Page 45 of 332
1
43
Instruments and controls
LCD instrument panel
) Press this button to display the following settings successively:
- hours,
- minutes,
- 12 or 24 hour format.
Setting the date and time
Press MENU
to display the MAIN MENUthen select " Preferences".Select "Date & Time".
Select the date or time displa
yed, use the keypad to adjust the setting, then "Confirm".
Touch screen
Select "System configuration".
Page 51 of 332
49
2
Access
Secondary control
doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Inser t the key in the lock to lock or unlock the door.
Passenger doors
)On the rear doors, check that the child lock
is not on. )Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aper ture without forcing, then without turning, move the
latch sideways towards the inside of thedoor.
)Remove the key and refit the cap.
Changing the battery
Battery ref.: CR1620 / 3 volts.
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Remote control problem
Reinitialisation
)
Switch off the ignition. )
Turn the key to position 2 (Ignition). )
Press the closed padlock immediately for a
few seconds. ) Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle. ) First of all, use the key in the lock to unlock
or lock your vehicle. ) Then, reinitialise the remote control.
I
f the problem persists, contact a PEUGEOT
dealer as soon as possible.
If the batter
y is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen. ) Unclip the cover using a screwdriver in thecutout. )
Remove the cover. )
Extract the flat battery from its location.
)
Place the new battery into its location
observing the original direction. ) Clip the cover in place.
Page 65 of 332
63
3
Comfort
Steering wheel adjustment
)When stationary, pull the control lever to yrelease the adjustment mechanism. )Adjust the height and reach to suit your
driving position. )Push the control lever to lock theadjustment mechanism.
As a safety precaution, these operations should only be carried out while the vehicle is stationary.
Correct driving
position
Before taking to the road, carry out these adjustments in the following order:
- lon
gitudinal position and height of the
driver's seat,
- hei
ght of the driver's seat head restraint,
- height and reach of the steering wheel.
Once these adjustments have been made,ensure that you can see the instrumentpanel clearly from your driving position.
Page 76 of 332
74
Comfort
Additional USB port
Depending on version, your vehicle may be fitted with a second USB por t, located on thecentre console.
When in use, the USB por t / Jack auxiliary
socket must not be used to charge a
por table device (risk of overload).
USB port / Jack auxiliary socket
This connection box, consisting of a JACKauxiliary socket and a USB por t, is located on
the centre console.
It allows the connection of por table device, such as a digital audio player of the iPod ®type
or a USB memory stick.
It reads the audio files which are transmitted toyour audio system and played via the vehicle's speakers.
You can manage these files using the steeringmounted controls or the audio system controlpanel and display them in the instrument panelscreen.
When the USB por t is used, the por table device
charges automatically.
For more information on the use of thissystem, refer to the "Audio equipmentand telematics" section.
Page 84 of 332
82
Driving
Gear shift indicator *
Operation
The system inter venes only when driving economically.
Depending on the driving situation and your
vehicle's equipment, the system may advise you to skip one or more gears. You can follow this instruction without engaging the intermediate gears.The gear engagement recommendations mustnot be considered compulsory. In fact, the configuration of the road, the amount of trafficand safety remain determining factors whenchoosing the best gear. Therefore, the driver remains responsible for deciding whether or not
to follow the advice given by the system.
This function cannot be deactivated.
* According to engine.
- You are in third
gear.
Exam
ple on a vehicle fitted with a manual
gearbox:
- You press the accelerator pedal
moderatel
y.
- The s
ystem may suggest that you engage a higher gear, if appropriate.
The information appears in the
instrument panel in the form of an
arrow, accompanied b
y the suggested gear for the manual gearbox.
On vehicles fitted with an electronic gear control or automatic gearbox, thesystem is only active in manual mode.
The system never suggests:
- engaging first gear,
- engaging reverse gear,
- engaging a lower gear. S
ystem which reduces fuel consumption by advising the driver to change up.
Page 86 of 332
84
Driving
Display in the instrument panel
Gear lever positions
N. Neutral R. Reverse1, 2, 3, 4, 5. Gears in manual mode AUTO.
This comes on when the automatedmode is selected. It switches off on changing to manual mode.
)
Select position N
.
Moving off
N
flashes in the instrument panelscreen if the gear lever is not inposition N
on starting.
)
Place your foot on the brakewhen this warning lamp flashes(e.g.: star ting the engine).
