2013 NISSAN FRONTIER warning

[x] Cancel search: warning

Page 374 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual 6. Return the wiper to its original position andrelease it until it has made contact with the
windshield.
CAUTION
●After wiper blade replacement, return
the wiper arm to its original position;
other

Page 384 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual If you have a flat tire, see “Flat tire” in the
“In case of emergency” section of this
manual.
TIRE PRESSURE
Tire Pressure Monitoring System
(TPMS)
This vehicle is equipped with the Tire
Press

Page 385 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual Tire inflation pressure
Check the tire pressures (including the
spare) often and always prior to long dis-
tance trips. The recommended tire pres-
sure specifications are shown on the
F.M.V.S.S./C.M.V

Page 390 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual 7The word “radial”
The word “radial” is shown if the tire has
radial structure.
8Manufacturer or brand name
Manufacturer or brand name is shown.
Other Tire-related Terminology
In addition to

Page 392 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual Wheel nut tightening torque:98 ft-lb (133 N·m)
The wheel nuts must be kept tight-
ened to specifications at all times. It
is recommended that wheel nuts be
tightened to specification at each
tire rot

Page 393 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual Replacing wheels and tires
When replacing a tire, use the same size, tread
design, speed rating and load carrying capacity
as originally equipped. Recommended types and
sizes are shown in “Wheels an

Page 394 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual Wheel balance service should be per-
formed with the wheels off the vehicle.
Spin balancing the wheels on the vehicle
could lead to mechanical damage.● For additional information regarding
tires, re

Page 408 of 444

NISSAN FRONTIER 2013 D40 / 2.G Owners Manual INSTALLING FRONT LICENSE
PLATE WITHOUT GROMMETS
Use the following steps to mount the front license
plate without grommets:1. Make a shallow hole in each plastic finisher at the location mark (small di