Safety.............................. .487
Sizes ............................... .488
Snow Tires ........................... .502
Spinning ............................ .505
Tread Wear Indicators ....................505
Tire Safety Information .....................487
Tongue Weight/Trailer Weight ................549
Tonneau Cover .......................... .674
Tonneau Cover Cleaning ....................674
Torque Converter Clutch ....................376
Tow Hooks, Emergency .....................623
Towing ............................... .539
Disabled Vehicle ....................... .628
Guide .............................. .545
Recreational .......................... .566
Weight .............................. .545
Traction ............................... .442
Traction Control ......................... .474
Trailer Sway Control (TSC) ..................485 Trailer Towing
.......................... .539
Cooling System Tips .....................561
Hitches ............................. .544
Minimum Requirements ..................550
Mirrors ............................. .135
Trailer and Tongue Weight .................549
Wiring .............................. .558
Trailer Towing Guide ...................... .545
Trailer Weight ........................... .545
Transfer Case ........................... .665
Electronically Shifted .....................392
Fluid ............................... .700
Transmission ........................... .355
Automatic ........................... .355
Fluid ............................... .700
Maintenance .......................... .665
Shifting ............................. .352
T
ransmitter Battery Service (Remote Keyless Entry) . .29
Transmitter Programming (Remote Keyless Entry) . . .23
10
INDEX 737
INSTALLATION OF RADIO TRANSMITTING EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
