2013 Ram 2500 belt

•Low brake vacuum (e.g. after several brake pedal
applications)
• STOP/START OFF switch is pressed
• 4WD system is put into 4LO mode
• The emissions system requires it
• A STOP/START system error occurs
Conditions that force an automatic shift to PARK while
in Autostop mode:
The Engine Will Not Start Automatically and the Trans-
mission will be placed in PARK if:
• The driver door is open and brake pedal released
• The driver door is open and the driver seat belt is
unbuckled •
The engine hood has been opened
• A STOP/START system error occurs
The engine may then be restarted by moving the trans-
mission shift selector out of PARK (e.g. to DRIVE) or, in
some cases, only by a KEY START. The Electronic Vehicle
Information Center (EVIC) will display a SHIFT OUT OF
PARK message, or a STOP/START KEY START RE-
QUIRED message, to indicate which action is required.
Refer to “Electronic Vehicle Information Center (EVIC)”
in “Understanding Your Instrument Panel” for further
information.
5
STARTING AND OPERATING 349

WARNING!
Always wear your seat belt and firmly tie down
cargo. Unsecured cargo can become projectiles in an
off-road situation.
When To Use Low Range
When driving off-road, shift into 4L (Low Range) for
additional traction or to improve handling and control on
slippery or difficult terrain. Due to the lower gearing, low
range will allow the engine to operate in a higher power
range. This will allow you to idle over obstacles and
down hills, with improved control and less effort. Also,
use 4L (Low Range) in rain, ice, snow, mud, sand, to get
heavy loads rolling, improve traction, or whenever 4H
(High Range) traction will not do the job.
Driving In Snow, Mud And Sand
There is a drastic reduction in traction when driving in
snow, mud or sand. The vehicle will be less responsive to
steering, acceleration and braking inputs. Therefore you
should accelerate slowly, leave greater stopping distances
and avoid abrupt vehicle maneuvers. You want to keep a
slow constant steady pace. The key is to maintain the
vehicle’s momentum.
•Snow – In heavy snow or for additional control and
traction at slower speeds, shift the transmission to a
low gear and shift the transfer case to 4L (Low Range)
if necessary. Do not shift to a lower gear than necessary
to maintain headway. Over-revving the engine can
spin the wheels and traction will be lost. If you start to
slow to a stop, try turning your steering wheel no more
than a ¼ turn quickly back and forth, while still
applying throttle. This will allow the tires to get a fresh
bite and help maintain your momentum.
5
STARTING AND OPERATING 425

CAUTION!
•It is essential when replacing the cables on the
battery that the positive cable is attached to the
positive post and the negative cable is attached to
the negative post. Battery posts are marked positive
(+) and negative (-) and are identified on the
battery case. Cable clamps should be tight on the
terminal posts and free of corrosion.
• If a “fast charger” is used while the battery is in the
vehicle, disconnect both vehicle battery cables be-
fore connecting the charger to the battery. Do not
use a “fast charger” to provide starting voltage.
Air Conditioner Maintenance
For best possible performance, your air conditioner
should be checked and serviced by an authorized dealer
at the start of each warm season. This service should
include cleaning of the condenser fins and a performance
test. Drive belt tension should also be checked at this
time.
CAUTION!
Do not use chemical flushes in your air conditioning
system as the chemicals can damage your air condi-
tioning components. Such damage is not covered by
the New Vehicle Limited Warranty.
648 MAINTAINING YOUR VEHICLE

To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution fol-
lowed by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with MOPAR® Glass Cleaner, or any commercial
household-type glass cleaner. Never use an abrasive type
cleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or the right rear
quarter window equipped with the radio antenna. Do
not use scrapers or other sharp instrument that may
scratch the elements.When cleaning the rear view mirror, spray cleaner on the
towel or rag that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
7
MAINTAINING YOUR VEHICLE 673

If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the car to
wash them. Dry with a soft cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
Tri-Fold Soft Tonneau Cover Care
For cleaning and protecting the vinyl Tri-Fold Tonneau
cover, use MOPAR® Whitewall & Vinyl Top Cleaner and
MOPAR® Leather and Vinyl Conditioner/Protectant.
Spray-On Bedliner – If Equipped
During ownership, the shine and luster of the Spray-On
Bedliner can fade from oxidation, road dirt, heavy-duty
hauling and hard water stains. Weathering and UV
exposure will lead to fading, dulling, and loss of gloss
over time.
To help maintain the appearance of your Spray-On
Bedliner, the manufacturer recommends you periodicallyrinse all loose dirt from your truck bed and clean your
truck at least twice per year using the MOPAR®
Spray-On Bedliner Conditioner available at your local
authorized dealer.
To Help Maintain The Appearance Of Your Spray-On
Bedliner, Follow The Steps Below:
1. Rinse your truck bed out with water to remove any
loose dirt and debris.
2. Mix a mild soap or detergent with water with a soft cloth or brush.
3. Rinse bedliner with water.
4. Once dry, apply a small amount of MOPAR® Spray-On Bedliner Conditioner to a moist towel or
sponge and wipe over the entire surface of the truck
bedliner.
674 MAINTAINING YOUR VEHICLE

