2013 MITSUBISHI LANCER EVOLUTION trunk

[x] Cancel search: trunk

Page 507 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual 6-10 For emergencies
6
NOTEThe chocks shown in the illustration do not come with
your vehicle. It is recommended that you purchase chocks
or blocks and keep them in the vehicle for use if needed. 
I

Page 508 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual For emergencies
6-11
6
To remove the compact spare tire
N00849700244
1. Lift up the luggage floor board.
2. To remove the spare tire, remove the installation clamp
(A) by turning it counterclockwise.N

Page 534 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual Vehicle care and maintenance
7-15
7 Rear axle oil
N00915200243
Whenever the oil level is checked, add oil as necessary to
maintain the proper level.
Fill or change oil according to the table.Oil type

Page 535 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual 7-16 Vehicle care and maintenance
7Wa s h e r  f l u i d
N00938600257
The windshield washer fluid reservoir is in the trunk.
Check the washer fluid level at regular intervals and add
washer fluid to r

Page 537 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual 7-18 Vehicle care and maintenance
7Battery
N00939100725
The vehicle battery is installed in the trunk behind a panel.
The condition of the battery is very important for quick starting
and to keep the

Page 538 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual Vehicle care and maintenance
7-19
7 Tires
N00939200508
It is important to familiarize yourself with the following terms:
Cold tire pressure:
• The measured pressure after the vehicle has been parke

Page 567 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual 7-48 Vehicle care and maintenance
7
NOTEThe high-mounted stop light uses LEDs rather than bulbs.
For repair and replacement, contact an authorized
Mitsubishi Motors dealer or a repair facility of you

Page 583 of 626

MITSUBISHI LANCER EVOLUTION 2013 10.G Owners Manual 7-64 Vehicle care and maintenance
7
5. To install the bulb, perform the removal steps in reverse.NOTEWhen mounting the light unit, align the pins (E) on the
light unit with the holes in the body.
Tai
Page:   < prev 1-10 ... 9-16 17-24 25-32 33-40 41-48 next >