2013 NISSAN ALTIMA ECO mode

01
TIRE PRESSURE MONITORING SYSTEM (TPMS)
WITH EASY FILL TIRE ALERT
A Tire Pressure Low – Add Air warning message



will appear in the vehicle information display 01 and
the low tire pressure warning light 02 will illuminate
when one or more tires are low




on pressure and air is needed.



•





T

he tire pressures should be checked when the
tires are cold. The tires are considered cold
after the vehicle has been parked for 3 hours
or more or driven less than 1 mile (1.6km) at
moderate speeds.
When adding air to an under-inflated tire, the TPMS



with Easy Fill T
ire Alert provides visual and audible



signals to help you inflate the tires to the




r
ecommended
cO
LD tire pressure.
To use the Easy Fill Tire Alert system:



1.

Move the shift lever to the
P (PARK) position and apply the parking brake.



2.

Place the ignition switc
h in the ON position. Do not start the engine.



3.

Add air to the under-inflated tire and within a few seconds, the hazar\
d warning lights will




st
art flashing.



4.

W
hen the designated tire pressure is reached, the horn will beep once and the hazard



warning flashers will stop.



5. Repeat this procedure for any additional under-inflated tires.
After tire pressures are adjusted, drive the vehicle at speeds above 16 \
M PH (25km/h).

T
he Tire Pressure Low – Add Air warning message and low tire pressure warning


light will dis

appear.
When the low tire pressure warning light flashes for approximately 1 minute and then remains



on, the TP
MS is not functioning properly. Have the system checked by a NISSAN dealer.
Tire pressure rises and falls depending on the heat caused by the vehicle\
’s operation and the



outside temperature. Low outside temperature can lower the temperature o\
f the air inside the




tire, whic
h can cause a lower tire inflation pressure. This may cause the low tire pressure



warning light to illuminate. If the warning light illuminates in low amb\
ient temperature, c
heck



the tire pressure in your tires.



•
c
heck the tire pressure (including the spare tire) often and always prior \
to long distance trips.
The Tire and Loading Information label contains valuable information. Please refer to section



9, “T
echnical and consumer information” in your Owner’s Manual for the location of the Tire



and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
02
6To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
esseN tial iNf or matioN
1482394_13d_AltimaSedan_QRG_030613.indd 63/6/13 1:17 PM

POWER SEAT ADJUSTMENTS (if so equipped)
To slide the seat forward or bac kward, push the



control switc
h
01 forward or backward.

To adjust the angle of the seatback, push the switch

02 forward or backward.
S
EA

T


LIFTER
(if so equipped for driver
’s seat)
To adjust the angle and height of the seat cushion,



push the front or rear end of the switc
h
01 up or down.
LUMBAR SUPPORT (if so equipped for driver’s seat)
To adjust the seat lumbar area, push the front or rear end of the switch
03 .
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)”\
of your
Owner’s Manual.
0102
03
OUTSIDE MIRROR CONTROL SWITCH
To select the right or left side mirror, move the control
switc

h
01 right or left.
To adjust the mirror angle, push the control switch
02



up, down, right or left.
To prevent accidentally moving the mirror,
set the



control switc
h
01 to the middle “neutral” position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
10
02
01
STARTING/STOPPING THE ENGINE
Depress the brake pedal.



•

If the brake pedal is not depressed, pushing the




ignition switc
h once enters the A
c
c mode.



•

If the ignition is pushed a second time, the vehicle




will enter the O
N mode.
Move the shift lever to P (PARK).
Push the ignition switc h to start the engine.
NOTE: It is important to make sure the NISSAN Intelligent
k

ey
® is with you (that is, in your pocket or purse).
TURNING THE ENGINE OFF
Move the shift lever to the P (PARK) position and apply the parking brake.
Press the ignition switch START/STOP button to turn the engine off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
first drive features
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1482394_13d_AltimaSedan_QRG_030613.indd 103/6/13 1:17 PM

03 DEFROSTING/DEFOGGING FRONT AND SIDE WINDOWS
Press the defroster control button to turn the system on. The A/ c automatically turns on
when the defroster mode is selected. This feature removes humidity from the air.
Turn the temperature control dial 01 to set the desired temperature.
To defrost the front and side windows, set the temperature control 01 and fan speed

control 06 to their maximum settings.
04 REAR WINDOW AND OUTSIDE MIRROR (if so equipped) DEFROSTER SWITCH

Press the rear window defroster switch
to turn the system on or off.
This function automatically turns off after approximately 15 minutes.
05 ON•OFF BUTTON

Press the button to turn the system on or off.
06 FAN SPEED CONTROL BUTTONS
Press the left button to decrease fan speed or the right
button to increase fan speed.
07 MODE BUTTON

Press the MODE button
to cycle through the following air flow outlets:



Air flows from the center and side vents.