Fluid Level Check...................... .665
Fluid Type ........................... .665
Shifting ............................. .364
Special Additives ...................... .666
Axle Fluid ............................. .663
Axle Lubrication (Axle Fluid) .................663
Back-Up Camera ......................... .189
Bar, Stabilizer/Sway System ..................420
Battery ................................ .647
Keyless Transmitter Replacement (RKE) ........29
Belts, Seat ...............................50
Body Builders Guide ........................6
Body Mechanism Lubrication .................649
B-Pillar Location ......................... .493
Brake Assist System ...................... .474
Brake Control System, Electronic ..............473
Brake Fluid ............................ .661
Brake System ........................... .470Anti-Lock (ABS)
....................... .471
Fluid Check .......................... .661
Master Cylinder ....................... .661
Parking ............................. .468
Warning Light ........................ .257
Brake/Transmission Interlock .................354
Bulb Replacement ........................ .686
Bulbs, Light ............................ .120
Cab Top Clearance Lights ...................693
Camera, Rear ........................... .189
Camper ............................... .242
Capacities, Fluid ......................... .696
Caps, Filler Oil (Engine) .......................... .645
Power Steering ........................ .467
Radiator (Coolant Pressure) ................657
Carbon Monoxide Warning ..................117
Cargo Light ............................ .166
10
INDEX 723

Immobilizer (Sentry Key)....................18
Infant Restraint ...........................82
Inflation Pressure Tires .....................508
Inside Rearview Mirror .....................127
Instrument Cluster ....................... .255
Instrument Panel and Controls ................253
Instrument Panel Lens Cleaning ...............673
Integrated Trailer Brake Controls ..............553
Interior Appearance Care ....................672
Interior Lights .......................... .163
Intermittent Wipers (Delay Wipers) .............169
Introduction ..............................4
Inverter Outlet (115V) ..................... .210
Jack Location ........................... .578
Jump Starting ........................... .617
Key-In Reminder ..........................18
Keyless Enter-N-Go ........................38 Keyless Entry System
.......................23
Key, Programming .........................20
Key, Replacement ..........................19
Keys ...................................12
Key, Sentry (Immobilizer) ....................18
Lane Change and Turn Signals ................167
Lane Change Assist ....................... .168
Lap/Shoulder Belts .........................50
Latches ............................... .120
Lead Free Gasoline ....................... .526
Leaks, Fluid ............................ .120
Life of Tires ............................ .506
Light Bulbs ............................. .120
Lights ................................ .120
Airbag ................................72
Alarm .............................. .260
Anti-Lock ............................ .255
Anti-Lock Warning ..................... .472
10
INDEX 729

Automatic Headlights....................158
Brake Assist Warning ....................484
Brake Warning ........................ .257
Bulb Replacement ...................... .687
Cap Top Clearance ..................... .693
Cargo .............................. .166
Center Mounted Stop ....................692
Check Engine (Malfunction Indicator) .........255
Courtesy/Reading ..................... .164
Daytime Running ...................... .159
Electronic Stability Program (ESP) Indicator .....484
Exterior ............................. .120
Fog ................................ .162
Four-Wheel Drive Indicator ................391
Hazard Warning Flasher ..................577
Headlights ........................... .158
High Beam ........................... .168
High Beam Indicator .....................259
High Beam/Low Beam Select ...............168Hill Descent Control Indicator
..............479
Illuminated Entry ........................22
Instrument Cluster ..................... .255
Interior ............................. .163
Oil Pressure .......................... .260
Passing ............................. .168
Seat Belt Reminder ..................... .259
Security Alarm (Theft Alarm) ...............260
Service .............................. .686
Side Marker .......................... .695
SmartBeams .......................... .160
Theft Alarm (Security Alarm) ...............260
Tire Pressure Monitoring (TPMS) ............260
Traction Control ....................... .484
Transfer Case ......................... .391
Turn Signal .......................... .120
W

arning (Instrument Cluster Description) ......255
Limited-Slip Differential ....................441
Loading Vehicle ......................... .536
730 INDEX