2013 MITSUBISHI OUTLANDER XL Owners Manual

Page 417 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-10 Driving safety
4
Curb weight: the weight of a motor vehicle with standard
equipment including the maximum capacity of fuel, oil,
and coolant.
Accessory weight: the combined weight (in excess of

Page 418 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual Driving safety
4-11
4
This placard shows the maximum number of occupants permit-
ted to ride in your vehicle as well as “the combined weight of
occupants and cargo” (A), which is called the vehicl

Page 419 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-12 Driving safety
4
Steps for Determining Correct Load Limit
N00630200094
1. Locate the statement “The combined weight of occu-
pants and cargo should never exceed XXX kg or XXX
lbs.” on your ve

Page 420 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual Driving safety
4-13
4
NOTEThe following table shows examples on how to calculate total load, cargo/luggage and towing capacities of your vehicle
with varying seating configurations and number and siz

Page 421 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-14 Driving safety
4Cargo loads
N00629700435
Cargo load precautions
N00630300040
To determine the cargo load capacity for your vehicle, subtract
the weight of all vehicle occupants from the vehicle c

Page 422 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual Driving safety
4-15
4
Loading cargo on the roof
N00630400096
NOTETo prevent wind noise or reduction in gas mileage,
remove the roof carrier when not in use.
Before using an automatic car wash, check

Page 423 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-16 Driving safety
4
Roof carrier mounting brackets
 (if so equipped)
N00630600098
Ty p e  1
When installing the roof carrier, use the brackets (A). The
brackets are located under each roof drip moul

Page 424 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual Driving safety
4-17
4
Attaching the roof carrierSlide each cover (B) toward the front of the vehicle to remove
it.
Refitting the covers1. With each cover, put the tabs (C) on the cover in the holes
(D