2013 MITSUBISHI LANCER MMCS Manual

Disk Handling 7-4
Disk Handling
Inserting and Removing Disks
This section explains how to insert music
CDs, MP3/WMA disks (CD-R/RW), and
DVDs (DVD-VIDEO) into the MMCS.
Inserting a disk

1 Press the [OPEN] key
Monitor Panel
eng_mngi474aSlide open the monitor panel to reveal the disk slot.
2 Insert a disk
eng_mngi475a
Disk
Label side
Make sure the disk label is on top when inserting into
the slot. When the disk is taken automatically, release
your hand.
Removing a disk

1 Press the [DISC ] key
NOHJB
%*4$
The disk is ejected automatically to the disk removal
position. Remove the disk.
2 Press the [OPEN] keySlide the monitor panel closed to return the MMCS to
its original state.
CAUTION
When inserting or removing disks, operate it while
parked in a safe location, and do not stop in no-
parking zones.
Do not insert hands, ngers, or other foreign objects
into the slot. This may cause injury, smoke, or re.
opening or closing the monitor panel.

Make sure the monitor panel is closed while driving. place any objects on top of the monitor panel.
is in the disk removal state (i.e., partially ejected)
from the disk slot, but depending on the disk state,
it may not be possible to detect that a disk has
been ejected. If the monitor panel is closed while
an undetected ejected disk is still in the slot, there
is a risk that either the disk or the device will be
damaged. When closing the monitor panel, check
that there is no ejected disk in the disk slot before
closing.
panel is opening or closing. The disk or the MMCS
may be damaged.
\b \b
\f \

 \b \b
\b

\f

Disk Handling 7-5
Audio
Correct Disk Handling
Handling Precautions
fingerprints or other dirt, the disk may become
unreadable. When holding a disk, do not touch the
signal surface. Gently pinch both edges of the disk,
or hold by the center hole and one edge.
the disk.
disk is already inserted. This may scratch or damage
the disks.
Maintenanceuse a soft cloth to wipe gently from inside to outside,
without rotating the disk.
and around the circumference of new disks. Using
a disk with residue may cause malfunction, so use a
ballpoint pen, etc., to clean away the residue.
Storage Precautionscases and store out of direct sunlight.
from the device.
Disk Playback Environmentimmediately after turning on the vehicle heater may
cause malfunction due to condensation (water
droplets) forming on the optical parts of the device,
or on the disk. In such cases, remove the disk and
wait a while before use.
malfunction.
Copyrightperformance, or rental of disks is prohibited by law.
and Macrovision and other copyright holders are
protected by the patent laws of the United States
and other intellectual property rights.
authorization from Macrovision. Further, without
special authorization from Macrovision, use is
restricted to the home and other private appreciation.
\b \b
\f \

   \b
\b

\f

Types of Playable Disks 7-6
Types of Playable Disks
Playable DVDs


Playable CDs



NOTE
assured.
disks that are partially transparent cannot be played.
be played.
Non-Standard CDs
CDs can be enjoyed using this device,
but note carefully the following points
concerning CD standards.

logo on the disk label.

standard cannot be assured. Further, even if the disk
can be played, the sound quality cannot be assured.
the following symptoms may occur.
- White noise may be mixed in during playback. Further, the sounds may also jump.
- The disk is not recognized.
- Track 1 is not played.
- Longer time than usual is taken to nd the start.
- Playback starts from the middle of a track.
- Some parts are unplayable.
- The disk freezes during playback.
- The display is incorrect.
Meaning of the Logos on DVDs
Region Codes Regional playback limitations are expressed as
region codes, and videos can be played only in the
region shown.
labeled with region code “1” or “ALL” can be played
on this device.
package are playable.
1 2
Package LogosThe meanings of the logos displayed on packages are
as follows:
Region code (Describes the region
where playback is possible)
Describes the number of angles that
can be played.
Describes the number of languages
that can be displayed as subtitles.
Describes the number of languages
that can be played.
\b \b
\f \

  \b
\b

\f

Types of Playable Disks 7-7
Audio
MP3/WMA Files
Files in MP3/WMA format written to CD-
ROM and CD-R/RW disks can be played
on this device. The files and media that
can be used are limited, so before writing
les in MP3/WMA format to disk, read the
following carefully. Further, also make sure
to read thoroughly the user manuals to
ensure the correct use of your CD-R/RW
drives and recoding software. Data such
as title information, etc., is stored in the
MP3/WMA le, and can be displayed.
NOTE
from music CDs to others, and uploading to internet
servers, etc., is illegal whether paid or free of charge,
so do not do so.
than MP3/WMA files. Playing disks to which these
files have been written causes misidentification for
playback, so intense white noise occurs that may
damage the speakers.
software used to write to the disk, correct playback
may not be possible. In this case, refer to the user
manuals for the devices and software used.
and settings, it may not be possible to add
extensions. In this case,(if it is an MP3/WMA file)
add the “.mp3/.wma” extension to the end of the le
before writing to disk.
format can be played.
in MP3/WMA format, only the files in MP3/WMA
format are played.
Folder Configurations
Up to eight levels of folder can be identi ed.
Tracks can be managed by creating levels
such as genreartistalbumtrack (MP3/WMA
le).
MP3s
MP3 is an abbreviation of “MPEG-
1AudioLayer3”. MPEG is an abbreviation
of “Motion Pictures Experts Group”, and
is the video compression standard used
for video CDs, etc. MP3 is an audio
compression format included in the MPEG
audio standards, and enables files with
a small amount of data to be created
with high quality audio by processing
inaudible sounds that have been buried
in loud noise, as well as sounds in ranges
inaudible to the human ear. The data
on a music CD can be compressed to
approximately 1/10th of its original size
with almost no loss of sound quality, so
it is possible to write approximately the
contents of 10 music CDs to one CD-R/
RW.
\b \b
\f \

