2013 TOYOTA AURIS HYBRID sport mode

22Pictorial index
UK_AURIS/AURIS_HV_EE (OM12F76E)
Except hybrid model
Power heater switch* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 408
Stop & Start cancel switch
* . . . . . . . . . . . . . . . . . . . . . . . . . P. 363
Sport mode switch
*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 285
“Es” switch
* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 290
Seat heater switches
*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 477
1
2
3
4
5

32Pictorial index
UK_AURIS/AURIS_HV_EE (OM12F76E)
Except hybrid model
Sport mode switch*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 285
Stop & Start cancel switch
* . . . . . . . . . . . . . . . . . . . . . . . . . P. 363
“Es” switch
* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 290
Seat heater switches
*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P. 477
1
2
3
4

1182. Instrument cluster
UK_AURIS/AURIS_HV_EE (OM12F76E)
The indicators inform the driver of the operating state of the vehicle’s
various systems.
Indicators
Turn signal indicator
(P. 305)*1
(Green)
Smart entry & start sys-
tem indicator (P. 266)
Headlight high beam
indicator
(P. 308)
*1
(Green)
Speed limiter indicator
(P. 337)
*1Front fog light indicator
(P. 320)*1, 2, 3Automatic High Beam
indicator (P. 316)
Rear fog light indicator
(P. 320)
*1, 2, 3“AFS OFF” indicator
(P. 312)
*1, 2Gear Shift Indicator
(P. 291)*1“SPORT” indicator
(P. 285)
*1
(Green)
Cruise control indicator
(P. 332)*1, 2
Stop & Start indicator
(P. 362)
Engine preheating indi-
cator (diesel engine)
(P. 262, 266)
*1, 2Stop & Start cancel indi-
cator (P. 362)
*2VSC OFF indicator
(P. 370)*1Cruise control “SET”
indicator (P. 332)
*1, 2, 3, 4 Slip indicator
(P. 369, 374)*1, 2, 3 “TRC OFF” indicator
(P. 370)
*1Shift position and gear
position indicators
(P. 284)Power mode indicator
(hybrid model)
(P. 300)

1392. Instrument cluster
UK_AURIS/AURIS_HV_EE (OM12F76E)
2
Instrument cluster
Drive monitor display
Multi-information display
The settings can be changed by pressing the “DISP” button.
(P. 133)
Operation of Eco Driving Indicator
Eco Driving Indicator will not operate in the following conditions:
The shift lever is in any position other than D.
Paddle shift switch
* is operated.
Sport mode is selected.
The vehicle speed is approximately 130 km/h (80 mph) or higher.
*: If equipped
Eco Driving Indicator Light customization
Eco Driving Indicator Light can be activated or
deactivated by pressing the display change
button when the Eco Driving Indicator Light
customization display is displayed.
To change the Eco Driving Indicator Light cus-
tomization display, display the odometer and
press and hold the display change button until
the display changes.
After customization, press the display change
button for more than 2 seconds to return to the
odometer.

2284-1. Before driving
UK_AURIS/AURIS_HV_EE (OM12F76E)
Multi-mode manual transmission
With the brake pedal depressed, firmly set the parking brake and
shift the shift lever to E or M.
When shifting the shift lever to E: Make sure that the display of the gear
position indicator shows E.
When shifting the shift lever to M: Make sure that the display of the gear
position indicator shows 1.
Gently depress the accelerator pedal.
Release the parking brake.
Manual transmission
With the parking brake firmly set and the clutch pedal fully
depressed, shift the shift lever to 1.
Lightly depress the accelerator pedal at the same time as gradually
releasing the clutch pedal.
Release the parking brake.
When starting off on an uphill (vehicles with a hill-start assist control)
The hill-start assist control is available. (P. 374)
Driving in the rain
Drive carefully when it is raining, because visibility will be reduced, the win-
dows may become fogged-up, and the road will be slippery.
Drive carefully when it starts to rain, because the road surface will be espe-
cially slippery.
Refrain from high speeds when driving on an expressway in the rain,
because there may be a layer of water between the tires and the road sur-
face, preventing the steering and brakes from operating properly.
Engine speed while driving (vehicles with a Multidrive)
In the following conditions, the engine speed may become high while driving.
This is due to automatic up-shifting control or down-shifting implementation to
meet driving conditions. It does not indicate sudden acceleration.
The vehicle is judged to be driving uphill or downhill
When the accelerator pedal is released
When the brake pedal is depressed while sport mode is selected
1
2
3
1
2
3

