Page 24 of 226
Fog lightsFirst read and observe the introductory information and safety warn-
ings
on page 14.
The indicator light lights up when the fog lights are switched on.
For further information, see » page 43.
Cruise control system
First read and observe the introductory information and safety warn-
ings
on page 14.
The indicator light
lights up when the cruise control system is active.
For further information, see » page 114.
Selector lever lock
First read and observe the introductory information and safety warn-
ings
on page 14.
If the warning light
lights up, operate the brake pedal. This is necessary, to be
able to move the selector lever from position P or N » page 103 .
Main beam
First read and observe the introductory information and safety warn-ings
on page 14.
The indicator light
lights up when the main beam or headlamp flasher is
switched on.
For further information, see » page 43.
21Instruments and Indicator Lights
Page 46 of 226
Turn signal and main beamFig. 22
Operating lever: Turn signal and
main beam operation
First read and observe the introductory information and safety warn-
ings on page 41.
Lever positions » Fig. 22
Switch on right turn signal
Switch on left turn signal
Switch on main beam (spring-tensioned position)
Switch on main beam or headlamp flasher (spring-loaded position)
The parking light can also be controlled with the control lever » page 45.
The main beam can only be switched on when the low beam lights are on.
When the high beam or headlight flasher is on, the warning light
lights up in
the instrument cluster.
When the left or right turn signal is on, the warning light
or
flashes in the
instrument cluster.
“Convenience turn signal”
If you only wish to flash three times, briefly push the lever to the upper or lower
pressure point and release again.
Turn signal for changing lanes - to only flash briefly, only move the lever up or
down to the pressure point and hold it in this position.
WARNINGOnly turn on the main beam or the headlight flasher if other road users will
not be dazzled.ABCDNote■ The headlight flasher can be operated even if the ignition is switched off.■The turn signal light switches itself off automatically when driving around a
curve or after making a turn.■
The warning light flashes at twice its normal rate if a bulb for the turn signal
light fails.
Fog lights
Fig. 23
Light switch
First read and observe the introductory information and safety warn-
ings on page 41.
Switching on/off
›
Turn the light switch to position
or
» Fig. 23 .
›
Pull the light switch to position
1
.
The rear fog light is switched off in the reverse order.
The warning light
lights up in the instrument cluster when the fog lights are
switched on » page 14.
Fog lights with CORNER function
First read and observe the introductory information and safety warn-
ings
on page 41.
The CORNER function lights the front fog lamp on each side of the vehicle to illu-
minate the area around the vehicle when turning, parking, etc.
43Lights and visibility
Page 205 of 226
Replacing bulb for main beam, daytime running lights and
parking lightFig. 172
Bulbs for main beam, daytime running lights, and parking light
First read and observe the introductory information and safety warn-
ings
on page 200.
Removing/replacing the bulb for main beam and separate daytime running
lights
›
Remove the rubber cover
2
or
5
» Fig. 170 on page 201.
›
Turn the bulb holder
A
» Fig. 172 as far as it goes in the direction of the arrow
and remove it.
›
Replace the bulb, insert the bulb holder with the new bulb and turn in the oppo-
site direction to that of the arrow as far as it goes.
›
Insert the rubber cover
2
.
Removing/replacing the bulb for the parking light
›
Remove the rubber cover
2
or
5
» Fig. 170 on page 201.
›
Remove the bulb holder with the bulb by jiggling it out in the direction of the
arrow
1
» Fig. 172 .
›
Remove the faulty bulb from the bulb holder
B
in the direction of the arrow.
›
Insert a new bulb in the bulb holder up to the stop.
›
Replace the bulb holder in the headlamp with the bulb.
›
Insert the rubber cover
2
.
Changing the front turn signal bulbFig. 173
Principle sketch: Headlight with halogen bulb/headlight with xenon
bulb
First read and observe the introductory information and safety warn-ings
on page 200.
›
Turn the socket with the bulb » Fig. 173 as far as it will go in the direction of the
arrow and then remove it.
›
Remove the bulb, insert the socket with the new bulb and turn in the opposite direction to that of the arrow to the stop.
202Do-it-yourself
