2013 SSANGYONG KORANDO warning

Tail lamp ON warning
The driver door is opened with the tail lamp ON and ACC or IGN OFF (ignition key removed).
The internal buzzer (chime) sounds for 10 seconds (T2) at intervals of 1.4 seconds (T1). A.
B. Operation 1.
The tail lamp switch is turned OFF while the internal buzzer (chime) is activated, or the driver door is
closed.
The internal buzzer (chime) is deactivated immediately. C.
D. Operation 2.
6. TAIL LAMP CONTROL
The 2 operations stated above are not available after the ignition is turned ON. E. Operation 3.
The sunroof and ignition key reminder warnings override this function.
If the tail lamp switch is turned ON from OFF while the internal buzzer (chime) is activated, the
buzzer sounds again. -
-

Door ajar warning lamp
7. DOOR AJAR WARNING LAMP CONTROL
When the door ajar signal is input while the vehicle is driven at 10 km/h or less (V2).
The door ajar warning lamp comes on. A.
B. Operation 1.
The door ajar warning lamp is ON.
The vehicle is driven at 10 km/h or more (V1) for 2 seconds or longer (T1).
The door ajar warning lamp starts to flash. C.
D.
E. Operation 2.
The warning lamp remains on when the vehicle speed decreases to 10 km/h or less (V2). F. Operation 3.
(The warning lamp flashes under the condition of operation 2.)
Operation 4.
The door ajar warning lamp flashes.
The lamp goes out when the open door is closed.
The lamp flashes again whenever a door is opened. G.
H.
I.The door ajar warning lamp goes out when the open door is closed under the condition stated
above. -
The door ajar warning lamp goes out when the open door is closed under the condition stated
above. -

Seat belt internal buzzer (chime) and warning lamp
The ignition is turned ON from OFF with the driver and passenger seat belts unbuckled.
The internal buzzer (chime) sounds and the warning lamp comes on for 6 seconds (T2).
(internal buzzer controlled by BCM, warning lamp controlled by instrument cluster) A.
B. Operation 1.
The ignition is turned ON from OFF with the driver and passenger seat belts unbuckled.
The internal buzzer (chime) does not sound but the warning lamp comes on for 6 seconds (T2).
(The seat belt reminder is operated when the vehicle is driven at 10 km/h (for EU), 25 km/h (for GEN)) C.
D. Operation 2.
When the fastened driver seat belt is unbuckled with IGN ON.
The internal buzzer (chime) sounds and the driver seat belt warning lamp comes on for T2 again. E.
F. Operation 3.
The ignition is turned OFF while the internal buzzer (chime) and seat belt warning lamp are activated.
The internal buzzer (chime) and seat belt warning lamp are deactivated. G.
H. Operation 4.
8. SEAT BELT CONTROL
The driver seat belt is fastened while the internal buzzer (chime) and seat belt warning lamp are
activated.
The internal buzzer (chime) does not sound but the warning lamp comes on for the time remaining. I.
J. Operation 5.
When the seat belt reminder operation conditions are met during the warning, the seat belt reminder
is operated after stopping the warning output.
For the passenger seat, however, the system detects if the passenger seat is empty or occupied
and operates the warning lamp only for the first time. After that, the only seat belt reminder detects if
the passenger seat is occupied. -
-

Seat belt reminder operation
A
BIf the seat belt is fastened after the seat belt reminder is activated, the output of the reminder is
turned OFF immediately. The reminder will be operated again whenever the seat belt is
unbuckled.
CWhen the seat belt reminder is activated initially with the seat belt unbuckled, the internal buzzer
(chime) is turned ON for 0.02 seconds and then turned OFF for 1.18 seconds (this cycle
continues for 5 minutes) and the driver seat belt warning lamp on the instrument cluster remains
on.
DWhen the seat belt reminder is activated with the seat belt unbuckled, the internal buzzer (chime)
is turned ON for 0.02 seconds and then turned OFF for 1.18 seconds (this cycle continues for 5
minutes) and the passenger seat belt warning lamp on the instrument cluster remains on, after
detecting that the passenger seat is occupied through the input value of the passenger seat
occupancy sensor.
EWhen the vehicle speed is changed while the seat belt reminder is turned on, the internal buzzer
(chime) is operated as follows:
FPriority of internal buzzer (chime) operation
(Seat belt reminder > ignition key reminder > sunroof warning > tail lamp warning > hazard
warning flasher on > turn signal indicator)GEN
The seat belt reminder is operated when the
vehicle is driven at 25 km/h or more with IGN
ON and alternator in High status (engine
running), and driver seat belt is not fastened. If
the vehicle speed is decreased to less than 25
km/h within 5 minutes after the seat belt
reminder is activated, the internal buzzer
(chime) is turned off. If the vehicle speed is
increased to 25 km/h or more, the buzzer
signal is output for 5 minutes. Only EU If the driver and passenger seat belts are not
fastened with the ignition switch ON, engine
running, vehicle speed above 10 km/h and
any passenger occupied, the seat belt
reminder is activated. In addition, even though
the vehicle speed reduces to below 10 km/h
after the reminder is activated at speed of 10
km/h or higher, it will remain activated.
Vehicle speedFunction
Remarks
Interior buzzerInstrument
cluster
25 Km/h to 49 Km/h
(10km/h~49km/h)0.02 sec. ON / 1.18 sec. OFF Remains on (Only EU)
50 Km/h to 99 Km/h 0.02 sec. ON / 0.98 sec. OFF Remains on
100 km/h or more 0.02 sec. ON / 0.78 sec. OFF Remains on

