2013 Lancia Flavia center console

POWER CONVERTIBLE
TOP CONTROLS
The power top switch is located on the
front of the center console.
There is also a power top button on
the Remote Keyless Entry (RKE)
transmitter for remotely lowering the
power convertible top.
LOWERING THE POWER
CONVERTIBLE TOP
Using The Power Top Switch
NOTE: The power top switch will
operate when the ignition switch is
turned to the ON or ACC position
and when in the power accessory
delay.
There are two Top Down
switch positions. Press and
hold the switch to the first
detent, which is indicated by
the EVIC displaying “CONVERT-
IBLE TOP IN OPERATION” message.
The system will lower all fully raised
windows approximately 10 mm, lower
the top to its fully retracted position,
and then raise the windows. Press and
hold the switch to the second detent.
The system will lower all four windows
and the top to their fully retracted
positions.
The driver has to press and hold the
convertible top switch during the en-
tire opening cycle, if there is an ob-
struction and the driver is alerted, the
convertible top operation can be
stopped by releasing the switch.
Using The Remote Keyless Entry
Transmitter
NOTE: Steps 1 – 3 must be per-
formed within five seconds.
1. Press and release the UNLOCK
button on the RKE transmitter. 2. Press and hold the
POWER TOP button until
the Power Top and All Win-
dows Down feature is com-
plete.
3.
Press and release the POWER TOP
button on the RKE transmitter.
NOTE:
If the RKE transmitter
button is released before the power
top is completely down steps 1–3
must be performed again.
RAISING THE POWER
CONVERTIBLE TOP
Using The Power Top Switch
NOTE: The power top switch will
operate when the ignition switch is
turned to the ON or ACC position
and when in the power accessory
delay.
Power Top Button
59

A courtesy light is also found in the
rear of the center console. You can
turn this light on and off from the
dimmer control in the multifunction
lever. This light is also controlled au-
tomatically by the Illuminated Entry
System.
Headlight Leveling System
This system allows the driver to main-
tain proper headlight beam position
with the road surface regardless of
vehicle load.
The headlight leveling switch is lo-
cated on the instrument panel below
the radio.To operate: push the head-
light leveling switch until
the appropriate number,
which corresponds to the
load listed on the following chart, il-
luminates on the switch.
0
Driver only, or driver
and front passenger.
1 All seating positions
occupied.
2 All seating positions
occupied, plus an
evenly distributed
load in the luggage
compartment. The
total weight of pas-
sengers and load
does not exceed the
maximum load ca-
pacity of the vehicle.
3 Driver, plus an
evenly distributed
load in the luggage
compartment. The
total weight of the
driver and load does
not exceed the maxi-
mum load capacity
of the vehicle.
Calculations based on a passenger
weight of 75 kg. BATTERY SAVER FEATURE
To protect the battery, the interior
lights will turn off automatically
10 minutes after the ignition switch is
moved to the LOCK position. This
will occur if the interior lights were
switched on manually or are on be-
cause a door is open.
WINDSHIELD WIPERS
AND WASHERS
The wipers and washers are
operated by a switch on the
control lever. The lever is lo-
cated on the right side of the steering
column.
Windshield Wiper/Washer Lever
97

ELECTRICAL POWER
OUTLETS
There are two 12 Volt (13 Amp) elec-
trical power outlets on this vehicle.
Both of the power outlets are pro-
tected by a fuse.
The instrument panel power outlet,
located below the climate control
knobs, has power available only when
the ignition is ON. This power outlet
will also operate a conventional cigar
lighter unit.
NOTE: To preserve the heating el-
ement, do not hold the lighter in
the heating position.A second power outlet is located in-
side the center console.
The center console power outlet is
powered directly from the battery
(power available at all times). Items
plugged into this power outlet may
discharge the battery and/or prevent
the engine from starting.
CAUTION!
Do not exceed the maximum
power of 160 Watts (13 Amps) at
12 Volts. If the 160 Watt (13 Amp)
power rating is exceeded the fuse
protecting the system will need to
be replaced.
(Continued)
CAUTION!
(Continued)
Power outlets are designed for ac-
cessory plugs only. Do not insert
any other object in the power out-
lets as this will damage the outlet
and blow the fuse. Improper use of
the power outlet can cause damage
not covered by your New Vehicle
Limited Warranty.
Instrument Panel Power Outlet
Center Console
Power Outlet Fuse Locations
1 — #16 Fuse 15 A Blue Cigar
Lighter Instrument Panel
2 — #11 Fuse 15 A Blue Power Out-
let Inside Arm Rest
102

