OuTSIDe MIrrOr CONTrOL SwIT CH
The outside mirror control switch is located on the
left side of the instrument panel.
To select the left or right mirror, move the switch
01 .
Adjust each mirror to the desired position using
the switch
02 .
To prevent accidentally moving the mirror, move this
switch
01 to the center “neutral” position.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
6
first drive features
FOLDING DOWN THE REAR BENcH SEAT
To fold the seats flat, secure the seat belts on
the seat belt hooks on the side wall. Release the
connector tongue of the rear center seat belt from
the buckle, then store the connector and seat belt
tongues on the seat belt hook.
Before folding down the seatback, tuck the seat belt
buckles into the seat cushion poc
kets.
Fold the seatback down by pulling the adjusting strap 01 .
To raise the seatback, lift up each seatback and push it to the upright position until it is latched.
After raising the seatback, pull the seat belt buc
kles out of the seat cushion pockets until they
are fully extended before using the seat belts.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
01
02
01
STarTING/STOPPING THe eNGINe
CONTINuOuSLY VarIaB Le TraN SMISSION
(NISS
aN Intelligent K
ey® models only - if so equipped)
Depress the brake pedal.
Move the shift lever to the P (ParK) position.
Push the ignition switch to start the engine.
NOTE: It is important to make sure the Intelligent
key is
with you (that is, in your poc
ket or purse).
TURNING THE ENGINE OFF
Move the shift lever to the P (ParK) position, apply
the parking brake and push the ignition switch.
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
1221378_13a_Cube_QRG_092112.indd 1010/2/12 9:26 AM
