2013 Lancia Voyager fold seats

Vehicle ISOFIX Positions Chart
Mass
Group Size
Class Fixture Front
Passen-
ger Rear
Outboard Rear
Center Interme-
diate
Outboard
SSnG Interme-
diate
Center
LUX.
Quad Other
Sites
II – 15 to
25 kg (1) X
XXX XX
III – 22 to
36 kg (1) X
XXX XX
Key of letters used in the table above:
 (1) For the CRS which do not carry the ISO/XX size class identification (A to G), for the applicable mass group, the car manufacturer shall indicate the vehicle specific ISOFIX child restraint system(s) recommended for each position.
 IUF = Suitable for ISOFIX forward child restraint systems of “universal” category approved for use in the mass group.
 IL = Suitable for particular ISOFIX child restraint systems (CRS) given in the attachment list. These ISOFIX CRS are those of the “specific vehicle”, “restricted” or “semi-universal” categories.
 X = ISOFIX position not suitable for ISOFIX child restraint systems in this mass group and/or this size class.
 * = Both LH & RH 2nd row seats must be in used position. (Seats can not be folded into floor)
 ** = Inboard buckle for Left side seating position must be behind all ISOFIX Child Restraints.
57

turn the buckle around, and insert
the latch plate into the buckle
again. If you still can't make the
child restraint secure, try a differ-
ent seating position.
 Buckle the child into the seat ac- cording to the child restraint manu-
facturer's directions.WARNING!
When your child restraint is not in
use, secure it in the vehicle with the
seat belt or remove it from the ve-
hicle. Do not leave it loose in the
vehicle. In a sudden stop or colli-
sion, it could strike the occupants
or seatbacks and cause serious per-
sonal injury.
ISOFIX — Child Seat Anchorage
System
Each vehicle, except com-
mercial cargo vehicles, is
equipped with the child re-
straint anchorage system
called ISOFIX. Two ISOFIX child re-
straint anchorage systems are in-
stalled on all second-row seats and in the center position on all third row
fold-in-floor seats. Second-row seats
also feature tether strap anchorages,
located in the rear surface of the seat-
back. In addition, all third row fold-
in-floor seats are equipped with a
child restraint tether anchor at the
center seating position.
NOTE:
 When using the ISOFIX attach-
ing system to install a child re-
straint, please ensure that all
seat belts not being used for oc-
cupant restraints are stowed and
out of reach of children. It is
recommended that before in-
stalling the child restraint,
buckle the seat belt so the seat
belt is tucked behind the child
restraint and out of reach. If the
buckled seat belt interferes with
the child restraint installation,
instead of tucking the seat belt
behind the child restraint, route
the seat belt through the child
restraint belt path and then
buckle it. This should stow the
seat belt out of the reach of an inquisitive child. Remind all
children in the vehicle that the
seat belts are not toys and
should not be played with, and
never leave your child unat-
tended in the vehicle.
 If your child restraint seat is not ISOFIX-compatible, install the
restraint using the vehicle seat
belts.
Installing the Lower Attachments:
1. The vehicle lower anchorages are
round bars located at the rear of the
seat cushion where it meets the seat-
back.
2. Loosen the adjusters on the lower
child restraint attachment straps (ref-
erence the child restraint seat instruc-
tions) to ease the installation.
NOTE: It is recommended to
loosen the top tether strap and
route it loosely prior to securing
the lower anchors so the top tether
strap is not trapped between the
vehicle seat and child restraint.60

 MANUAL RECLINING SEATS . . . . . . . . . . . . .109
 HEAD RESTRAINTS . . . . . . . . . . . . . . . . . . . .110
 STOW 'N GO® SEATING . . . . . . . . . . . . . . . . .112
 QUAD SEATS(for versions/markets, where provided) . . . . . .114
 THIRD ROW POWER RECLINE (for versions/markets, where provided) . . . . . .117
 THIRD ROW POWER FOLDING SEAT (for versions/markets, where provided) . . . . . .117
 MANUALLY FOLDING THIRD ROW SEATS (for versions/markets, where provided) . . . . . .118
 PLASTIC GROCERY BAG RETAINER HOOKS. . . . . . . . . . . . . . . . . . . . . .119
 DRIVER MEMORY SEAT (for versions/markets, where provided) . . . . . . . .120
 SETTING MEMORY POSITIONS AND LINKING RKE TRANSMITTER TO MEMORY . . . . . . . . .120
 EASY ENTRY/EXIT SEAT (Available With Memory Seat Only) . . . . . . . . .121
 TO OPEN AND CLOSE THE HOOD . . . . . . . . . . .122
 LIGHTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .123
 INTERIOR LIGHTING . . . . . . . . . . . . . . . . . . .123
 PARKING LIGHTS . . . . . . . . . . . . . . . . . . . . . .124
 HEADLIGHTS . . . . . . . . . . . . . . . . . . . . . . . . .124
 AUTOMATIC HEADLIGHTS(for versions/markets, where provided) . . . . . .124
 HEADLIGHTS ON WITH WIPERS (for versions/markets, where provided) . . . . . .124
71

