2013 SSANGYONG TURISMO radio

09-4
2. CAUTIONS
The parking aid system is just a supplemental device to help your parking.
Always keep the safety precautions.
Do not press or shock the sensors by hitting or using a high-pressure water gun while washing,
since it may damage the sensors.
If the system is in normal operating condition, a short beep sounds when the shift lever is moved
into "R" position with the ignition key "ON".
If the system is defective, the warning buzzer sounds for 3 seconds when moving the gear shift
lever to “R” position with the ignition ON. Be careful not to confuse this and the parking aid
alarm (in 50 cm). 1.
2.
3.
4.
5.
- Note that the display does not show everything in the rear area. Always check
nobody, especially animals and children, is behind the vehicle when parking or
reversing.
- If you can not properly check the vehicle behind, get out of the vehicle and then
visually check it.
The parking aid system will not work or improperly work under following cases: ▶
1) Certain obstacles that sensors can not detect
Thin and narrow objects, such as wires, ropes, chains
Cotton, sponge, clothes, snow; that absorb ultrasonic waves
Obstacles lower than the bumper (ex. drain ditch or mud puddle) -
-
-
2) Not defective but improperly working
When the sensing portion is frozen (operates normally after thawed)
When the sensing portion is covered by rain, water drops, snow or mud (operates normally after
cleaned)
When receiving other ultrasonic signals (metal sound or air braking noises from heavy commercial
vehicles)
When a high-power radio is turned on -
-
-
-
3) Narrowed sensing area
When the sensing portion is partially covered by snow or mud (operates normally after cleaned)
Surrounding temperature of sensor is too high (approx. over 80°C) or too low
(approx. below -30°C) -
-
4) Not defective but may cause malfunction
When driving on the rough roads, gravel road, hill and grass
When the bumper height is changed due to heavy load
When the sensing portion is frozen
When the sensing portion is covered by rain, water drops, snow or mud
When receiving other ultrasonic signals (metal sound or air braking noises from heavy commercial
vehicles)
When a high-power radio is turned on
When some accessories are attached in detecting ranges -
-
-
-
-
-
-

11-38910-05
1. SPECIFICATION
1) Audio Head Unit
Item Specification
Audio Voltage DC 14.4V
Operating voltage DC 10.8V~16.0V
Output 45W/1ch 4ch
Current consumption 5 A or less Up to 10 A
Leakage current 3 mA or less
Radio Frequency FM: 87.5~108MHz
AM: 531~1602KHz
MW: 522~1620KHZ
LW: 144~290KHZ
Preset FM1: 6ch
FM2: 6ch
AM: 6ch
MW : 6ch
LW : 6ch
Usable sensitivity AM: 25dBu
FM: 10dBu
S/N raito (limit value) AM: 54dB
FM: 60dB
LCD Type FSTN
Operating voltage 9.0V VDD: 3.0~3.3V
Operating temperature-30℃ ~ +80℃
Operating temperature-40℃ ~ +85℃
Size (W x H) 132X36
Bluetooth Component MD-5XR (Bluetooth multimedia module)
Application technologyBluetooth 2.0+EDR (Enhanced Data Rate)
Specification Supports HFP, A2DP, AVRCP profile formats
(HFP, A2DP: profile for calling)
(AVRCP: profile for listening music)

11-6
Radio antenna specification changed
Changed to micro pole antenna from glass antenna (with radio antenna amplifier)

11-8
Front door speaker
2. LAYOUT
Handsfree microphoneSteering wheel switch
1. OVERVIEW
The audio head unit is fitted with the Bluetooth handsfree for convenience. And, it has a micro pole
antenna and its own integrated amplifier to improve the radio frequency reception rate and to provide
the high-quality sound.
Audio head unitFront tweeter speakerUSB/AUX jack assembly

11-10
USB/AUX jack
assembly
Sends USB signal and AUX
(stereo) output signal.Handsfree microphone
It sends the transmission tone
signal to the head unit and
outputs the receiving tone to the
driver's door speaker during
handsfree calling.Steering wheel switch
Outputs the signal when
power, mode, volume
up/down, handsfree, seek
up/down, mute switch is
operated.
3. OPERATION PROCESS
Audio head unit
The audio system plays a various
types of music such as radio,
MP3, CD and USB. It has a built-
in high output amplifier, allowing
to provide the high-quality sound.
Micro pole antenna
Micro pole radio antenna is fitted
to ensure the high sensitivity.
(Glass antenna removed)Bluetooth handsfree
Once the pairing is complete, after
searching for the Bluetooth phone,
you can use a various functions and
contents in the phone via Bluetooth.

11-12
1) Audio Head Unit
4. SWITCH OPERATION AND FUNCTION
No. Name Description
1 Display window Displays operation status and various information
2 BAND/AS buttonSelects the radio function or band (press : FM1 → FM2→ MW
→ LW → FM1 → ....), to store stations automaticall
y (press and
hold)
3 SCAN/INF button Scan in each station automatically, enter the file search mode
(press); switch the display items (press and hold).
4 CALL button Receive the incoming a call (press); connect the Bluetooth device
(press and hold).
5 END button End a call (press); release the Bluetooth connection (press and
hold).
6 SEEK button Find a station manually or skip a track (press); seek a station
automatically or up/down for file searching, fast-forward/rewind a
track(press and hold).

11-138910-05
No. Name Description
7 RDS button Seek the specified program type or traffic program station (press),
enter the RDS (Radio Data System) menu (press and hold).
8 SET button Enters the setting mode (EQ style, Tone and Bluetooth).
9 Disc slot Insert a disc (label side up), playback starts.
10 CD button Select the CD, USB, AUX or Bluetooth Audio playback.
11 Disc EJECT[ ]button Ejects the disc.
12 Number [1 to 6 D+]
buttonsStore each station (press and hold), receive each stored stations or
select the CD/USB playback as below (press);
2 RPT: Repeat playback
3 INT: Intro playback
4 RDM: Random playback
5 D-: Folder down
6 D+: Folder up
13 POWER/MUTE button
with VOLUME [VOL]
dialTurn the power on, turn the radio mute or CD/USB pause playback
on/off (press), tune the power off (press and hold); adjusts the
volume (rotate).
14 ENTER button with
TUNE dialEnters the track/file search mode, select the item for
setting/searching; find a station manually or skip a track (rotate);
up/down for track/file searching.

11-14
2) LCD Screen Description
Radio function ▶
Preset channel number
RDS indicator 1.
2.Stereo indicator
Band indicator
Multi-function display area
Disc indicator
Media indicator
CDP - lights up when an audio CD is loaded.
MP3 - lights up when a MP3 file is loaded.
WMA - lights up when a WMA file is loaded. 3.
4.
5.
6.
7.
CD/MP3/WMA mode ▶
Current folder (directory) number
Current file (track) number
USB indicator
Folder select mode indicator
Playback mode indicators
RPT (Repeat), INT (Intro), RDM (Random) 8.
9.
10.
11.
12.Bluetooth function indicator
Playing time
EQ (Equalizer) indicator
POP, ROCK, COUNTRY, VOICE, JAZZ,
CLASSIC 13.
14.
15.
TP lights up when a TP (Traffic Program)
station is tuned in.
TA lights up when TA (Traffic Announcement
standby) function is on.
REG lights up when a REG (Regional) station
is tuned in.
AF lights up when AF (Alternative
Frequencies search) function is on. -
-
-
-