2404-1. Before driving
UK_AURIS/AURIS_HV_EE (OM12F76E)
NOTICE
If you get a flat tire while driving
A flat or damaged tire may cause the following situations. Hold the steering
wheel firmly and gradually depress the brake pedal to slow down the vehi-
cle.
It may be difficult to control your vehicle.
The vehicle will make abnormal sounds or vibrations.
The vehicle will lean abnormally.
Information on what to do in case of a flat tire (P. 640, 653)
When encountering flooded roads
Do not drive on a road that has flooded after heavy rain etc. Doing so may
cause the following serious damage to the vehicle:
Engine stalling
Short in electrical components
Engine damage caused by water immersion
In the event that you drive on a flooded road and the vehicle is flooded, be
sure to have any authorized Toyota dealer or repairer, or another duly quali-
fied and equipped professional check the following:
Brake function
Except hybrid model: Changes in quantity and quality of engine oil, trans-
mission fluid, etc.
Hybrid model: Changes in quantity and quality of engine oil, hybrid trans-
mission fluid, etc.
Lubricant condition for the bearings and suspension joints (where possi-
ble), and the function of all joints, bearings, etc.
Hybrid model: If the P position control system is damaged by flooding, it
may not be possible to shift the shift position to P, or from P to other posi-
tions. When the shift position cannot be changed from P to any other posi-
tion, the front wheels will lock, and you will be unable to tow the vehicle with
the front wheels on the ground, as the front wheels may be locked. In this
case, transport the vehicle with both front wheels or all four wheels lifted.

2854-2. Driving procedures
UK_AURIS/AURIS_HV_EE (OM12F76E)
4
Driving
*1: To improve fuel efficiency and reduce noises, set the shift lever in D for
normal driving.
*2: Selecting gear step using the M position achieves suitable engine braking
forces by operating the shift lever.
Press the switch.
For powerful acceleration and driv-
ing in mountainous regions.
Press the switch again to return to
normal mode.
Shift position purpose
Shift positionObjective or function
PParking the vehicle/starting the engine
RReversing
NNeutral
D
Normal driving*1
Gear step selection (P. 286)
(paddle shift switches activated)
M7-speed sport sequential shiftmatic mode driving*2
(P. 287)
Sport mode

2874-2. Driving procedures
UK_AURIS/AURIS_HV_EE (OM12F76E)
4
Driving
To enter 7-speed sport sequential shiftmatic mode, shift the shift lever
to M. Gear steps can then be selected by operating the shift lever or
paddle shift switches (vehicles with a paddle shift switch), allowing
you to drive in the gear step of your choosing.
Upshifting
Downshifting
The gear changes once every time
the shift lever or paddle shift switch
is operated.
The selected gear step, from M1 to
M7, will be displayed in the meter.
*1: Vehicles without a multi-informa-
tion display
*2: Vehicles with a multi-information
display
However, even when in the M position, the gear steps will be auto-
matically changed if the engine speed is too high, or too low.
Gear step functions
You can choose from 7 levels of engine braking force.
A lower gear step will provide greater engine braking force than a higher
gear step, and the engine speed will also increase.
If the 7-speed sport sequential shiftmatic mode indicator does not come
on even after shifting the shift lever to M
This may indicate a malfunction in the Multidrive system. Have the vehicle
inspected by any authorized Toyota dealer or repairer, or another duly quali-
fied and equipped professional immediately.
(In this situation, the transmission will operate in the same manner as when
the shift lever is in D.)
When the vehicle comes to a stop with the shift lever in the M position
The transmission will automatically downshift to M1 once the vehicle is
stopped.
After a stop, the vehicle will start off in M1.
When the vehicle is stopped, the transmission is set at M1.
Changing gear steps in the M position
*1*2
1
2