  \b
\b
 \f

Types of Playable Disks 7-8 Playable MP3 File Standards
The speci cations for playable MP3 les are as follows:
ItemDetails
Standards MPEG1 AUDIO LAYER3
MPEG2 AUDIO LAYER3
Sampling
frequency
[Hz] MPEG1 32k/44.1k/48k
MPEG2 16k/22.05k/24k
Bit rate [kbps] MPEG1 32/40/48/56/64/80/96/112 /128/160/192/224/256/32
0
MPEG2 32/40/48/56/64/80/96/112 /128/144/160
VBR
(Variable Bit Rate) Compatible
Multi-session Compatible
Channel mode Stereo, joint stereo, dual
channel, and monaural
Max. number of levels 8 (including the root
directory)
Max. number of folders 255 folders
Max. number of les 400 files (Total number
on disk. Does not include
other than MP3 or WMA
les.)
ID3Tag Ver.1.0 and Ver.1.1
* MP3 les written using standards other than those described above may not be playable correctly, and
the file names and folder names, etc., may not be
displayed correctly.
WMA
WMA is an abbreviation for Windows
Media Audio and is an audio compression
format from Microsoft Corporation. This
format compresses data using a higher
compression ratio than MP3.
* Microsoft and Windows Media are registered trademarks of Microsoft Corporation in America and
other countries.
NOTEso WMA les that are protected by copyright cannot
be played on this audio system.
Playable WMA File StandardsThe specifications for playable WMA files are as
follows:
Item Details
Standards W i ndows Media Audio
Version 7.0
Sampling frequency [Hz] 16k/22.05k/32k/44.1k/48k
Bit rate [kbps] 32/40/48/64/80/96/128/16
0/192
VBR
(Variable Bit Rate) Compatible
Multi-session Compatible
Channel mode Stereo and monaural
Max. number of levels 8 (including the root
directory)
Max. number of folders 255 folders
Max. number of les 400 files
(Total number on
disk. Does not include other
than MP3 or WMA les.)
WMA Tag T i tles, artist names, and
album names
* WMA les written using standards other than those described above may not be playable correctly, and
the file names and folder names, etc., may not be
displayed correctly.
\b \b
\f \

  \b
\b
 \f

Listening to Radio 7-9
Audio
Listening to Radio
1 Press the [MODE] key

2 Touch [FM] or [AM]
eng_a310
eng_a431Radio is received.
NOTE the touch panel.
Selecting Stations
1 Receive radio
2 Touch either [ TUNE] or
[TUNE
] to select the frequency
eng_a431
The frequency is changed by one step.
Touch and hold the touch panel button to select
receivable frequencies automatically.
Scanning Broadcasting Stations
It is possible to search for broadcasting
stations that can be received in the current
location.

1 Receive radio

2 Touch [ ]
eng_a431
3 Touch [Scan]
eng_a432
eng_a433The search for broadcasting stations that can be
received starts automatically.
Broadcasting stations that can be received plays for
10 seconds only, and then the search resumes.
4 Press the [ENT] keyThe scan is cancelled, and reception of the current
broadcasting station is continued.
NOTE station can continue to be received.
\b \b
\f \

  \b
\b
 \f

Listening to Radio 7-10
Storing Broadcast Stations
Manual StorageUp to six broadcasting stations that are regularly
listened to can be saved in FM1, another six in FM2,
and another six in AM.
1 Dial the broadcasting station to
be stored.
>>> “Selecting Stations” (page 7-9)
2 Touch and hold the desired
preset number (i.e., the number under
which the broadcast station is to be
stored)
eng_a436Preset number

eng_a431The broadcast station currently being received is
stored using the preset number selected.
Auto StorageUp to 12 FM stations and 6 AM stations can be stored
automatically (auto select mode) if traveling to regions
with different reception frequencies, while on a journey,
etc. If auto select mode is canceled, reception is
returned to the broadcast stations originally stored.
1 Receive radio (page 7-9)
2 Touch [ ]
eng_a431
3 Touch [Auto Select]
eng_a432
eng_a435The search for broadcasting stations that can be
received starts automatically.
When the search has been completed, a list of
broadcast stations is displayed.
NOTE than the number that can be stored, storage is not
performed.

\b \b
\f \

 
 \b
\b
 \f

Listening to Radio 7-11
Audio
Recalling Stored Stations
Broadcast stations that were previously
stored can be recalled.

1 Receive radio (page 7-9)
2 Touch the preset number for the
desired station
eng_a431Preset number

eng_a434Reception of the stored broadcast station begins.
\b \b
\f \

 

 \b
\b
 \f