2013 RENAULT KANGOO fuel consumption

83A-9
AFTER REPAIRCheck for correct operation.
V1 MR-376-X76-83A000$020.mif
INSTRUMENT PANEL INSTRUMENTS
Fault finding – System operation83A
Oil pressure warning light
When the ignition is switched on, the oil pressure warning light illuminates.
When the engine is running and the oil pressure is sufficient, the warning light goes out.
The oil pressure signal is transmitted to the instrument panel by a wire connection.
The signal is produced by the oil pressure switch.
3. ODOMETER
Total mileage
The total mileage is displayed as soon as the ignition is switched on.
Press the Trip computer scroll button or the Reset button to move to the next page.
Trip mileage
The trip mileage is displayed instead of the total mileage when the Trip computer or the Reset button is pressed
briefly.
Except in the following cases:
– it is reset by a long press of the instrument panel Reset button,
– resetting the trip mileage is different from resetting the trip computer (distance travelled).
Trip computer
The various sequences of the trip computer can be displayed instead of the mileage by pressing the button at the
end of the wiper stalk (Trip computer button). It is reset by a long press of the Reset button.
The signals from the trip computer are displayed after the trip mileage as follows:
–Fuel consumed (in litres per 100 km) since the last reset,
–Average consumption (in litres per 100 km) since the last reset.
This is only displayed after the vehicle has travelled 400 m.
This takes into consideration the distance covered and the fuel consumption since the last time the reset button was
pressed.

83A-10
AFTER REPAIRCheck for correct operation.
V1 MR-376-X76-83A000$020.mif
INSTRUMENT PANEL INSTRUMENTS
Fault finding – System operation83A
Estimated range with remaining fuel (in km).
This is only displayed after the vehicle has travelled approximately 400 m. This is the potential distance remaining
calculated on the basis of distance travelled, amount of fuel remaining in the tank and fuel consumption.
Note :
The range is no longer displayed 3 minutes after the low fuel level warning light illuminates.
–Distance travelled since the last reset.
–Average speed since the last reset.
This is displayed after the vehicle has travelled 400 m. It is obtained by dividing the distance travelled by the time
elapsed since the last reset. The time base is internal to the on-board computer.
HANDBRAKE APPLIED AND BRAKING CIRCUIT FAULT DETECTED WARNING LIGHT
– Handbrake switch.
– Low brake fluid switch.
– Electronic braking distribution fault (ONLY WITH ABS).

83A-13
AFTER REPAIRCheck for correct operation.
V1 MR-376-X76-83A000$030.mif
83A
CONNECTOR (24-track grey)
The 24-track grey connector is fitted only on the MG and HG versions.
*CPE: Electric central door lockingTracks Description
1Not used
2Not used
3Not used
4Not used
5Fuel level signal
6Not used
7 Not used
8Not used
9Not used
10Not used
11Oil pressure warning light
12Door open warning light (with electric central door locking*)
Rabbet switch signal (without electric central door locking*)
13Brake fault warning light
14Not used
15Not used
16Anti-lock braking system indicator light
17Not used
18Not used
19Fuel consumption info signal
20Not used
21Not used
22Not used
23Not used
24Not used
INSTRUMENT PANEL INSTRUMENTS
Fault finding – Allocation of computer tracks