WARNING!
To avoid serious injury or death:
 Only devices designed for use inthis type of outlet should be in-
serted into any 12 Volt outlet.
 Do not touch with wet hands.
 Close the lid when not in use and while driving the vehicle.
If this outlet is mishandled, it may
cause an electric shock and failure.CAUTION!
 Many accessories that can be
plugged in draw power from the
vehicle's battery, even when not
in use (i.e., cellular phones, etc.).
Eventually, if plugged in long
enough, the vehicle's battery will
discharge sufficiently to degrade
battery life and/or prevent the
engine from starting.
 Accessories that draw higher power (i.e., coolers, vacuum
cleaners, lights, etc.) will degrade
the battery even more quickly.
Only use these intermittently and
with greater caution.
(Continued)
CAUTION!(Continued)
 After the use of high power draw accessories, or long periods of the
vehicle not being started (with
accessories still plugged in), the
vehicle must be driven a suffi-
cient length of time to allow the
generator to recharge the vehi-
cle's battery.CIGAR LIGHTER AND
ASH RECEIVER
(for versions/markets,
where provided)An optional ash receiver is available
from your authorized dealer and will
fit in the center console front cup-
holder.
The optional ash receiver also comes
with a cigar lighter that can be used
with the power outlets. Refer to “Elec-
trical Power Outlets” in “Understand-
ing The Features Of Your Vehicle” for
further information. CUPHOLDERS
FRONT SEAT CUPHOLDER
The cupholder in the center console
will accommodate either two large
size cups or two 0.5 L bottles or cans.
The one-piece insert can be removed
easily for cleaning. An optional re-
movable ashtray may be located in
one of the cupholders.
Front Cupholders
103

REAR SEAT CUPHOLDERS
Cupholders for the rear seat occu-
pants are located in the armrests.
Each cupholder is capable of holding
up to a 0.5 L bottle or can.WARNING!
If containers of hot liquid are place
in the cupholder, they can spill
when the door is closed, burning
the occupants. Be careful when
closing the doors to avoid injury.STORAGE
GLOVE BOX STORAGE
COMPARTMENT
The glove box storage compartment is
located on the right side of the instru-
ment panel. To open the glove box,
pull outward on the latch handle lo-
cated on the front of the glove box.
CONSOLE FEATURES
Storage
The center console is located between
the front driver and passenger seats.
The center console armrest slides for-
ward from design position to provide
added user comfort. The center con-
sole can be used for storage and is also
equipped with an electrical power outlet. Refer to “Electrical Power
Outlets” in “Understanding The Fea-
ture of Your Vehicle” for further infor-
mation.
Two separate storage compartments are
also located underneath the armrest.To open the upper storage compart-
ment, pull upward on the smaller
latch located on the front of the lid.
Rear Seat Cupholder
Glove Box Storage Compartment
Center Console
Center Console Storage
104

PARKING BRAKE
Before leaving the vehicle, make sure
that the parking brake is fully ap-
plied. Also, be certain to leave the
transmission in PARK.
The parking brake lever is located in
the center console. To apply the park-
ing brake, pull the lever up as firmly
as possible. To release the parking
brake, pull the lever up slightly, press
the center button, then lower the lever
completely.
When the parking brake is applied
with the ignition switch ON, the
“Brake Warning Light” in the instru-
ment cluster will illuminate.NOTE:
 When the parking brake is ap-
plied and the transmission is
placed in gear, the “Brake Warn-
ing Light” will flash. If vehicle
speed is detected, a chime will
sound to alert the driver. Fully
release the parking brake before
attempting to move the vehicle.
 This light only shows that the parking brake is applied. It does
not show the degree of brake
application.
When parking on a hill, it is important
to turn the front wheels toward the
curb on a downhill grade and away
from the curb on an uphill grade.
Apply the parking brake before plac-
ing the shift lever in PARK, otherwise
the load on the transmission locking
mechanism may make it difficult to
move the shift lever out of PARK. The
parking brake should always be ap-
plied whenever the driver is not in the
vehicle.
WARNING!
 Never use the PARK position as a substitute for the parking brake.
Always apply the parking brake
fully when parked to guard
against vehicle movement and
possible injury or damage.
 When leaving the vehicle, always remove the key fob from the igni-
tion and lock your vehicle.
 Never leave children alone in a vehicle, or with access to an un-
locked vehicle. Allowing children
to be in a vehicle unattended is
dangerous for a number of rea-
sons. A child or others could be
seriously or fatally injured. Chil-
dren should be warned not to
touch the parking brake, brake
pedal or the shift lever.
 Do not leave the key fob in or near the vehicle. A child could operate
power windows, other controls, or
move the vehicle.
 Be sure the parking brake is fully disengaged before driving; failure
to do so can lead to brake failure
and a collision.
(Continued)
Parking Brake
150