Head Restraints — Second Row
Quad Seats
To raise the head restraint, pull up-
ward on the head restraint. To lower
the head restraint, press the push but-
ton, located at the base of the head
restraint, and push downward on the
head restraint.
Head Restraints — Second Row
Bench
To raise the head restraint, pull up-
ward on the head restraint. To lower
the head restraint, press the push but-
ton, located at the base of the head
restraint, and push downward on the
head restraint.Head Restraints — Third Row
The head restraint in the center posi-
tion can be raised and lowered for
tether routing. Refer to “Occupant
Restraints” in “Things To Know Be-
fore Starting Your Vehicle” for further
information.
STOW 'N GO® SEATING
On vehicles equipped with Stow 'n
Go® seating, the second and third
row seats can be folded into the floor
for convenient storage.
Second Row Stow 'n Go®
On vehicles equipped with Stow 'n
Go® seats, the seats will fold and
tumble in one motion.
1. Move the front seat fully forward.
2. Recline the front seatback fully
forward.
3. Raise the armrests on the second
row seat.
NOTE: Seat will not stow in the
storage bin unless the armrests are
raised.4. Slide the storage bin locking
mechanism to the “LOCK” position
and then pull up on the storage bin
latch to open the cover.
5. Pull upward on the seatback re-
cliner lever located on the outboard
side of the seat.
Push Button
Storage Bin Cover Lock ReleaseSeatback Recliner Lever, Seat
Tumble, And Head Restraint Fold Lever
112

The non-adjustable head restraint
and seatback will fold automatically
during the seat tumble. No additional
actuation is necessary.
The seat will automatically tumble
into position for easy storage.6. Push the seat into the storage bin.
7. Close the storage bin cover.
CAUTION!
The storage bin cover must be
locked and flat to avoid damage
from contact with the front seat
tracks, which have minimal clear-
ance to the cover.
WARNING!
In a collision, serious injury could
result if the seat storage bin covers
are not properly latched.
 Do not drive the vehicle with the
storage bin covers open.
 Keep the storage bin covers closed and latched while the ve-
hicle is in motion.
 Do not use a storage bin latch as a tie down.
To Unstow Second Row Seats
1. Pull up on the storage bin latch to
open the cover.
2. Pull up on the strap to lift the seat
out of the storage bin and push the
seat rearward to latch the seat an-
chors.
3. Lift the seatback to the full up-
right position.
4. Return the head restraint to its
upright position, close the storage bin
cover and slide the storage bin locking
mechanism to the “Unlocked” posi-
tion.
Non-Adjustable Head RestraintAutomatic Folding Seatback
Tumbled Second Row Seat
Seat In Storage Bin
113

Stow 'n Go® Seat — Folded And
Latched Position
To tumble or stow the seat from the
folded and latched position: return
the seatback and head restraint to the
upright position. Then pull up on the
seatback recliner lever on the out-
board side of the seat to fold head rest
and seatback and tumble seat for-
ward.
1. Return the seatback to the upright
position.
2. Return the head restraint to the
upright position.3. Pull up on the seatback recliner
lever on the outboard side of the seat
to fold head rest and seatback and
tumble seat forward.
Easy Entry Second Row
The second row Stow 'n Go® seats
allow easy entry to the third row seat
or rear cargo area.
Pull up on the seatback recliner lever
on the outboard side of the seat.
The seat will automatically fold into
position for easy entry into the third
row.
WARNING!
In the event of a collision you could
be injured if the seat is not fully
latched.
QUAD SEATS (for
versions/markets, where
provided)
Both Quad seats are adjustable for-
ward or rearward. The manual seat
adjustment handle is located under
the seat cushion at the front edge of
each seat.
Raising The Seatback
Raising The Head Restraint
Seatback Recliner Lever, Seat
Tumble, And Head Restraint Fold Lever
114

While sitting in the seat, pull up on
the handle and slide the seat forward
or rearward. Release the bar once you
have reached the desired position.
Then, using body pressure, move for-
ward and rearward on the seat to be
sure that the seat adjusters have
latched.WARNING!
 Adjusting a seat while drivingmay be dangerous. Moving a seat
while driving could result in loss
of control which could cause a
collision and serious injury or
death.
(Continued)
WARNING!(Continued)
 Seats should be adjusted before fastening the seat belts and while
the vehicle is parked. Serious in-
jury or death could result from a
poorly adjusted seat belt.
Manual Recline
To recline, lean forward slightly, lift
the lever, then push back to the de-
sired position and release the lever.
Lean forward and lift the lever to
return the seatback to its normal po-
sition. Using body pressure, lean for-
ward and rearward on the seat to be
sure the seatback has latched.
WARNING!
Do not ride with the seatback re-
clined so that the shoulder belt is no
longer resting against your chest. In
a collision you could slide under the
seat belt, which could result in seri-
ous injury or death.
Fold-Flat
To fold the seat, lift the recliner lever
to the full upward position and push
the seatback forward until it rests on
the seat cushion.
Easy Entry
The Quad seats can be tilted forward
for easy entry into the third row. With
the Quad seat in the fold-flat position,
Manual Seat Adjuster
Recline Lever
Fold-Flat Quad Seat
115

lift up on the easy entry lever located
near the bottom of the seat and lift the
seat forward.
For passengers seated in the third row,
there is a pull strap located on the
outboard side of the seat near the
bottom of the seat back. Third row
passengers can pull on the strap and
push the Quad seat forward for fold-
ing the seatback and accessing the
easy entry lever.To provide additional space behind
the second row seats, the seats can be
folded forward.
With the seat in its fold-flat position,
pull upward on the easy-access re-
lease lever and lift the seat into the
desired position.
Pull out the retainer strap from the
sewn-in pocket located on the base of
the seat cushion.
Place the strap around the grab
handle located on the B-Pillar. Before
securing the strap, adjust the buckle
for proper fit.
Secure the retainer strap to the inside
grab handle located on the B-Pillar.
When not in use, store the strap in the
sewn-in pocket located on the base of
the seat cushion.
Easy Entry Lever
Pull Strap for Third Row Passengers
Fold-Flat Release Lever
Retainer Strap
B-Pillar Grab Handle
Retainer Strap
116