2013 RENAULT CLIO CUP display

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-23

B.6.4.3 Turning off the engine

Flick the “IGNITION” switch to the down (OFF) posit ion

NOTE : The vehicle’s electrics remain switched on
Except in the event of an emergency stop, it’s stri ctly not advised to turn off the
engine using the power supply switch (OFF button).
It is also recommended to wait 30seconds between sw itching off the engine and
switching off the power supply.
Respecting these two recommendations will guarantee optimum operation of the power
steering.
B.6.4.4 Switching off the power supply

Press the “OFF” button of the facia switch panel an d hold there for at least half a second.
The dashboard display is switched off.
NOTE: Switching off the power supply also switches off th e engine.

B.6.4.5 Changing gears

2 modes are possible and are completely independent . It’s possible to make randomly
upshift and downshift manually (using the lever) or in semi-auto using paddle shift kit.

Please refer to Chapter D-Transmission/shifting for a complete description of the shifting
modes.
B.6.4.6 Pit limiter

The purpose of this function is to limit the vehicl e's speed to 60kph
. It is enabled and
disabled by the driver.
Principle:
By pressing the button “PIT” of the steering wheel, Engine revs are thus limited (by the
ECU) to those corresponding to a speed of 60kph and the message “PIT LIMITER” is
displayed on the dashboard in the RPM Area :

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-24

If the pit limiter is activated while the current s peed is > 60kph, all the Shiftlights flashes
together till the vehicle reach 60kph (at this part icular moment, all shiftlights remains ON
but without flashing)


NOTE
: The speed limiter does not control the brakes. Cons equently, the vehicle speed
will only slow rapidly to 60kph if the driver appli es the brakes.

To disable the pit limiter mode, the driver has to press the button “PIT” of the steering
wheel : the message “ Pit Limiter” disappears on the display.

Specific conditions:
The driver may only enable and disable the speed li miter when the vehicle is in on a
forward gear (1 to 4)
B.6.4.7 Controlling the rain light

The rain light is switched on by flicking the “rain ” switch to the up position (ON).

The central rear rain light is ON continuously whe n enabled.

However, it is lightning automatically with flashin g phases (flashes at 0.5Hz) in the
following specific situations: - When the Pit limiter is enabled
- For a period of 20 seconds after the engine stall s
- When Reverse Gear ratio is shifted

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-25

B.6.4.8 Resetting the chassis sensors

This procedure allows to reset the following sensor s:
- Front Brake pressure sensor
- Rear brake pressure sensor
- Steering angle sensor
It is necessary to make a reset if one of the follo wing sensor has been changed or if the
brake circuit has been bleeded.
CONDITIONS :


The car must be in the following configuration to a llow the procedure:
- Engine stalled
- Gearbox in Neutral
- Speed = 0 kph
- Brake pedal released
- Steering wheel straight
- Car on a flat surface · Press the “ON” button to power supply the car
· Display the “brake diagnostic” page
· Press the “RESET” button, the following message app ears :

· press again the “RESET” button gain to start the pr ocedure or “PAGE” button
(steering wheel) to cancel it

· Check in the “brake diagnostic” page that the value of :
Front BP = 0 bar
Rear BP = 0 bar
Steering angle = 0 °

This page only reminds
the conditions to
perform the RESET
procedure