There is an audible signal on engagement of reverse.
When moving off on a slope, accelerate gradually while releasing the parking brake.
)
Select first gear (position Mor A
) or Areverse (position R)R )
Release the parking brake.
AUTO
and 1
or R
appear in theinstrument panel.
Stopping - Moving off on a slope
When stopping on a slope, do not use the
accelerator to immobilise the vehicle; apply the
parking brake.
Manual mode
AUTOdisappears and the gearsengaged appear in succession in the
instrument panel.
)After star ting the vehicle, select position Mto change to manual mode.
The
gear change commands are only carried
out if the engine speed permits.
When driving at low speed, on approachinga stop sign or traffic lights for example,
the gearbox changes down to first gear
automatically.
You must press the brake pedal while star tin
g
the engine.
Automated mode
)Following use of manual mode, selectposition A
to return to automated mode.
AUT
Oand the gear engaged appear
in the instrument panel.
The gearbox then operates in auto-adaptive
mode, without any action on the par t of the
driver. It continuously selects the most suitable gear for:
- optimisation of fuel consumption,
- the drivin
g style,
- the road conditions,
- t
he vehicle load.
)Progressively take your foot off
the brake pedal, then move off.
)Press the brake pedal fully.
Nappears in the instrument panel.
)
Star t the engine.
Page 87 of 332
85
4
Driving
Never select neutral N
while the vehicleis moving. Only engage reverse gear Rwhen thevehicle is immobilised, with your foot on the brake pedal. In all cases, you must apply the parkingbrake to immobilise the vehicle.
"Au t o s equential" mode
In automated mode, you can resume control
temporarily at any time using the steeringmounted control paddles.
The use of these paddles permits manual
selection of the gears in situations which
require a more rapid change-down than in
the automated mode (arrival at a roundabout,leaving a car park with a steep gradient,
over taking...).
The gearbox engages the required gear if
the engine speed permits. AUTO
remains
displayed in the instrument panel.
After a few moments, the gearbox resumes
automatic control of the gears.
Stopping the vehicle
Before switching off the engine, you canchange to position N to be in neutral.
In this case,
you must apply the parking braketo immobilise the vehicle.
AUTO
and -appear in the instrument panel.
Operating fault
With the ignition on, if this warninglamp comes on and AUTOflashes, accompanied by an audible signal
and a message in the screen, this indicates a gearbox fault.
Have it checked by a PEUGEOT dealer or a qualified workshop.
For best acceleration, when over taking another vehicle for example, press the accelerator pedal firmly to pass the
point of resistance.
)
Select position N
.
Reinitialisation
Following disconnection of the battery, the gearbox must be reinitialised. )
Switch on the ignition.
)
Press the brake pedal.
)
Wait approximately 30 seconds until N
or agear appears in the instrument panel.
)
Release the brake pedal.
The
gearbox is operational again.
Page 89 of 332
87
4
Driving
accompanied by an audible signal.
Nflashes in the instrument panel,accompanied by an audible signaland a message in the instrument panel screen, if the gear lever is not inposition N on starting.
For optimum acceleration, for example when over taking another vehicle, pressthe accelerator pedal firmly past the point of resistance.
Display in the instrument panelMoving off
Automated mode
Gear lever positions
N.
Neutral
R.Reverse1, 2, 3, 4, 5, 6.Gears in manual mode
AUTO. This comes on when the automatedmode is selected. It switches off on changing to manual mode.
)
Place your foot on the brakewhen
this warning lamp is flashing (for example, when star ting the engine).
)
Select position N.
Nappears in the instrument panelscreen.
)
Select automated mode (position A
), Amanual mode (position M ), or reverse(position R).R )
Release the parking brake.
AUTOand 1, 1
or R
appears in the instrument panel screen.
)
After star ting the vehicle, select position Afor enter automated mode.
AUTO
and the gear engaged appear
in the instrument
panel screen.
The
gearbox is then operating in auto-active
mode, without any action on the par t of the driver. It continuously selects the most suitablegear, depending on the:
- style of driving,
- profile of the road.
Foot on brake
flashes on the instrument panel, accompanied by an audible signal and a message in the instrument panel screen, if the brakepedal is not pressed on star ting.
)
Ta k e your foot off the brake pedal, then accelerate.
)
Press the brake pedal down fully.
)
Start the engine.