The driver door is opened with the sunroof open and IGN OFF and ACC ON (ignition key
removed).
The internal buzzer (chime) sounds for 10 seconds (T1). A.
B. Operation 1.
The driver door and sunroof is closed while the internal buzzer (chime) is activated.
The internal buzzer (chime) is deactivated.
(The internal (chime) buzzer is not activated again after the operation 1, and it is activated again when
the operation 1 is performed after the ignition is turned ON) C.
D. Operation 2.
9. SUNROOF WARNING LAMP CONTROL
The sunroof open warning (T2) overrides the tail lamp ON warning (T3). E. Operation 3.

8710-01
REKES key switch description
Door LOCK (locks the doors and tailgate when pressed briefly) 1.
All doors and the tailgate are locked and the theft deterrent mode is activated.
When the theft deterrent mode is activated, the hazard warning lamp flashes twice. When this
button is pressed once more within 4 seconds, the hazard warning lamp flashes twice and the
buzzer sounds once. -
-
Panic (Press and hold for 2 seconds or more) 3.
If this button is pressed for 2 seconds or more, the hazard warning lamp flashes while the buzzer
sounds for approx. 30 seconds.
If the door LOCK button or panic button is pressed, this function is deactivated. -
- Door UNLOCK (unlocks the doors and tailgate when pressed briefly) 2.
If this button is pressed briefly, all doors and the tailgate are unlocked and the theft deterrent
mode is deactivated.
When the theft deterrent mode is deactivated, the hazard warning lamp flashes once.
In theft deterrent mode, if a door, tailgate or engine hood is not opened within 30 seconds after
the door is unlocked by a remote controller, the doors are locked with the hazard warning lamp
and buzzer activated (lamp flashes twice and buzzer sounds once, the theft deterrent mode is
activated again). -
-
-
13. REMOTE KEYLESS ENTRY SYSTEM (REKES)
REKES key (Transmitter)
When the user operates the switch of the REKES key, the vehicle control message formatted by the
remote controller CPU is sent to the main part via radio transmission. The CPU of the main part controls
the vehicle and the main part controls the vehicle operations.
Door LOCK
Door UNLOCK
Panic
The escort function is activated with the headlamp ON for 20 seconds when the door LOCK button
is pressed for 0.5 seconds or more in the theft deterrent mode. If the door LOCK button is pressed
briefly or the ignition is turned ON during the escort operation, the escort is deactivated.

AUTO UNLOCK upon receiving air bag deployment signal
Air bag deployment signal is not input for initial 7 seconds (T4) after IGN ON A. Operation 1.
Signal from unlock relay is output for 5 seconds (T3) after 40 ms (T2)
When turning IGN OFF during 5 seconds (T3) of unlock relay signal output
Signal from unlock relay is input for the rest of the time B.
C.
D.
E. Operation 2.
The room lamp comes on when the air bag deployment signal is input except when the room lamp
switch is turned off.
The hazard warning lamp flashes when the air bag deployment signal is input.
Resetting the auto door unlock function turns off the battery (cutting off BCM power). -
-
-
The door LOCK/UNLOCK relay is installed inside the actuator.

REKES key panic alarm (for vehicles without SKM)
The REKES key panic signal is received.
The hazard warning lamp and warning horn are activated for 30 seconds (T1) at intervals of 0.5 sec.
ON/0.5 sec. OFF. A.
B. Operation 1.
The hazard warning lamp and warning horn are activated by REKES panic function.
The REKES panic LOCK and panic signals are received.
The panic function is interrupted and other functions are activated by the corresponding command. C.
D.
E. Operation 2.
The theft deterrent alarm is activated.
The panic function is interrupted and theft deterrent alarm is set. F.
G. Operation 3. (during operation 1)
15. PANIC ALARM CONTROL
The panic alarm functions regardless of the ignition status. -