Air flows from the center, side and foot vents.



Air flows mainly from the foot vents.



Air flows from the defroster and foot vents.
08 A/C BUTTON
Press the A/C button to turn the air conditioner system on or off. This system helps cool



and dehumidify the air inside the cabin and defog the windows.
09 FRESH AIR INTAKE BUTTON
Press the fresh air intake button
to draw outside air into the passenger compartment.

T
he indicator light on the button will illuminate.
10 AIR RECIRCULATION BUTTON
Press the air recirculation button
to recirculate interior air inside the vehicle. The

indicator light on the button will come on. T his system is used to avoid certain outside



odors and helps to adjust the inside vehicle temperature more effectivel\
y
.
The air recirculation mode cannot be activated when the air conditioner i\
s in the front



defrosting mode or the front defrosting and foot vent mode
.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4)” \
of your
Owner’s Manual.
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi13
1482394_13d_AltimaSedan_QRG_030613.indd 133/6/13 1:17 PM

16
VEHICLE INFORMATION DISPLAY
The vehicle information display 01 displays such items as:
Vehicle settings
Trip computer information
Drive system warnings and settings (if so equipped)
Audio information
Navigation turn by turn
cruise control system information
NISSAN Intelligent key® operation information
Indicators and warnings
Tire pressure information
USING THE VEHI c LE INFORMATION DISPLAY
The vehicle information display can be changed using the
button
02 and the ENTER
buttons
03 located on
the steering wheel.
Press 02 to change the display mode Press
03 to navigate through the mode’s menu Press ENTER
03 to change or select an item
Press 04 to go back to the previous menu

STARTUP DISPLAY
When the ignition is in the A
c

c or ON position, the vehicle information display will support four of
the following modes:
Active system status (if so equipped)
Trip computer
Tire pressure information
Fuel economy
Warnings (if there are any)
RESETTING THE TRIP c
O
MPUTER
1.


Press the button
02 until you reach the trip
computer mode 05.
2.


Press the button again for more than 1.5
seconds to reset the trip computer .
SETTINGS
The setting mode allows you to change the information
displayed in the vehicle information display:
Main Menu Selection Vehicle Settings
Body c olor Language
Maintenance Unit
Alarms Welcome Effects
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
01
03
0402
05
system guide
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1482394_13d_AltimaSedan_QRG_030613.indd 163/6/13 1:17 PM

17
BLUETOOTH® HANDS-FREE PHONE SYSTEM
A cellular telephone should not be used while driving
so full attention may be given to vehicle operation*.
SYSTEM OPERATING TIPS
The “Help” command can be used to hear a list of available commands at any time.
Reduce bac kround noise as much as possible by
closing windows and pointing HVA
c
vents away from
the ceiling.
Say commands after the tone, or press the
button to say a command at any time.
Speak naturally without long pauses and without
raising your voice.
When speaking Phonebook names, please be aware some phones require the last name to be spoken
before the first name. For example, “Michael Smith”
may be spoken as “Smith Michael”.
To cancel a voice recognition session, simply wait
5 seconds, say “ c ancel” or “Quit,” or press and hold
the
button for 5 seconds.
To increase or decrease the volume of the voice prompts, push the volume \
control
switches + or - on the steering wheel or turn the control dial on the audio s\
ystem while
the audio system is responding.
If the Voice Recognition system does not recognize your voice commands, train th\
e system using the Voice Adaptation Mode. See your Owner’s Manual for detailed information.
For more detailed information and instructions, refer to your cellular phone Owner’s Manual and visit www.nissanusa.com/bluetooth.
*Some jurisdictions prohibit the use of cellular telephones while drivin\
g..
Bluetooth® Controls
Microphone
**Some jurisdictions prohibit the use of cellular telephones while drivi\
ng.
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1482394_13d_AltimaSedan_QRG_030613.indd 173/6/13 1:17 PM