltage electrical system and high-voltage battery are dangerous and can
cause burns, other serious personal injuries, electrocution, and death.
x Always assume that high-voltage battery and parts of the high-voltage system are fully
charged and energized.
x Never touch or let jewelry or other metal objects contact high-voltage cables or the high-
voltage battery and battery poles, especially if the cables, battery, and battery poles have
been damaged in any way.
x Never do any work yourself on the high-voltage electrical system, the orange-colored
high-voltage wiring, or on the high-voltage battery.
x Never open, service, repair, or disconnect any part of the hybrid electrical system.
x Never damage the orange-colored high-voltage cables. Never remove them and never
disconnect them from the high-voltage electrical system.
x Never open or remove the orange-colored cover on the high-voltage battery.
x Always have work on the hybrid electrical system and systems that could be indirectly
affected by it done by qualified, trained technicians who have the know-how, experience,
documentation, and tools to do the work safely.
x All work on the high-voltage electrical system and the high-voltage battery must be done
in compliance with Volkswagen standards and guidelines.
x Vehicle keys must be safely stored a safe distance from vehicle so that the ignition cannot
be switched on and energize the electrical system.
x Gases vented or released from the high-voltage battery vapors are potentially poisonous
and can burn.
x Physical damage to the vehicle or the high-voltage battery can result in immediate or
delayed release of poisonous gases that can also cause a fire.
x Always avoid contact with leaking fluids and gases escaping from the battery, particularly
one that has been damaged.
x Always tell emergency responders that the vehicle has a high-voltage battery.
WARNING
Driver distraction causes accidents and serious personal injury. Using the instrument cluster
or accessing Infotainment System menus while driving can take your attention off the road
and cause accidents.
x To help reduce the risk of accidents and injuries, never change settings in the instrument
cluster display or use Infotainment System functions unless the vehicle is standing still.

Warning messages
When the ignition is switched on, several warning and indicator lights come on briefly for a function
check. They go out after a few seconds.
Warning lights and text messages are shown in the instrument cluster display. Acoustic warnings may
also sound at the same time.

Lights up Warnings in the instrument cluster
display ⇒  Proper response
∋ Error: Hybrid system
Park vehicle!
Stop the vehicle in a safe place as soon as
it is safe to do so.
*∋ Error: Hybrid system
Contact dealer now!
See an authorized Volkswagen dealer or an
authorized Volkswagen Service Facility.
*∋ Hybrid system:
Vehicle still ready to drive.
–
Hybrid system currently
not available.
Never leave the vehicle parked in the ready
position. Remove the remote control vehicle
key out of the ignition or, for vehicles with
Keyless Access, press the starter button.
Restart engine! Start the engine with the ignition switch or
starter button.
Hybrid battery charging
...Leave engine running!
While this message appears, do not stop
the engine.

Warning when leaving the vehicle
Switch off the ignition before leaving the vehicle unattended . In certain situations, a message
Ignition on appears in the instrument cluster display as you are leaving the vehicle. This message
warns you that the vehicle's electric drive is still enabled and that the combustion engine might start
automatically.
Always switch the ignition off, remove the key, and take it with you when leaving the vehicle ⇒ . As
a reminder to do so, the combustion engine may start automatically under the following conditions:
x The ignition is switched ON.
x AND: Electrical drive is functional (Ready).
x AND: The transmission is in Park (P) or Neutral (N).
x AND: The driver safety belt is not fastened OR The driver door is open.
The message in the instrument cluster display also reminds you to switch the ignition off. In addition,
always be sure to apply the parking brake, remove the key, and take it with you when leaving the
vehicle.
WARNING
A parked vehicle that is not properly parked can roll away and cause accidents or severe
injuries. When leaving the vehicle, always move the selector lever into Park (P) and engage
the parking brake.

x Press the CAR Infotainment button.
x Tap a function key on the screen to view the information described below.

Function key Function
Driv.
data
Since Start Display of fuel consumption, speed, route, travel time, and range
from the time the ignition was switched on until the time it was
switched off.
Long-term Display of total fuel consumption, speed, route, travel time, and
range.
Energy flow Shows the energy flow between the engine, high-voltage battery,
and driving wheels .
Zero Emission Displays the emission-free driving time as a bar graph. Each bar
represents 1 minute of driving. The height of the bar indicates the
proportion of emission-free driving in %.
A full bar, or 100% ⇒ fig. 117 (1), is a 1 minute interval of
emission-free hybrid driving or sailing.
No bar, or 0% (2), is a 1 minute interval driving only with the
combustion engine.
The display shows the emissions for a maximum of 30 minutes.
Tapping Reset resets all values on this graph to zero.

You can always go back to the previously active menu by pressing the