2013 MITSUBISHI LANCER SPORTBACK display

[x] Cancel search: display

Page 545 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual 5-132 Comfort controls
5Error codes (SIRIUS Satellite Radio)
 (if so equipped)
N00760300053
If an error code (1) appears in the display, take action in accordance with the table below.
Error display
P

Page 546 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual Comfort controls
5-133
5
NOTEReception may not be possible in a place where the signal is interrupted by a tunnel, by the roof of a garage or other structure,
by woods, or by a tall building. At such

Page 547 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual 5-134 Comfort controls
5Error codes (iPod)
N00766300013
If an error code (1) appears in the display, take action in accordance with the table below.
Error display
Item
Repair
NO SONG There are no play

Page 548 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual Comfort controls
5-135
5
CONNECT RETRY (Blink)If the iPod indicator illuminates, the iPod cannot 
be authenticated.Reconnect the iPod. 
If the iPod indicator goes out, it shows the USB 
communication

Page 549 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual 5-136 Comfort controls
5Error codes (USB memory device)
N00766400014
If an error code (1) appears in the display, take action in accordance with the table below.
Error display
Item
Repair
U NO SONG Th

Page 550 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual Comfort controls
5-137
5
USB BUS PWR (Blink)An overcurrent or other power-supply error 
has occurred.Remove the USB memory device.
Have the vehicle inspected at an authorized Mitsub-
ishi Motors deale

Page 554 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual Comfort controls
5-141
5 Antenna
N00734200468
To removeTurn the pole (A) counterclockwise.To installScrew the pole (A) clockwise into the base (B) until it is
securely retained.NOTEBe sure to remove

Page 555 of 706

MITSUBISHI LANCER SPORTBACK 2013 8.G Owners Manual 5-142 Comfort controls
5
3. When the time is set, press the DISP button to stop the
clock display from flashing. After time signal setting,
however, the clock display automatically stops flashing.NOTE