2013 TOYOTA HILUX engine

598
5-2. Steps to take in an emergency
HILUX_OM_OM0K134E_(EE)
If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the
vehicle in the normal way, stop the vehicle using the following pro-
cedure:
Steadily step on the brake pedal with both feet and firmly
depress it.
Do not pump the brake pedal repeatedly as this will increase the
effort required to slow the vehicle.
Shift the shift lever to N.
If the shift lever is shifted to N
After slowing down, stop the vehicle in a safe place by the
road.
Stop the engine.
If the shift lever cannot be shifted to N
Keep depressing the brake pedal with both feet to reduce
vehicle speed as much as possible.
Stop the engine by turning the
engine switch to the “ACC”
position.
Stop the vehicle in a safe place by the road.
STEP1
STEP2
STEP3
STEP4
STEP3
STEP4
STEP5

5
599 5-2. Steps to take in an emergency
When trouble arises
HILUX_OM_OM0K134E_(EE)
CAUTION
If the engine has to be turned off while driving
Power assist for the brakes and steering wheel will be lost, making the
brake pedal harder to depress and the steering wheel heavier to turn.
Decelerate as much as possible before turning off the engine.
Never attempt to remove the key, as doing so will lock the steering wheel.

605 6-1. Specifications
6
Vehicle specifications
HILUX_OM_OM0K134E_(EE)Double-cab models
Gross
vehicle
mass4WD
models
1KD-FTV
engine
Left-hand
drive
vehicles2720 kg (5967 lb.)*1
2730 kg (6019 lb.)*2
Right-
hand drive
vehicles3080 kg (6790 lb.)
2KD-FTV
engine
Left-hand
drive
vehicles2680 kg (5908 lb.)*1
2690 kg (5930 lb.)*2
Right-
hand drive
vehicles3040 kg (6702 lb.)
Pre Runner
2600 kg (5732 lb.)
Maxi-
mum per-
missible
axle
capacity
1KD-
FTV
engine
Left-hand
drive vehiclesFront 1340 kg (2954 lb.)
Rear 1600 kg (3527 lb.)
Right-hand
drive vehiclesFront 1340 kg (2954 lb.)
Rear 1900 kg (4189 lb.)
2KD-
FTV
engine
Left-hand
drive vehiclesFront 1280 kg (2822 lb.)
Rear 1600 kg (3527 lb.)
Right-hand
drive vehiclesFront 1280 kg (2822 lb.)
Rear1600 kg (3527 lb.)*3
1900 kg (4189 lb.)*4
Drawbar load
115 kg (254 lb.)
Towing
capacityWithout brake
750 kg (1654 lb.)
With brake2790 kg (6151 lb.)*5
2800 kg (6173 lb.)*6

607 6-1. Specifications
6
Vehicle specifications
HILUX_OM_OM0K134E_(EE)Engine number
The engine number is stamped on the engine block as shown.

608 6-1. Specifications
HILUX_OM_OM0K134E_(EE)
Engine
1KD-FTV engine
2KD-FTV engine
Model1KD-FTV
Ty p e4 cylinder in line, 4 cycle, diesel (with turbo-
charger)
Bore and stroke 96.0  103.0 mm (3.78  4.06 in.)
Displacement 2982 cm3 (182.0 cu.in.)
Valve clearance
(engine cold)Intake: 0.20  0.30 mm (0.008  0.012 in.)
Exhaust: 0.35  0.45 mm (0.014  0.018 in.)
Drive belt tensionAutomatic adjustment
Model2KD-FTV
Ty p e4 cylinder in line, 4 cycle, diesel (with turbo-
charger)
Bore and stroke 92.0  93.8 mm (3.62  3.69 in.)
Displacement 2494 cm3 (152.2 cu.in.)
Valve clearance
(engine cold)Intake: 0.20  0.30 mm (0.008  0.012 in.)
Exhaust: 0.35  0.45 mm (0.014  0.018 in.)
Drive belt tensionAutomatic adjustment

610 6-1. Specifications
HILUX_OM_OM0K134E_(EE)
Lubrication system (except for Russia and Ukraine)
*: The engine oil capacity is a reference quantity to be used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Toyota
recommends the use of approved “Toyota Genuine Motor Oil”.
Another motor oil of matching quality can also be used.
Oil grade: ACEA C2
Oil capacity
(Drain and refill
reference
*)
With filter
Without filter6.9 L (7.3 qt., 6.1 Imp.qt.)
6.6 L (7.0 qt., 5.8 Imp.qt.)
NOTICE
Using engine oil other than ACEA C2 may damage the catalytic converter.

611 6-1. Specifications
6
Vehicle specifications
HILUX_OM_OM0K134E_(EE)Recommended viscosity (SAE):
SAE 0W-30 is filled into your
Toyota vehicle at manufacturing,
and the best choice for good fuel
economy and good starting in
cold weather.
Oil viscosity (0W-30 is explained here as an example):
• The 0W in 0W-30 indicates the characteristic of the oil which allows
cold startability. Oils with a lower value before the W allow for easier
starting of the engine in cold weather.
• The 30 in 0W-30 indicates the viscosity characteristic of the oil when
the oil is at high temperature. An oil with a higher viscosity (one with a
higher value) may be better suited if the vehicle is operated at high
speeds, or under extreme load conditions.
Temperature range anticipated before
next oil change.
Preferred

612 6-1. Specifications
HILUX_OM_OM0K134E_(EE)
Lubrication system (for Russia and Ukraine)
*: The engine oil capacity is a reference quantity to be used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Toyota
recommends the use of approved “Toyota Genuine Motor Oil”.
Another motor oil of matching quality can also be used.
Oil grade: ACEA B1, API CF-4 or CF
(You may also use API CE or CD.)
Oil capacity
(Drain and refill
reference
*)
With filter
Without filter6.9 L (7.3 qt., 6.1 Imp.qt.)
6.6 L (7.0 qt., 5.8 Imp.qt.)