Page 16 of 336
14
LIGHTING
Ring A
Lighting off.
Automatic illumination of headlamps.
Sidelamps.
Dipped / main beam headlamps.
Rear foglamp.
Ring B
100
91, 92 Raise or lower the lighting stalk passing
the point of resistance; the corresponding
direction indicators will fl ash until the stalk is
moved from this position.
DIRECTION INDICATORS
"Motorway" function
Press the lighting stalk up or down once,
without passing the point of resistance; the
corresponding direction indicators will fl ash
three times.
The use of this function is available regardless
of the speed, but you will fi nd it particularly
useful when changing lane on fast roads.
WINDSCREEN WIPERS
2.
Fast wipe.
1.
Normal wipe.
I.
Intermittent wipe.
0.
Park.
AUTO È
Automatic wipe or single wipe.
Wash-wipe: pull the stalk towards you.
98
Switching on "AUTO"
)
Press the stalk down and release it.
Switching off "AUTO"
)
Push the stalk up and return it to
position "0"
. 102
Page 17 of 336
FAMILIARISATION
MONITORING
The instrument panel has permanent back-
lighting for improved visibility in all situations,
both day and night.
- With the ignition on, the fuel gauge needle
should indicate the level of fuel remaining.
- With the engine running, its associated
low level warning lamp should go off.
- With the ignition on, the oil level indicator
should display "OK" or "correct",
depending on version, for a few seconds.
If the levels are not correct, top up the levels
which are low.
INSTRUMENT PANEL
62
22
- With the ignition on, the orange and red
warning lamps come on.
- With the engine running, these warning
lamps should go off.
If warning lamps remain on, refer to the page
concerned.
WARNING LAMPS
26 Illumination of the indicator lamp indicates the
status of the corresponding function.
A.
Emergency call.
SWITCH PANEL
57 202, 203
107
143
202, 203
B.
Deactivation of the interior volumetric and
anti-tilt sensors (alarm).
C.
Central locking.
D.
Deactivation of the ESC/ASR system.
E.
Deactivation of the front and rear parking
sensors.
F.
Access to PEUGEOT services.
Page 27 of 336
1/
INSTRUMENTS and CONTROLS
Vehicle parameters
This menu allows you to activate or deactivate certain driving and
comfort equipment:
- vehicle speed repeat,
- selective unlocking (refer to the "Access" section),
- guide-me-home and welcome lighting (refer to the "Visibility" and
"Ease of use and comfort" sections),
- interior mood lighting (refer to the "Ease of use and comfort" section),
- daytime running lamps (refer to the "Visibility" section),
- directional headlamps (refer to the "Visibility" section),
- rear parking sensors (refer to the "Driving" section).
Choice of language
This menu allows you to select the language used by the display:
Deutsch, English, Espanol, Français, Italiano, Nederlands, Portugues,
Pусский, Portugues-Brasil, Türkçe * .
Choice of units
This menu allows you to select the units: temperature (°Celsius or
°Fahrenheit) and fuel consumption (l/100 km, mpg or km/l).
*
According to country.
Page 32 of 336
30
Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the
corresponding system has come into operation.
It may be accompanied by an audible signal.
Depending on your version of instrument panel, illumination of the
indicator lamp may also be accompanied by:
- a symbol in the central instrument panel screen and a message in
the multifunction screen,
or
- a symbol and a message in the central instrument panel screen.
Warning lamp
is on
Cause
Action / Observations
Left-hand
direction
indicato
r
fl ashing with
buzzer. The lighting stalk is pushed
down.
Right-hand
direction indicator
fl ashing with
buzzer. The lighting stalk is pushed up.
Hazard warning
lamps
fl ashing with
audible signal. The hazard warning lamps
switch, located on the dashboard,
has been operated. The left-hand and right-hand direction indicators and their
associated indicator lamps fl ash simultaneously.
Sidelamps
fi xed. The lighting stalk is in the
"Sidelamps" position or the
"AUTO" position with low light.
Dipped beam
headlamps
fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position or in the "AUTO" position
in conditions of low light.
Main beam
headlamps
fi xed. The lighting stalk is pulled
towards you. Pull the stalk again to return to dipped beam
headlamps.
