2013 Peugeot 208 open bonnet

6
Familiarisation
Access
A.
Unfolding / Folding the key.B. Unlocking the vehicle.
Deactivation of the alarm.
Remote control key
Bonnet
191
1.Opening the fuel filler flap.
2. Removing the fuel filler cap.
3.
Hooking the fuel filler cap.
Ta n k c a p a c i ty: approximately 50 litres.
A.Interior release lever. B.Exterior safety catchC.Bonnet stay.
Other functions...C. Locking the vehicle. Locating the vehicle. Activation of the alarm.
Locking and unlocking of the vehicle is signalled by rapid flashing of the direction indicators for abouttwo seconds.
44


Fuel t ank
188

8
Familiarisation
10. Side adjustable air vents.
11.Front side window demisting/defrosting
vent.
12 .Instrument panel.
13. Windscreen demisting/defrosting vent. 14 .
Sunshine sensor.
15. Glove box / Passenger's airbagdeactivation.
16.Passenger's airbag.
17. Multifunction screen / Audio system.
18. Central adjustable air vents.

Instruments and controls
1.
Cruise control / speed limiter controls. 2.
Steering mounted controls for the touch screen.
3.
Wiper / screenwash / trip computer stalk. 4.
Lighting and direction indicator stalk5.
Bonnet release lever.
6.Steering wheel adjustment control.
7. Driver's airbag.
Horn. 8.Headlamp height adjustment. 9. Switch panel.
19.
Central locking and hazard warning buttons. 20.
Heating / air conditioning controls.
21.12 V accessory socket.
USB por t / auxiliary socket.
Additional USB por t.22. Open storage.
Cup holder. 23. Gear lever. 24.
Central armrest with storage. 25.Parking brake.

51
2
Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring.





Alarm


- Exterior perimeter

The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...




- Interior volumetric

The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or
moves inside the vehicle.
Self-protection function
The system checks for the putting out of service of its components. The alarm is triggered if the battery, thecentral control or the wires of the siren are put out of ser vice or damaged.
For all work on the alarm system, contact a PEUGEOT dealer or aqualified workshop.
Locking the vehicle with full
alarm system
Activation
)Switch off the ignition and get out of the vehicle.
) Press the locking button on the
remote control.
After the locking button on the remote control
is pressed, the exterior perimeter monitoring
is activated after a delay of 5 seconds and the
interior volumetric monitoring after a delay of 45 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
dela
y of 45 seconds at the same time as the
interior volumetric monitoring.
)
Press the unlocking button on
the remote control.

Deactivation

The alarm system is deactivated: the
indicator lamp in the button goes off.
The monitoring system is active: the
indicator lamp in the button
flashes once per second.

174
Practical information




Battery
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery.

After refitting the battery, the Stop & Start system will only be active
after several hours depending on the climatic conditions and the state of charge of the battery (up to about 8 hours).
)Raise the locking tab fully.




Disconnecting the cables

Reconnecting the cables
)Position the open clip 1of the cable on the positive terminal (+) of the battery.
)Press ver tically on the clip 1
to position it correctly against the battery.)Lock the clip by spreading the positioning
lug and then lowering the tab 2.
Do not force the tab as locking will not be possible if the clip is not positionedcorrectly; start the procedure again.
Procedure for char
ging your battery when it is flat or for star ting the engine using another battery.

The battery is located under the bonnet.
To gain access to it:) open the bonnet using the interior releaselever, then the exterior safety catch, )
secure the bonnet stay, )
remove the plastic cover on the (+)
t
erminal.

Access to the battery

188
Checks











Bonnet
)Open the left hand front door.


Before doing anything under the bonnet,switch off the Stop & Start system toavoid any risk of injury resulting from anautomatic change to START mode.


Closing
)Take the stay out of its suppor t slot. )Clip the stay back into its housing. )Lower the bonnet and release it at the end of its travel. )Pull on the bonnet to check that it has
latched correctly.
)Unclip the stay from its housing and place it in the suppor t slot to hold the bonnet open.

Do not open the bonnet under verywindy conditions.When the engine is hot, handle the exterior safety catch and the stay with care (risk of burns).To avoid damaging electrical units,it is strictly forbidden
to use a highpressure jet wash under the bonnet.


Opening
)
Lift the safety catch and raise the bonnet.


)Pull the release lever, located at the bottom
of the door aper ture, towards you.

195
8
Checks
On vehicle fitted with HDi engines, the fuel system must be primed if you run out of fuel;
refer to the engine compar tment view on the
"Diesel engine" section.
If the tank on your vehicle is fitted with
a misfuel prevention device, refer to the corresponding section.












Running out of fuel (Diesel)


If the engine does not star t first time, don't keep trying. Star t the procedure again from the beginning.

)
Fill the fuel tank with at least five litres of
diesel.)
Open the bonnet.)
Press and release the priming pump until resistance is felt (there may be resistance
on the first press).
) Operate the star ter until the engine star ts. )
Close the bonnet.
1.4 litre HDi engine
)
Fill the fuel tank with at least five litres of diesel. )
Open the bonnet. )
If necessary, unclip the styling cover for
access to the priming pump. ) Squeeze and release the priming pump
repeatedl
y until resistance is felt (there may
be resistance at the first press). ) Operate the star ter until the engine star ts (if the engine does not star t at the first
attempt, wait around 15 seconds before
trying again).) If the engine does not star t after a few
attempts, operate the priming pump again
then star t the engine. ) Clip the styling cover back in place.)
Close the bonnet.



1.6 litre HDi engine

320
Visual search
Instruments and controls
Courtesy lamps 123 Interior mood lighting 124 Rear view mirror 109 Emergency orassistance call 126, 213

Manual parking brake 80
5/6 -speed manual gearbox 81 Gear shift indicator 82 5 -speed electronic gearbox 83-85 6 -speed electronic gearbox 86-89
Automatic gearbox 90 -92 Stop & Star t 93 -95 Hill start assist 96


Dashboard fuses 170

USB por t / Auxiliary socket 74 Additional USB por t 74
Heating, ventilation 64- 66 Manual air conditioning 66 - 67 Dual-zone air conditioning 68-70 Front demisting / defrosting 71 Rear screen demist/defrost 71
To u c h s c r e e n 215-274
Door mirrors 108-109 Electric windows, deactivating 53-54
Bluetooth audio system 275-300
Audio system 301-317 Setting the date/time 43
Glove box fuses 171-172
Opening the bonnet 188

322
Visual search
Maintenance - Technical data
Identification markings 212 Dimensions 211

Changing bulbs 161-167 - front - rear


Running out of fuel, Diesel 195
Opening the bonnet 188 Under the bonnet, petrol 189 Under the bonnet, Diesel 190 Petrol engines 201-202 Diesel engines 206-207
12V battery 174-176 Load reduction, economy mode 176 , 17 7 Engine compar tment fuses 168 -169, 173
Petrol weights 203-205 Diesel weights 208-210

Checking levels 196 -198 - oil - brake fluid - coolant - screenwash fluid- additive (Diesel with particle emissions filter)Checking components 199 -200 - battery- air / passenger compar tment filter - oil filter - particle emissions filter (Diesel) - brake pads / discs