2013 SSANGYONG KORANDO horn

8710-01
Theft deterrent mode (for vehicles with SKM)
Battery power
Front/rear door open
Tailgate open
4 doors LOCK/UNLOCK
Hood open -
-
-
-
- The BCM monitors the following conditions continuously in theft deterrent mode.
Theft deterrent alarm activation (for vehicles with SKM)
Any door including hood and tailgate is opened in theft deterrent mode.
The LOCK switch of any door including tailgate is set to UNLOCK in theft deterrent mode.
Any door including tailgate and hood is closed and then opened after 30 seconds of alarming.
The hazard warning lamp and warning horn are activated for 30 seconds at intervals of 0.5 sec.
ON/0.5 sec. OFF. -
-
-
-
Theft deterrent alarm deactivation conditions (for vehicles with SKM)
The theft deterrent alarm is deactivated in the following conditions. The theft deterrent mode is kept
ON.
a. Door LOCK/UNLOCK signal by smart key is received.
b. Tailgate open signal by smart key is received.
c. UNLOCK signal by door switch is received.
d. Tailgate open switch signal is received.
e. IGN ON signal is received.
f. Panic function is activated.
When the ignition is turned ON while the theft deterrent alarm is activated, the alarm is deactivated
immediately.
When the theft deterrent alarm is activated in theft deterrent mode, turning the ignition ON
immediately deactivates the mode. The alarm is deactivated 30 seconds (time remaining) after that.
If no deactivation command is received, the system enter the theft deterrent mode after the 30
seconds. -

-
-
-
Theft deterrent mode re-activation after tailgate open (for vehicles with SKM)
All doors except the tailgate are in theft deterrent mode, the system searches for the smart key inside the
vehicle 1 second after the tailgate is closed. If no smart key is found, the system enters the theft
deterrent mode again.
The hazard warning lamp and warning horn are activated when the system enters the mode.

Theft deterrent alarm deactivation (for vehicles with/without SKM)
The system is in theft deterrent mode.
The conditions for theft deterrent alarm are met.
The hazard warning lamp flashes and the warning horn is activated. A.
B.
C. Operation 1.
The theft deterrent alarm is activated.
The conditions for deactivation of theft deterrent alarm are met.
The hazard warning lamp and warning horn are deactivated.
The theft deterrent alarm is deactivated because the conditions are not met, and the system enters
the theft deterrent mode. D.
E.
F.
G. Operation 2.

Priority of BCM buzzer control
23. BUZZER CONTROL
External buzzer
(SKM buzzer)Internal buzzer (chime)Warning horn
Internal buzzer (chime)

Horn (high) Horn (low)
Theft deterrent horn
Theft deterrent horn
4) Horn Switch
Two horns are installed in the radiator grille at the bottom of both sides (one on each side). There is
another horn installed at the bottom of the battery tray side in the engine compartment for theft alarm.
Operating the horn switch on the steering wheel applies the power to the horn relay to operate both
horns (Dual horn). The theft deterrent horn is controlled by the BCM in armed mode regardless of the
horn relay operation.
Horn (dual horn)
Horn switch

4) Basic Inspection
(1) Horn operation
Listen for the horn sound when pressing the horn pad on the steering wheel. -
(2) Brake operation
Check if there is any abnormal noise, unusually long braking distance, or uneven braking force. If the
brake warning lamp does not go out even after starting the engien or are flashing during driving,
have the brake system checked immediately.
Check the brake pipes and hoses for connection, oil leak, crack or interference after changing the
position of tires. When replacing the tires, check the brake disc for surface condition and wear.
Check the parking brake cable and brake operation. Shorten the checking interval if the parking
brake is used frequently. -
-
-
(3) Exhaust system
Be aware to any changes in sound or smell from the exhaust system. These may be caused by leak or
overheat. Have the exhaust system checked and repaired immediately.
Inspect the exhaust system including catalytic converter. Inspect all the components and body frame
near the exhaust system. -
-
(4) Tires
Unusual vibration of the steering wheel and seats or pulling to one side on the straight and level roads
may indicates the uneven tire inflation pressure or poor wheel balance. -
(5) Steering and suspension system
Inspect the front and rear suspension and the steering system for damage, looseness or missing
parts, signs of wear or lack of lubrication. Inspect the power steering line and the hoses for
connection, leak, crack and chafing. Inspect the drive axle boot and seals for damage, tear or leak.
Replace or repair the system if necessary. -
(6) Engine oil
Check the oil level when the engine is still warm and add the specified engine oil if necessary. -
(7) Coolant
Check the coolant level in the coolant reservoir, coolant conditions (contamination, foreign material),
and hoses for damage and leak. Replace or add the Ssangyong genuine coolant, if needed. -
(8) Engine drive belt
Check all drive belts on the engine for wear, crack and looseness. Retighten or replace the belt, if
needed. -