2013 RENAULT KANGOO air condition

38C-49
AFTER REPAIRClear the computer memory using command RZ001 Fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V1 MR-376-X76-38C000$170.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault Finding Chart38C
ABS BOSCH 8.1
Vdiag No.: 18
ALP3 Pull
NOTESOnly address this customer complaint after a complete check with the diagnostic
tool.
Disconnect one wheel speed sensor.
Start the engine and ensure that only the ABS fault warning light comes on. Do not drive the vehicle if the brake
fault warning light is also illuminated because the "braking compensator" function is no longer guaranteed.
Carry out a road test with the ABS thus out of order.
Is the fault still present under these conditions?
Raise the vehicle so that you can rotate the wheels and check:
– whether the speed sensors have been incorrectly
connected,
– whether the pipes on the hydraulic unit have been inverted.
For these two tests, consult and apply the procedures defined
in ALP2 Locking of one or several wheels.
Check the condition and conformity of the ABS targets.
If the fault is still present, contact the techline.If the brake pedal travel is relatively long,
bleed the brake circuit.
If the travel is normal, check the tyre
pressures, the front axle, or for any leaks in
the circuit.
NOYES
ABS8.1X76_V18_ALP3

38C-50
AFTER REPAIRClear the computer memory using command RZ001 Fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V1 MR-376-X76-38C000$170.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault Finding Chart38C
ABS BOSCH 8.1
Vdiag No.: 18
ALP4 Drift
NOTESOnly address this customer complaint after a complete check with the diagnostic
tool.
Disconnect one wheel speed sensor.
Start the engine and ensure that only the ABS fault warning light comes on. Do not drive the vehicle if the brake
fault warning light is also illuminated because the "braking compensator" function is no longer guaranteed.
Carry out a road test with the ABS thus out of order.
Is the fault still present under these conditions?
Normal behaviour linked to the system operation during
the regulation phase, mainly on surfaces with uneven
grip or which are poorly laid.Road holding fault not related to the ABS.
Check the condition of the brake linings and that
they are to specification and check the tyre
pressures, the front axle, etc.
NOYES
ABS8.1X76_V18_ALP4

38C-57
AFTER REPAIRClear the computer memory using command RZ001 Fault memory.
Carry out a road test followed by another check with the diagnostic tool.
V1 MR-376-X76-38C000$170.mif
ANTI-LOCK BRAKING SYSTEM
Fault finding – Fault Finding Chart38C
ABS BOSCH 8.1
Vdiag No.: 18
ALP11 Noise from the pump, pipes or hydraulic unit
NOTESOnly address this customer complaint after a complete check with the diagnostic
tool.
– Vibration of the unit: check the presence and the condition of the unit support insulating rubber mountings.
– Vibration of pipes: check that all the pipes are securely clipped in their retaining clips and that there is no contact
between pipes or between pipes and bodywork.
To identify the origin of the noise, use the solenoid valve control commands AC003 Front left-hand wheel
solenoid valves, AC004 Front right-hand wheel solenoid valves, AC005 Rear left-hand wheel solenoid
valves and AC006 Rear right-hand wheel solenoid valves while depressing the brake pedal.
ABS8.1X76_V18_ALP11