7
MAINTAINING YOUR VEHICLE
 ENGINE COMPARTMENT — 2.4L . . . . . . . . . . . .189
 ONBOARD DIAGNOSTIC SYSTEM — OBD II . . .190
 REPLACEMENT PARTS . . . . . . . . . . . . . . . . . . .190
 MAINTENANCE PROCEDURES . . . . . . . . . . . . . .190  ENGINE OIL . . . . . . . . . . . . . . . . . . . . . . . . . .191
 ENGINE OIL FILTER . . . . . . . . . . . . . . . . . . . .192
 ENGINE AIR CLEANER FILTER . . . . . . . . . . .192
 MAINTENANCE-FREE BATTERY . . . . . . . . . .193
 AIR CONDITIONER MAINTENANCE . . . . . . . .194
 A/C AIR FILTER . . . . . . . . . . . . . . . . . . . . . . .194
 BODY LUBRICATION . . . . . . . . . . . . . . . . . . .195
 WINDSHIELD WIPER BLADES . . . . . . . . . . .196
 ADDING WASHER FLUID . . . . . . . . . . . . . . . .196
 EXHAUST SYSTEM . . . . . . . . . . . . . . . . . . . . .196
 COOLING SYSTEM . . . . . . . . . . . . . . . . . . . . .198
 BRAKE SYSTEM . . . . . . . . . . . . . . . . . . . . . . .201
 AUTOMATIC TRANSMISSION . . . . . . . . . . . . .202
 APPEARANCE CARE AND PROTECTIONFROM CORROSION . . . . . . . . . . . . . . . . . . . . .204
 CLEANING CENTER CONSOLE CUPHOLDERS . . . . . . . . . . . . . . . . . . . . . . . .206
187

When cleaning the inside rearview
mirror, spray cleaner on the towel or
rag that you are using. Do not spray
cleaner directly on the mirror.
Cleaning Plastic Instrument
Cluster Lenses
The lenses in front of the instruments
in this vehicle are molded in clear
plastic. When cleaning the lenses,
care must be taken to avoid scratch-
ing the plastic.
1.
Clean with a wet soft rag or micro-
fiber towel. A mild soap solution may be
used, but do not use high alcohol con-
tent or abrasive cleaners. If soap is used,
wipe clean with a clean damp rag.
2. Dry with a soft cloth.
Seat Belt MaintenanceDo not bleach, dye, or clean the belts
with chemical solvents or abrasive
cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use MOPAR®
Total Clean or equivalent, a mild soap
solution, or lukewarm water. Do not
remove the belts from the vehicle to
wash them. Dry with a soft cloth.
Replace the belts if they appear frayed
or worn or if the buckles do not work
properly.
CLEANING CENTER
CONSOLE CUPHOLDERS
Removal
Grab the rubber portion of the cup-
holder and lift upward.
Cleaning
Soak the rubber cupholder liner in a
mixture of medium hot tap water and
one teaspoon of mild liquid dish soap.
Let soak for approximately one hour.
After one hour pull the liner from the
water and dip it back into the water
about six times. This will loosen any
remaining debris. Rinse the liner thor-
oughly under warm running water.
Shake the excess water from the liner
and dry the outer surfaces with a
clean soft cloth.
Installation
Align the liner in the cupholder and
press down firmly. CONVERTIBLE TOP CARE
CAUTION!Failure to follow these cautions may
cause interior water damage, stains
or mildew on the top material: Avoid high-pressure car washes,
as they can damage the top mate-
rial. Also, increased water pres-
sure may force past the weather
strips.
 Remove any standing water from the top and dry the surface before
opening it. Operating the top,
opening a door or lowering a win-
dow while the top is wet may al-
low water to drip into the vehicles
interior.
Use care when washing the vehicle,
water pressure directed at the
weather strip seals may cause wa-
ter to leak into the vehicles interior.
206