Page 34 of 336
32
Deactivation warning lamps
If one of the following warning lamps comes on, this confi rms that the
corresponding system has been switched off intentionally.
It is accompanied by an audible signal and a message on the screen.
Depending on your version of instrument panel, illumination of the
deactivation lamp is also accompanied by:
- a symbol in the central instrument panel screen and a message in
the multifunction screen,
or
- a symbol and a message in the central instrument panel screen.
Warning lamp
is on
Cause
Action / Observations
Passenger's
front airbag
fi xed, in the seat
belt and front
passenger's
airbag warning
lamps display. The control switch, located
on the passenger's end of
the dashboard, is set to the
OFF
position.
The passenger's front airbag is
deactivated.
You can install a "rear-facing"
child seat on the front seat. Before installing a "rear-facing" child seat on the front seat,
it is essential
to deactivate the passenger's front airbag.
On the other hand, where no "rear-facing" child seat is
present, it is recommended that the airbag be reactivated:
set the control to the ON
position.
ESC/ASR
fi xed. The button, located in the centre
of the dashboard, is pressed. Its
indicator lamp is on.
The following functions are
deactivated.
- electronic stability
programme (ESC),
- anti-slip regulation or traction
control (ASR),
- automatic operation of
hazard warning lamps. Press the button again to reactivate these functions
manually. Its indicator lamp goes off.
These functions are reactivated automatically when the
vehicle is started.
Page 47 of 336
1/
INSTRUMENTS and CONTROLS
With the Peugeot Connect Sound (RD5) switched on, once this menu
has been selected you can confi gure your Bluetooth hands-free system
(pairing), consult the various telephone directories (calls log, services...)
and manage your communications (pick up, hang up, call waiting,
secret mode...).
For more information on the "Telephone" application, refer to the
Peugeot Connect Sound (RD5) section.
"TELEPHONE" MENU
*
According to country.
Display configuration
Once this menu has been selected, you have access to the following
settings:
- brightness-video setting,
- date and time setting,
- choice of units.
Choice of language
Once this menu has been selected, you can change the language
used by the display (Deutsch, English, Espanol, Français, Italiano,
Nederlands, Portugues, Portugues-Brasil, Türkçe * ).
For safety reasons, confi guration of the multifunction screen by
the driver must only be done when stationary.
Page 48 of 336
46
RETRACTABLE COLOUR SCREEN (WITH
PEUGE
OT CONNECT NAVIGATION (RT6))
DISPLAYS IN THE SCREEN
Displays according to context:
- time,
- date,
- altitude,
- ambient temperature (the value displayed fl ashes if there is a risk of
ice),
- parking sensor information,
- audio functions,
- telephone and contacts information,
- satellite navigation system information,
- alert messages,
- menus for settings of the screen, navigation system and vehicle
equipment.
From the navigation system control panel, to select one of the
applications:
)
press the dedicated "RADIO"
, "MUSIC"
, "NAV"
, "TRAFFIC"
,
"PHONE"
or "SETUP"
button for access to the corresponding
menu,
)
turn dial A
to select a function, an item in a list,
)
press button B
to confi rm the selection,
or
)
press the "Back"
button to abandon the current operation and
return to the previous display.
For more information on these applications, refer to the "Audio
equipment and telematics" section.
CONTROLS
Page 50 of 336
48
RETRACTABLE COLOUR SCREEN (WITH
PEUGEOT CONNECT MEDIA NAVIGATION (NG4 3D))
DISPLAYS IN THE SCREEN
Displays according to context:
- time,
- date,
- altitude,
- ambient temperature (the value displayed fl ashes if there is a risk of
ice),
- parking sensor information,
- audio functions,
- telephone and address book information,
- satellite navigation system information.
- display screen or navigation system parameter settings menus.
From the Peugeot Connect Media Navigation (NG4 3D) control panel,
to select one of the applications:
)
press the dedicated "RADIO"
, "MEDIA"
, "NAV"
, "TRAFFIC"
,
"ADDR BOOK"
or "SETUP"
button for access to the
corresponding menu,
)
turn dial A
to select a function, an item in a list,
)
press button B
to confi rm the selection,
or
)
press the "Back"
button to abandon the current operation and
return to the previous display.
CONTROLS
For more information on these applications, refer to the
Peugeot Connect Media Navigation (NG4 3D) section.
