Page 19 of 332
.
17
Familiarisation
Driving safely
Stop & Start
Going into engine STOP mode
93
The "ECO"warning lamp comes
on in the instrument panel and the
en
gine goes into standby:
Going into engine START mode
Deactivation
/ Reactivation
You can deactivate the system at any time bypressing the "ECO OFF"
button; the button's
warning lamp comes on.
94
94
, 95
The system is automatically reactivated every time the engine is star ted withthe key.
Before refuelling or doing anything under the bonnet, you must switch off the ignition with the key. Th
e "ECO"
warning lamp goes off
and the engine restar ts:
-with a manual gearbox, when you press
the clutch pedal,-with an electronic gearbox:●
with the gear lever in position A
or M,
when you release the brake pedal,
●
or with the gear lever in position N
andbrake pedal released, when you move thegear lever to position A
or M,●
or when you engage reverse.
-with a manual gearbox
, at speeds below
12 mph (20 km/h), when you put the gear lever into neutral, and you release theclutch pedal,
-
with an electronic gearbox
, at speeds
below 5 mph (8 km/h), when you press the
brake pedal or you put the gear lever into position N .
In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off. In certain circumstances,
STOP mode may not
be available; the "ECO"warning lamp flashes
for a few seconds, then goes off.
Page 22 of 332
20
Familiarisation
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in thebottom of the boot, as close as possible to the rear seats.
Limit the loads carried in the vehicle and reduce wind resistance (roof bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.
Remove roof bars and roof racks after use.
At the end of winter, remove snow tyres and refit your summer tyres.
Observe the recommendations on
maintenance
Check the tyre pressures regularly, when cold, referring to the label in the door aperture, driver's side. Carry out this check in par ticular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.
Have your vehicle ser viced regularly (engine oil, oil filter, air filter...) andobser ve the schedule of operations recommended by the manufacturer.
When refuelling, do not continue after the third cut-off of the nozzle to
avoid any overflow.
At the wheel of your new vehicle, it is only after the first 1 800 miles (3 000 kilometres) that you will see the fuel consumption settle down toa consistent average.
Page 195 of 332
193
8
Checks
Operation
When a petrol filler nozzle is introduced into the
fuel filler neck of your Diesel vehicle, it comes
into contact with the flap. The system remainsclosed and prevents filling.
Do not persist but introduce a Diesel type filler nozzle.
Misfuel prevention (Diesel) *
Mechanical device which prevents filling the tank of a Diesel vehicle with petrol. It avoids the risk of engine damage that can result from filling with the
wrong fuel.
Located in the filler neck, the misfuel prevention device appears when the filler cap is removed.
*
Accordin
g to country of sale.
It remains possible to use a fuel can tofill the tank. In order to ensure a good flow of fuel,do not place the nozzle of the fuel can in direct contact with the flap of the misfuel prevention device and pour slowly.
Tr a v e l l i ng abroad
As Diesel fuel pump nozzles may be different in other countries, thepresence of the misfuel prevention device may make refuelling impossible.
Before travelling abroad, werecommend that you check with the PEUGEOT dealer network, whether your vehicle is suitable for the fuel pumps in the country in which you want to travel.